Palm AOKI Wireless PDA User Manual legal

Palm Inc Wireless PDA legal

Contents

Updated Regulatory Information

Palm® T|X Handheld 672Product Regulatory InformationFCC StatementThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.The use of shielded I/O cables is required when connecting this equipment to any and all optional peripheral or host devices. Failure to do so may violate FCC rules.Changes or modifications not covered in this manual must be approved in writing by the manufacturer’s Regulatory Engineering Department. Changes or modifications made without written approval may void the user’s authority to operate this equipment.In August 1996, the FCC of the United States with its action in Report and Order FCC 96-326 adopted an updated safety standard for human exposure to radio frequency electromagnetic energy emitted by FCC regulated transmitters. Those guidelines are consistent with the safety standard previously set by both U.S. and international standards bodies. The design of this product complies with the FCC guidelines and these international standards.IMPORTANT[!]
Palm® T|X Handheld 673Exposure to radio frequency energy (SAR) In order to comply with FCC RF exposure safety guidelines, this device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. The user of this device should ensure that the operation of this device is in compliance with these provisions.FCC RF Safety StatementIn order to comply with FCC RF exposure safety guidelines, if the device is to be worn on the body, users MUST use a "body-worn" accessory that contains NO metal (snaps, clips, etc) and provides AT LEAST 1.5 cm of separation between the users body and the unit.Do NOT use the device in a manner such that it is in direct contact with the body (i.e. on the lap or in a breast pocket). Such use will likely exceed FCC RF safety exposure limits. See www.fcc.gov/oet/rfsafety/ for more information on RF exposure safety.FCC ID: O8FAOKIAntenna Care/Unauthorized Modifications Use only the supplied integral antenna. Unauthorized antenna modifications or attachments could damage the unit and may violate FCC regulations. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.Responsible Party:North AmericaPalm, Inc. 950 W. Maude Ave. Sunnyvale, California 94085-2801United States of Americawww.palm.comEuropeBornibus FrancoisBuckhurst CourtLondon RoadWokingham, Berkshire RG40 1PA,www.palm.comPalmT|X
Palm® T|X Handheld 674Potentially Unsafe Areas Potentially explosive atmospheres: Turn off your unit when you are in any areas with a potentially explosive atmosphere, such as fueling areas (gas or petrol stations) or storage facilities for fuel or chemicals.Industry Canada The term “IC:” before the certification/registration number only signifies that the Industry Canada technical specifications were met.IC: 3905A-AOKICanadian Wireless Regulatory Notice This Class B digital apparatus meets all the requirements of the Canadian Interference Causing Equipment Regulations. Operation is subject to the following two conditions: a) this device may not cause any interference, and b) this device must accept any interference, including interference that may cause undesired operation of the device. To prevent radio interference to the licensed service, this device is intended to be operated indoors, and away from windows to prevent maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing.CE Declaration of ConformityPalm T|XPalm, Inc. declares that the above model of Palm PDA is compliant with the specifications below. The declaration applies to the PDA and its associated accessories (power supply, and USB cable) where applicable.Maximum Measured SAR Values (W/kg) (1gr. AVG) IEEE802.11 B Body SAR: .17Conforms with the following Specifications:EMC: EN 301 489-1 V1.4.1 (Aug 2002) EN 301 419-17 V1.2.1(Aug 2002)EN 300 328 V1.5.1 (Aug 2004) !
