Northfield Telecommunications d b a Advanced Wireless Communications AWR391V4 Two-way Radio User Manual AW391 20080812

Northfield Telecommunications, Inc. d/b/a Advanced Wireless Communications Two-way Radio AW391 20080812

User Manual

AWR391V4S1391457026-Ganged ChargerModel Number: 420855208640Part number
—Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. Any changes or modifications not expressly approved by the party responsible for compliancecould void the user's authority to operate the equipment. ISEDC RSS warning This device complies with ISEDC licence-exempt RSS standard (s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'ISEDC applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. SAR tests are conducted using standard operating positions accepted by the FCC/ISEDC warning device transmitting at its highest certified power level in all tested frequency bands, SAR is determined at the highest certified power level, the actual SAR level of the operating can be well below the maximum value. Before a new model is a the public, it must be tested and certified to the FCC/ISEDC that it does not exceed established by the FCC/ISEDC, tests for each product are performed in positions and required by the FCC/ISEDC.The device is authorized to operate at available for sale tothe exposurealthough the device while locations as limita duty factor not to exceed 50%.
For body worn operation, this device has been tested and meets the FCC/ISEDC RF exposure whenused with an accessory designated for this product or when used with an accessory that Contains no metal. To maintaion compliance with the FCC/ISEDC RF exposure guideline,hold the transimitter and antenna at least 2.5 centimeters from your face and speak in a normal voice,with the antenna pointed up and away from the face. le dispositif est autorisée à fonctionner à un facteur de service ne doit pas dépasser 50%. les essais sont effectués à l'aide des positions standard acceptée par la FCC / ISEDC avertisseur transmettant à son plus haut niveau de puissance certifiée conforme à toutes les bandes de fréquences de r - s test, bien que la puissance est déterminée au niveau le plus élevé de recherche et de sauvetage certifié, le niveau de l'appareil en projetg peut être bien en dessous de la valeur maximale.avant qu'un nouveau modèle est disponible pour la vente au public, il doit être testé et certifié à la FCC / ISEDC qu'il ne dépasse pas les limites d'exposition établies par la FCC / ISEDC, tests pour chaque produit sont effectuées dans des postes et des endroits comme requis par la FCC / ISEDC. opération portés sur le corps, ce dispositif a été testé et répond à la FCC / ISEDC l'exposition aux champs rf lorsqu'il est utilisé avec un accessoire désigné pour ce produit ou utilisé avec un accessoire qui ne contient pas de métal. pour maintaion conformité avec la FCC / ISEDC exposition rf transimitter et orientation, l'antenne d'au moins 2,5 cm de ton visage et parlez normalement, avec l'antenne pointée et loin de la tête.
1TRANSCEIVER RADIO VIEW10678101192345Front View:0. AntennaReceives and transmits signals1. LED indicatorLights up red when transmitting a signal2. Channel UpPress and hold for more than 2.0 seconds to activate the auto scan or dual watch(selected by PC program) for available channel. While radio is on, press buttonto increase channel no.Generates audible sound4. Speaker3. Channel DownPress and hold for more than 2.0 seconds to activate the key lock.While radiois on, press button to decrease channel no.5. Connection pinsSlot pins into a desktop charger docking pins station (docking station not included)6. MicrophonePicks up voice sounds
7. Headset jackAllows use of headset for hands-free communication.8. Push to talkPress and hold button, speak into the microphone using your normalspeaking voice.PTTPress and hold more than 1.5 seconds to rapidly increase the volume. While radiois on, press button to increase the volume by a single unit.10. Volume DownPress and hold for more than 1.5 seconds to rapidly decrease the volume. While radiois on, press button to decrease the volume by a single unit.11. PowerPress and hold for more than 1.5 seconds to turn the unit on or off.Back View:1. Battery doorRemove to access battery compartment2. Battery compartmentUses lithium 3.7V-800mAhrechargeable battery3. buttonMonActivate MONITOR function9. Volume Up2
3LCD DISPLAY SYMBOLSSYMBOL FUNCTION(big)Channel number: Select between 16 channels Battery indicator: Provides battery status during operationDual Watch: Scan 2 channelsHigh Power˖the current channel is high power Keypad lock: Locks keypad to prevent accidental button activationAuto-scan: Unit is scanning Channels or CTCSSPTT tone: the Call tone is activatedVOX: Voice activation system(small)Auxiliary function
This is no use for AWR391V4.AWR391V4AWR391V44
