Olympia Innovations Y00L Smart Lantern User Manual O2Tech Quickstart ML 1204 R2ai
Olympia Innovations Inc. Smart Lantern O2Tech Quickstart ML 1204 R2ai
User Manual
SMART LANTERN
HARDWARE SETUP
1Remove the battery pack from the base of the lantern by
squeezing the side clips and insert four (4) D cell batteries
(batteries not included).
Slide the battery pack back into the base of the lantern
until you hear the side clips snap into place.
2Press the power button once to turn on the lantern.
Press the power button again to cycle through the High,
Medium, Low, Flash, S.O.S. and Standby modes.
Press and hold the power button continuously for 3
seconds to completely power off the lantern.
DOWNLOAD THE APP
3Get the O2Tech Smart Lantern app for Android or iPhone
by scanning this QR code, or by visiting http://o2tech.co on
your smartphone.
TURN OVER PAGEPAGE 1 / 3
SMART LANTERN
FCC RULES OPERATION
NOTICE:
This device complies with Part 15 of the FCC Rules Operation is subject to the following two
conditions:
¥ This device may not cause harmful interference, and
¥ This device must accept any interference received, including interference that may
!!cause undesired operation.
NOTICE:
Changes or modiÞcations made to this equipment not expressly approved by (manufacturer
name) may void the FCC authorization to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
¥ Reorient or relocate the receiving antenna.
¥ Increase the separation between the equipment and receiver.
¥ Connect the equipment into an outlet on a circuit different from that to which the
! !receiver is connected.
¥ Consult the dealer or an experienced radio/TV technician for help.
The radiated output power of the device is far below the FCC radio frequency exposure limits.
Nevertheless, the device shall be used in such a manner that the potential for human contact
during normal operation is minimized.
PAGE 3 / 3
PAGE 4/4 PAGE 1/4
SMART LANTERN
CONNECT THE LANTERN TO YOUR PHONE
4Press the power button once to ensure the lantern is
turned on. The logo on the power button will glow white
when the lantern is on, or in standby mode.
Standby mode allows the lantern to remain connected to
your app while no light is on.
5On your iPhone or Android device, go to your device’s
Settings screen and tap on Bluetooth. In the Bluetooth
screen, make sure Bluetooth has been switched on.
It’s best to place your lantern close to your iPhone or
Android device when Þrst connecting.
6Open the O2Tech Smart Lantern app and follow the
instructions to connect to your lantern.
You can control up to Þve lanterns at once from the same
app. Any settings you change such as brightness or color
will apply to all lanterns at once.
PAGE 2 / 3
SMART LANTERN
BATTERY WARNING
Frequent attempts to connect to the O2Tech Smart Lantern while not in use by
Bluetooth apps may drain the lantern's battery pack. Please remove the battery
pack from your O2Tech Smart Lantern while not in use.
PAGE 2/4
PAGE 3/4