Orpak Systems 800942XXX NOZZLE READER UNR User Manual 1

Orpak Systems Ltd. NOZZLE READER UNR 1

User Manual

µNR Operating Instructions P/N 817439451 Rev A 1. SCOPE This document provides a general and functional description of the µNozzle Reader (hereafter referred to as µNR) units. 2. µNR DESCRIPTION The µNR is a self-contained, battery operated transceiver installed on the dispenser’s fueling nozzle. µNR uses RFID technology to read the vehicle FuelOmat data and transfer it to the WGT network through the nearest WGT. The µNR uses an internal battery and requires only mechanical interface to the fueling nozzles. The following NR types are available (Figure 1and Figure 2): Figure 1. µNR-F Figure 2. µNR-B/T – Rectangular Coil (Left) & Round Coil (Right) µNR Operating Instructions 1
3. OPERATING INSTRUCTIONS Proceed as follows: 1. Remove the nozzle from the boot 2. Insert the nozzle spout into the vehicle fuel inlet 3. The µNR detects the FuelOpass and the indication LED blink twice 4. Turn on the pump handle and dispense fuel 5. Turn the pump handle off 6. Return the nozzle to the boot 4. TECHNICAL SPECIFICATIONS Table 1 lists the specifications for the µNR units. Table 1. µNR Specifications Parameter Description Supply Voltage: P/N 812539200 (x2) Battery replacement should be performed only by authorized service personnel Power Consumption: Active mode: 25mA typical. Standby mode: 20µA Battery Life Span 2 to 3 years typical Operating Temperature: -40° to +60 °C Storage Temperature: -40° to +60 °C Dimensions (HxWxD): µNR Assembly: 27.2x39.3x44.2mm NR-B Back Clamp: 106x56.9x72.2mm Communication Interface: 1. RF communication method to WGT: • Frequency: 2.405-2.480 GHz • Typical transmission power: 3dbm (2mW) 2. RFID communication method with FuelOpass: • Frequency: 119-135 kHz 2 µNR Operating Instructions
FCC Compliance Statement This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio and television reception. However, there is no guarantee that interference will not occur in a particular installation. If this device does cause such interference, which can be verified by turning the device off and on, the user is encouraged to eliminate the interference by one or more of the following measures: – Re-orient or re-locate the receiving antenna. – Increase the distance between the device and the receiver. – Connect the device to an outlet on a circuit different from the one that supplies power to the receiver. – Consult the dealer or an experienced radio/TV technician. WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with FCC Rules Part 15 and with Industry Canada licence-exempt RSS standard(s). Operation is subject to two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference that may be received or that may cause undesired operation. Le present appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux conditions suivantes :(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement. µNR Operating Instructions 3

Navigation menu