Ox Co IVS465 K-Band Transceiver Module User Manual TBD IVS 465

Optex Co Ltd K-Band Transceiver Module TBD IVS 465

User manual

Innovation in radar sensing Innovation in radar sensing 1 von 3 DATA SHEET IVS-465 09-02-2009 Version 1.2 ___________________________________________________________________________________________________ DATA SHEET Product Family: FSK/FMCW-capable Low-cost K-Band VCO Transceiver Range of use: Industrial Applications Module Number: IVS-465 _____________________________________________________________________________________________________ Description: • K-Band VCO radar transceiver for FMCW/FSK applications • advanced PHEMT –oscillator with low current consumption • split transmit and receive path for maximum gain • stereo (dual channel) operation for direction of motion identification • very small outline dimensions • Low-cost K-Band VCO Transceiver Environmental Tests and Handling Precautions: • This InnoSenT sensor is sensitive to damage from ESD. • Normal precautions as usually applied to CMOS devices are sufficient when handling the device. Touching the signal output pins has to be avoided at any time before soldering or plugging the device into a motherboard. Absolute maximum and minimum Ratings: Parameter Symbol Rating Units supply voltage VCC 5,5 V varactor tuning voltage VTune 12 V operating temperature (out of spec) TOP. 0,5 V storage temperature TSTG -40/+85 °C Electrical Characteristics: Parameter Symbol min. typ. max. units comment transmit frequency ftransmit 24.000 24.125 24.250 GHz depending on VTune varactor tuning voltage VTune 0,5 10 V varactor input impedance see equivalent circuit modulation input 150 kHz tuning slope 50 MHz/V output power (EIRP) Pout 12 dBm temperature drift f -1 MHz/°C antenna pattern horizontal 80 ° azimuth vertical 32 ° elevation side lobe suppression horizontal 13 ° azimuth vertical 13 ° elevation I/Q balance amplitude 6 dB phase 60 90 120 ° IF output voltage offset -300 +300 mV supply voltage VCC 4.75 5.0 5.25 V supply current ICC 35 50 mA operating temperature TOP -20 +60 °C outline dimensions ~ 25 x 25 x 7 (12.7) mm compare drawing
Innovation in radar sensing Innovation in radar sensing 2 von 3 DATA SHEET IVS-465 09-02-2009 Version 1.2 Varactor input impedance equivalent circuit: Interface: The sensor provides a 2.54 mm grid, single row pin header (square pin 0.635 mm) Pin # Description In/Out Comment 1 VTune input varactor tuning voltage 2 VCC input supply voltage (+5 V) 3 GND input analog ground 4 IF2 output Signal Q(uadrature) 5 IF1 output Signal I(nphase) Mechanical Outlines: (dimensions in mm)
Innovation in radar sensing Innovation in radar sensing 3 von 3 DATA SHEET IVS-465 09-02-2009 Version 1.2 FCC approval • This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • Warning: Changes or modifications made to this equipment not expressly approved by InnoSenT GmbH may void the FCC authorization to operate this equipment. • Manufacturers of mobile or fixed devices incorporating IVS-465 modules are authorized to use the FCC Grants and IC Certificates of the IVS-465 modules for their own final products according to the conditions referenced in these documents. In this case, the FCC label of the module shall be visible from the outside, or the host device shall bear a second label stating "Contains FCC ID: DC9-IVS465" and "Contains IC: 4012A-IVS465". Certification and environment protection: InnoSenT GmbH has established and applies a quality system for: Development, production and sales of radar sensors for commercial and industrial sensors An audit was performed, Report No. 010350 Proof has been furnished that the requirements according to DIN EN ISO 9001:2000 are fulfilled. This InnoSenT product is compliant to the restriction of hazardous substances (RoHs – European Union directive 2002/95/EG). InnoSenT Approval This data sheet contains the technical specifications of the described product. The technical specifications of this data sheet are approved: InnoSenT GmbH Am Roedertor 30 97497 Donnersdorf GERMANY Contact Information: InnoSenT GmbH Am Roedertor 30 97499 Donnersdorf Germany Phone: +49 (0) 9528-9518-0 Fax: +49 (0) 9528-9518-99 E-Mail: info@InnoSenT.de Web: www.InnoSenT.de

Navigation menu