Option OGI0322 Quadband GSM/GPRS/EDGE and Triband UMTS/HSDPA/HSUPA USB Modem User Manual 08 certification leaflet
Option NV Quadband GSM/GPRS/EDGE and Triband UMTS/HSDPA/HSUPA USB Modem 08 certification leaflet
Option >
Contents
08 certification leaflet
![iCON 322 FCC ID: NCMOGI0322 CE 0682 Certification Leaflet Federal communications commission notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15,22 and 24 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: > Reorient or relocate the receiving antenna. > Increase the separation between the equipment and receiver. > Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. > Consult the dealer or an experienced radio or television technician for help. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by Option could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC rules. This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Exposure Information to Radio Frequency Energy This device complies to the SAR regulation as stated by the FCC. The measurements were made according to the Supplement C to OET Bulletin 65 of the Federal Communications Commission (FCC) Guidelines [OET 65] for evaluating compliance of mobile and portable devices with FCC limits for human exposure (general population) to radiofrequency emissions. The device was tested in all possible orientations while plugged into laptop computers. The highest SAR value for this modem when tested on top side with 12.7 mm (1/2 inch) distance was 1.45 W/kg. In positions other than top side, a separation distance of 5 mm (1/5 inch) is required. The highest SAR value in this case was 1.17 W/kg. This USB modem is approved for use in normal size laptop computers only (typically with 12" or larger display screens). To comply with FCC RF exposure requirements, this modem should not be used in configurations that cannot maintain at least below stated distances from users and bystanders: • 12.7 mm (1/2 inch) distance from the top side of the modem • 5 mm (1/5 inch) from all other sides The antenna swivel cap should be clicked into position during operation of the device. Users concerned with the risk of Radio Frequency exposure may wish to limit the duration of their calls and to position the modem as far away from the body as is practical. Top side](https://usermanual.wiki/Option/OGI0322.08-certification-leaflet/User-Guide-993689-Page-1.png)
