PC Locs ELE1906 6-key remote controller User Manual Manual R6 lab 101221
PC Locs Pty Ltd 6-key remote controller Manual R6 lab 101221
PC Locs >
Users Manual
USER MANUAL
Tips of using the Remote Controller:
* Line of sight from the Remote Switch to the Receiver is not required.
The control signal can pass through walls and ceilings.
* As with all RF transmitter devices, electrical fields, metal doors,
and motor devices can decrease the strength of the transmitting control
signal. Reorient the Remote Controller may increase the control range.
* It is not guaranteed that every control signal sent out by the Remote
Controller will be received by the paired Receiver. Check to make sure
of the Receiver has responded after your press on the Remote Controller.
* If the LED indicator of the Remote Controller dimmed, replace the
battery according to the polarity sign on the battery apartment. One
new CR2032 lithium battery is needed.
6-key Remote Controller
This is a remote controller that can generate radio wave carrying control
signal. After paired with a suitable Receiver, the remote controller can
control the Receiver by pressing on the remote. Each button of the remote
contains one unique ID. The paired Receiver is capable to identify the ID
and then take action accordingly.
SAFE
ON
SAFE
OFF
1HR
ALL
3HR
ALL
1HR
CYCLE
3HR
CYCLE
Specifications:
Product: 6-key Remote Controller
Model No.: ELE1906
Transmission Media: 433.92MHz radio frequency
Power Supply: 1 x CR2032 3V battery
WEEE Directive & Product Disposal
At the end of its serviceable life, this
product should not be treated as
household or general waste. It should be
handed over to the applicable collection
point for the recycling of electrical and
electronic equipment, or returned to the
supplier for disposal.
Designed and Manufactured by:
Sino Wealthy (HK) Limited
Room 1801, Great Eagle Centre, No.23,
Harbour Road,Wanchai, Hong Kong
admin@sinowell.com.hk
Manufactured under ISO9001
quality management system
Made in Shenzhen,China
This Remote Controller conforms with Part 15 of FCC rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference;
2. This device must accept any interference received, including
interference may cause undesired operation.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the device.
NOTE: This device have ben tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential use. This device generates, uses and can radiate radio
frequency energy and, if not used in accordance with the instructions, may
cause harmful interference to radio communications.