To insert the battery:1. Slide the battery door open.2. Insert the lithium battery into the battery compartment, making sure the polarities(+ and –) match.3. Slide the back cover and clip into place.WARNING:There is a danger in which incorrectly placing the battery can cause anexplosion. Always make sure the radio is switched off before installing or changingthe battery. Replace only with the same or equipment type. Use ONLY with lithium 3.7V800mAH rechargeable battery. Contact Advanced Wireless Communications at1-800-475-5852 or www.adavncedwireless.com for more information.5GETTING STARTEDINSTALLING / REMOVING / CHARGING THE BATTERYTo charge the battery using 6 gang charger:IMPORTANT:Charge the battery for 12 hours on the first charge. After that, it shouldtake 4 or less hours to charge.Make sure the adapter is not obstructed and is easily accessible to the unit.1) Connect 6 gang charger to AC power using DC adaptor provided.2) Slide switch to select CHG.CHG-CLON3) Insert radio unit into 1 docking cradle (insert additional radio units into dockingcradles, 2 through 6). Please ensure radio screen faces forward (same directionas LED lights on gang charger).stBattery Status Extra Batteries LED Radio screenBattery chargingBattery chargedRedGreenLCD backlight onLCD backlight off
Press and hold until you hear a beep and the LCD display appears or disappears.TURNTHEUNITON/OFFTo turn the unit ON or OFF:To change the volume level:Use or to increase or decrease volume.VOLUMENOTE:To completely disconnect from power, the adapter should be disconnected from the6-Ganged Charger.Batteries should not be exposed to excessive heat such as sunshine or fire.To maintain the battery life of your two-way transceiver it is recommended that you onlycharge the battery when needed. Overcharging the battery will reduce performance.The 6-Ganged Charger and adapter should not be exposed to wet conditions. Nowith liquid, such as vases, should be placed on the main unit and adapter.objects filledFor best results ensure that the unit is turned off before charging.Remove batteries before storing your radio for extended periods. Batteries corrodeover time and may cause permanent damage to your radio.For best transmission speak about 2 away from the radio and leave a short pausebefore speaking once you have pressedTo talk to another transceiver:The transceiver will automatically play received transmissions.NOTE:You can only communicate with another transceiver that is on the same channeland using the same CTCSS/DCS code as your transceiver.1. Press and hold “ ” to check if the channel is free.MonTALK TO ANOTHER TRANSCEIVER2. Press and hold and speak into the microphone to transmit.3. Release once you have finished speaking to allow other radios to respond.6
7
SCAN / DW FOR A CHANNEL / CTCSS / DCSNOTE:will be disabled when Scan function is activated.orNOTE:If you activate a scan while your code is set to off, the radio will check for anyactivity on each channel, regardless of the code used on that channel. If you activate ascan while the CTCSS or DCS code is set, the radio will only check for activity on thespecified channel and code combinations set on your radio.To auto-scan / DW for a channel / CTCSS / DCS:3. Press and release to enter scan mode.4. Press to enter the Tx mode on the last valid channel in memory andcontinue to scan after the button is released.5. Long press to terminate the All Scan mode. The radio will then return to thelast valid channel.1. DW or Scan function is selected by PC program.2. Channel for DW is chosen by PC program.BATTERYSAVER/TXPOWER/PTTTONE  SETTING1. Short press , the LCD will display “S” and flashing “y” or “n”, then press or to enable or disable the Battery Saver mode, when the Battery saver is active, the will be displayed on the LCD screen. 2. Short press again, the LCD will display “P” and flashing “H” or “L”, Then press or to toggle the current channel TX power. When the Channel is High power, the will be displayed on the LCD screen. 3. Short press again, the LCD will display “t” and flashing “y” or “n”, Then press or to enable or disable the PTT tone. When the PTT tone is active, the will be displayed on the LCD screen 8
TROUBLESHOOTINGPROBLEM POSSIBLE CAUSES / REMEDIESCan’t turn the radio on Check the battery is correctly installed●and has beenfully chargedCan’t communicate withother radiosVOX function is not working ●Check the headset is correctly plugged in and iscompatible with the Mini 391 radio●For this and all other issues contact Advanced WirelessCommunications at 1-800-475-5852 orwww.advancedwireless.com for more informationSee below for some common problems and their remedies. DO NOT attempt any repairsyourself. This will invalidate your warranty. 9
Package ListAccessoriesPhotoQuantity1Radio 13Battery14Charger15Power Adapter12Belt Clip110

Navigation menu