Orpak Systems 800942XXX NOZZLE READER UNR User Manual 1

Orpak Systems Ltd. NOZZLE READER UNR 1

User Manual

Download: Orpak Systems 800942XXX NOZZLE READER UNR User Manual 1
Mirror Download [FCC.gov]Orpak Systems 800942XXX NOZZLE READER UNR User Manual 1
Document ID2011302
Application IDTZjqSgnBAbJCYvs1HjiMuw==
Document DescriptionUser Manual
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize18.26kB (228247 bits)
Date Submitted2013-07-09 00:00:00
Date Available2013-07-09 00:00:00
Creation Date2013-05-26 16:39:18
Producing SoftwareAdobe PDF Library 11.0
Document Lastmod2013-05-26 16:39:20
Document Title1
Document CreatorAcrobat PDFMaker 11 for Word
Document Author: yoram_f

µNR Operating Instructions
P/N 817439451
Rev A
1. SCOPE
This document provides a general and functional description of the µNozzle Reader
(hereafter referred to as µNR) units.
2. µNR DESCRIPTION
The µNR is a self-contained, battery operated transceiver installed on the dispenser’s
fueling nozzle. µNR uses RFID technology to read the vehicle FuelOmat data and
transfer it to the WGT network through the nearest WGT. The µNR uses an internal
battery and requires only mechanical interface to the fueling nozzles. The following
NR types are available (Figure 1and Figure 2):
Figure 1. µNR-F
Figure 2. µNR-B/T – Rectangular Coil (Left) & Round Coil (Right)
µNR Operating Instructions
3. OPERATING INSTRUCTIONS
Proceed as follows:
1.
2.
3.
4.
5.
6.
Remove the nozzle from the boot
Insert the nozzle spout into the vehicle fuel inlet
The µNR detects the FuelOpass and the indication LED blink twice
Turn on the pump handle and dispense fuel
Turn the pump handle off
Return the nozzle to the boot
4. TECHNICAL SPECIFICATIONS
Table 1 lists the specifications for the µNR units.
Table 1. µNR Specifications
Parameter
Description
Supply
Voltage:
P/N 812539200 (x2)
Battery replacement should
be performed only by
authorized service personnel
Power
Consumption:
Active mode: 25mA typical.
Standby mode: 20µA
Battery Life
Span
2 to 3 years typical
Operating
Temperature:
-40° to +60 °C
Storage
Temperature:
-40° to +60 °C
Dimensions
(HxWxD):
µNR Assembly:
27.2x39.3x44.2mm
NR-B Back Clamp:
106x56.9x72.2mm
Communication 1. RF communication
Interface:
method to WGT:
• Frequency: 2.4052.480 GHz
• Typical transmission
power: 3dbm (2mW)
2. RFID communication
method with FuelOpass:
• Frequency: 119-135
kHz
µNR Operating Instructions
FCC Compliance Statement
This device has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in residential installations. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
and television reception.
However, there is no guarantee that interference will not occur in a particular
installation. If this device does cause such interference, which can be verified by
turning the device off and on, the user is encouraged to eliminate the interference by
one or more of the following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one that supplies
power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
WARNING! Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with FCC Rules Part 15 and with Industry Canada licenceexempt RSS standard(s). Operation is subject to two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept
any interference that may be received or that may cause undesired operation.
Le present appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisee aux deux conditions
suivantes :(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est
susceptible d'en compromettre le fonctionnement.
µNR Operating Instructions

Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : yoram_f
Create Date                     : 2013:05:26 16:39:18+03:00
Modify Date                     : 2013:05:26 16:39:20+03:00
Language                        : EN-US
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03
Metadata Date                   : 2013:05:26 16:39:20+03:00
Creator Tool                    : Acrobat PDFMaker 11 for Word
Document ID                     : uuid:629c7bf4-1b28-45eb-aac4-93057aa656b2
Instance ID                     : uuid:e76c469e-22bc-4eca-bc67-73a004771d94
Subject                         : 2
Format                          : application/pdf
Title                           : 1
Creator                         : yoram_f
Producer                        : Adobe PDF Library 11.0
Source Modified                 : D:20130526133909
Company                         : 
Page Layout                     : OneColumn
Page Count                      : 3
EXIF Metadata provided by EXIF.tools
FCC ID Filing: W8F800942XXX

Navigation menu