Panasonic of North America 96NKX-TGA405 DECT Cordless Telephone Repeater User Manual TGA405 applay ver001 indd

Panasonic Corporation of North America DECT Cordless Telephone Repeater TGA405 applay ver001 indd

user manual

Installation Guide for Range ExtenderBy installing this unit, you can extend the range of your phone system, to include areas where reception was previously not available. The unit extends the range in all directions, allowing several floors to be covered.Important:LThis unit is an accessory unit for use with the following series of Panasonic Digital Cordless phones: KX-TG4051/KX-TG4071/KX-TG4051CLThis unit is pre-registered to the base unit.LThis leaflet only describes the steps needed to install and use the unit. Refer to the base unit’s operating instructions for the accessory information, important information for safety, FCC information (for U.S.A. users only), and Industry Canada Notices and other information (for Canada users only).For best performancePlacementLWe recommend installing the unit to a raised position (such as on a wall), which is well within range of the base unit.LAvoid positioning the unit close to objects that will interfere with reception, such as thick walls, radiators, metal shelving, etc.LFor maximum distance noise-free operation, place the unit away from electrical appliances such as TV, radio, personal computer or other telephone equipment.LKeep a minimum distance of 5 m between this unit and the base unit.(The minimum distance may vary depending on the location.) If the unit is installed near the base unit, the handset directly communicates with the base unit.Model No.Range ExtenderKX-TGA405KX-TGA405CBase unitHandsetRange extenderRange extender rangeBase unit rangeKX-TG4011/KX-TG4021/KX-TG4031/KX-TG4051/KX-TG4071/KX-TG6511/KX-TG6521/KX-TG6531/KX-TG6541/KX-TG7531LYou must register this unit with your base unit before it can be used.LThis lea et only describes the steps needed to install and use the unit. Please read the base unit’s operating instructions for further details.
_2_ControlsUnderstanding the STATUS indicator and q indicatorInstallationASTATUS indicatorBq indicatorID indicatorCPROGRAMIndicator Light status MeaningSTATUSindicatorGreen On LWithin base unit range. The unit is ready for use.Flashing L1 handset is communicating with the base unit through this unit.FlashingrapidlyL2 handsets are communicating with the base unit through this unit.Red On LOut of base unit range.Off LThe power is off. (AC adaptor is not connected properly.)qindicatorGreen On LSignal strength of the base unit is strong.Amber On LSignal strength of the base unit is weak.Red On LOut of base unit range.Off LThe unit is not being used.LThe power is off.BAC1 Base unit:Press and hold [LOCATOR] for about 5 seconds until the registration tone sounds.LThe next step must be completed within 90 seconds.
_3_Wall MountingDrive the screws (not supplied) into the wall. Mount the unit, then slide it down.37.0 mm(115/32 inches)Screws2Confirm that the STATUS indicator and q indicator light green. (The unit is ready for use.)LIf the indicators do not light green, re-position the unit in a place where the indicators light green.21Connect the unit.LUse only the supplied Panasonic AC adaptor PQLV219.LWhen the unit is turned on, the STATUS indicator and q indicator light amber for about 2 seconds.Press plug firmly.(120 V AC, 60 Hz) Hook23Note:LThe AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.)LThe unit can support a maximum of 2 handsets at a time.SpecificationsNStandard: DECT 6.0 (Digital Enhanced Cordless Telecommunications 6.0)NFrequency range: 1.92 GHz to 1.93 GHzNRF transmission power: 115 mW (max.)NPower source: 120 V AC, 60 HzNPower consumption: Standby: Approx. 0.0 W, Maximum: Approx. 0.0 WLTo stop the registration tone, press [LOCATOR] on the base unit.1.0 W, 1.8 W
_4_TroubleshootingProblem Cause/solutionThe unit does not work. LWhen the indicators do not light, the AC adaptor is not connected properly. Check the connections.LWhen the indicators light red, the unit is out of base unit range. Move the unit closer to the base unit.LRegistration may have been canceled.Deregister the unit, then re-register.Deregister:1Unplug the AC adaptor, then press and hold {PROGRAM}.2While pressing and holding {PROGRAM}, re-connect the AC adaptor.3Keep pressing and holding {PROGRAM} for about 10 seconds until the STATUS indicator flashes amber. Then release {PROGRAM}.Re-register:1Range extender: Unplug the AC adaptor.2Base unit: Press and hold {LOCATOR} for about 5 seconds until the registration tone sounds.– The next step must be completed within 90 seconds.3Range extender: Connect the AC adaptor, then wait until the STATUS indicator lights green.4Base unit: To stop the registration tone, press {LOCATOR}.While talking using the handset, sound cuts in and out.LThe handset is out of range. Move the handset closer to this unit.
_5_For your safetyTo prevent severe injury and loss of life/property, read this section carefully before using the product to ensure proper and safe operation of your product.WARNINGPower connectionLUse only the power source marked on the product.LDo not overload power outlets and extension cords. This can result in the risk of fire or electric shock.LCompletely insert the AC adaptor/power plug into the power outlet. Failure to do so may cause electric shock and/or excessive heat resulting in a fire.LRegularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation defect from moisture, etc. resulting in a fire.LUnplug the product from power outlets if it emits smoke, an abnormal smell, or makes an unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has stopped emitting and contact the Panasonic Call Center at 1-800-211-PANA (1-800-211-7262).LUnplug from power outlets and never touch the inside of the product if its casing has been broken open.LNever touch the plug with wet hands. Danger of electric shock exists.InstallationLTo prevent the risk of fire or electrical shock, do not expose the product to rain or any type of moisture.LDo not place or use this product near automatically controlled devices such as automatic doors and fire alarms. Radio waves emitted from this product may cause such devices to malfunction resulting in an accident.LDo not allow the AC adaptor or telephone line cord to be excessively pulled, bent or placed under heavy objects.Operating safeguardsLUnplug the product from power outlets before cleaning. Do not use liquid or aerosol cleaners.LDo not disassemble the product.LDo not spill liquids (detergents, cleansers, etc.) onto the telephone line cord plug, or allow