Palm® T|X Handheld 675FCC CFR 47 Part 15.247SAR: ANSI/IEEE C95.1 1999FCC OET Bulletin 65 Supplement CSafety: EN 60950: 2000 (Jan-2000)Radiated Emissions: EN 55022:1998/A1:2000/A2:2003 Class BImmunity: EN 55024:1998/A1:2001/A2:2003Authorized Palm Representative: Palm Regulatory Compliance DepartmentDate: June 23, 2005Battery WarningDo not mutilate, puncture, or dispose of batteries in fire. The batteries can burst or explode, releasing hazardous chemicals. Discard used batteries according to the manufacturer’s instructions and in accordance with your local regulations.Varning Eksplosionsfara vid felaktigt batteribyte. Använd samma batterityp eller en ekvivalent typ som rekommenderas av apparattillverkaren. Kassera använt batteri enligt fabrikantens instruktion.Advarsel! Lithiumbatteri—Eksplosionsfare ved fejlagtig håndtering. Udskiftning må kun ske med batteri af samme fabrikat og type. Levér det brugte batteri tilbage tilleverandøren.Varoitus Paristo voi räjähtää, jos se on virheellisesti asennettu. Vaihda paristo ainoastaan valmistajan suosittelemaan tyyppiin. Hävitä käytetty paristo valmistajan ohjeiden mukaisesti.Advarsel Eksplosjonsfare ved feilaktig skifte av batteri. Benytt samme batteritype eller en tilsvarende type anbefait av apparatfabrikanten. Brukte batterier kasseres i henhold til fabrikantens instruksjoner.Waarschuwing! Bij dit produkt zijn batterijen geleverd. Wanneer deze leeg zijn, moet u ze niet weggooien maar inleveren als KCA.
Palm® T|X Handheld 676UwagaIntrinsic Safety WarningWarning – Explosion Hazard• Substitution of components may impair suitability for Class I, Division 2;• When in hazardous location, turn off power before replacing or wiring modules, and,• Do not disconnect equipment unless power has been switched off or the area is known to be non-hazardous.Wireless Notices—Usage CautionsIn some situations, the user of the wireless device may be restricted. Such restrictions may apply aboard an airplane, in hospitals, near explosive environment, in hazardous locations etc. If you are not certain of the policy that applies to the use of this device, please ask for authorization prior to turning on the device.Static Electricity, ESD, and Your Palm® HandheldElectrostatic discharge (ESD) can cause damage to electronic devices if discharged into the device, so you should take steps to avoid such an occurrence.Description of ESDStatic electricity is an electrical charge caused by the buildup of excess electrons on the surface of a material. To most people, static electricity and ESD are nothing more than annoyances. For example, after walking over a carpet while scuffing your feet, building up electrons on your body, you may get a shock—the discharge event—when you touch a metal doorknob. This little shock discharges the built-up static electricity.ESD-susceptible equipmentEven a small amount of ESD can harm circuitry, so when working with electronic devices, take measures to help protect your electronic devices, including your Palm® handheld, from ESD harm. While Palm has built
Palm® T|X Handheld 677protections against ESD into its products, ESD unfortunately exists and, unless neutralized, could build up to levels that could harm your equipment. Any electronic device that contains an external entry point for plugging in anything from cables to docking stations is susceptible to entry of ESD. Devices that you carry with you, such as your handheld, build up ESD in a unique way because the static electricity that may have built up on your body is automatically passed to the device. Then, when the device is connected to another device such as a docking station, a discharge event can occur. Precautions against ESDMake sure to discharge any built-up static electricity from yourself and your electronic devices before touching an electronic device or connecting one device to another. The recommendation from Palm is that you take this precaution before connecting your handheld to your computer, placing the handheld in a cradle, or connecting it to any other device. You can do this in many ways, including the following: • Ground yourself when you’re holding your mobile device by simultaneously touching a metal surface that is at earth ground. For example, if your computer has a metal case and is plugged into a standard three-prong grounded outlet, touching the case should discharge the ESD on your body.• Increase the relative humidity of your environment.• Install ESD-specific prevention items, such as grounding mats.Conditions that enhance ESD occurrencesConditions that can contribute to the buildup of static electricity in the environment include the following:• Low relative humidity.• Material type (The type of material gathering the charge. For example, synthetics are more prone to static buildup than natural fibers like cotton.)• The rapidity with which you touch, connect, or disconnect electronic devices.While you should always take appropriate precautions to discharge static electricity, if you are in an environment where you notice ESD events, you may want to take extra precautions to protect your electronic equipment against ESD.

Navigation menu