it to become wet at all. This may cause a fire. If the telephone line cord plug becomes wet, immediately pull it from the telephone wall jack, and do not use.MedicalLConsult the manufacturer of any personal medical devices, such as pacemakers or hearing aids, to determine if they are adequately shielded from external RF (radio frequency) energy. (The product operates in the frequency range of 1.92 GHz to 1.93 GHz, and the RF transmission power is 115 mW (max.).)LDo not use the product in health care facilities if any regulations posted in the area instruct you not to do so. Hospitals or health care facilities may be using equipment that could be sensitive to external RF energy.CAUTIONInstallation and locationLNever install telephone wiring during an electrical storm.LNever install telephone line jacks in wet locations unless the jack is specifically designed for wet locations.LNever touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.LUse caution when installing or modifying telephone lines.LThe AC adaptor is used as the main disconnect device. Ensure that the AC outlet is installed near the product and is easily accessible.LThis product is unable to make calls when:– the handset batteries need recharging or have failed.– there is a power failure.･ The AC adaptor is used as the main disconnected device. Ensure that the AC outlet is installed near the product and is easily accessible.
_6_Important safety instructionsWhen using your product, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:1. Do not use this product near water for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement or near a swimming pool.2. Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric shock from lightning.3. Do not use the telephone to report a gas leak in the vicinity of the leak.4. Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions.SAVE THESE INSTRUCTIONSFor best performanceBase unit location/avoiding noiseThe base unit and other compatible Panasonic units use radio waves to communicate with each other.LFor maximum coverage and noise-free communications, place your base unit:– at a convenient, high, and central location with no obstructions between the handset and base unit in an indoor environment.– away from electronic appliances such as TVs, radios, personal computers, wireless devices, or other phones.– facing away from radio frequency transmitters, such as external antennas of mobile phone cell stations. (Avoid putting the base unit on a bay window or near a window.)LCoverage and voice quality depends on the local environmental conditions.LIf the reception for a base unit location is not satisfactory, move the base unit to another location for better reception.Range extender location/avoiding noiseThe range extender and other compatible Panasonic units use radio waves to communicate with each other.EnvironmentLKeep the product away from electrical noise generating devices, such as fluorescent lamps and motors.LThe product should be kept free from excessive smoke, dust, high temperature, and vibration.LThe product should not be exposed to direct sunlight.LDo not place heavy objects on top of the product.LWhen you leave the product unused for a long period of time, unplug the product from the power outlet.LThe product should be kept away from heat sources such as heaters, kitchen stoves, etc. It should not be placed in rooms where the temperature is less than 0 °C (32 °F) or greater than 40 °C (104 °F). Damp basements should also be avoided.LThe maximum calling distance may be shortened when the product is used in the following places: Near obstacles such as hills, tunnels, underground, near metal objects such as wire fences, etc.LOperating the product near electrical appliances may cause interference. Move away from the electrical appliances.Routine careLWipe the outer surface of the product with a soft moist cloth.LDo not use benzine, thinner, or any abrasive powder.
_7_Other informationCAUTION: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.Notice for product disposal, transfer, or returnLThis product can store your private/confidential information. To protect your privacy/confidentiality, we recommend that you erase information such as phonebook or caller list entries from the memory before you dispose of, transfer, or return the product.NoticeImportant safety instructionsFCC and other informationThis device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.Privacy of communications may not be ensured when using this phone.CAUTION:Any changes or modifications not expresslyapproved by the party responsible for compliance could void the user’s authority to operate this device.NOTE:This equipment has been tested and found to comply with the limits for a Class B digitadevice, pursuant to Part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses, and can radiateradio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user iencouraged to try to correct the interferenceby one or more of the following measures:– Reorient or relocate the receiving antenna.– Increase the separation between the equipment and receiver.– Connect the equipment into an outlet on acircuit different from that to which the receiver is connected.
_8_– Consult the dealer or an experienced radio/TV technician for help.Some cordless telephones operate at frequencies that may cause interference to nearby TVs and VCRs. To minimize or prevent such interference, the base of the cordless telephone should not be placed near or on top of a TV or VCR. If interference is experienced, move the cordless telephone further away from the TV or VCR. This will often reduce, or eliminate, interference.FCC RF Exposure Warning:L This product complies with FCC radiation exposure limits set forth for an uncontrolled environment. L To comply with FCC RF exposure requirements, the base unit must be installed and operated 20 cm (8 inches) or more between the product and all person’s body (excluding extremities of hands, wrist and feet). L This product may not be collocated or operated in conjunction with any other antenna or transmitter.L The handset may be carried and operated with only the specific provided belt-clip. Other non-tested belt-clips or similar body-worn accessories may not comply and must be avoided.NoticeL FCC ID can be found inside the battery compartment or on the bottom of the units. FCC ID can be found on the bottom of the unit. To comply with FCC RF exposurerequirements, the range extender must be installed and operated 20 cm (8 inches) or more between the product and all person’s body (excluding extremities of hands, wrist and feet).

Navigation menu