Panasonic of North America 9TGWL15A Wireless Network Adaptor User Manual 20160427 v1 WL15A

Panasonic Corporation of North America Wireless Network Adaptor 20160427 v1 WL15A

User Manual_20160427_v1 - User Manual_WL15A.pdf

FCC ID: ACJ9TGWL15A / IC: 216H-CFWL15A
WLAN+BT module adapter
Model number: WL15A
User Manual
GENERAL
This device is the WLAN+BT module adapter IEEE802.11a/b/g/n/ac, dual band 2x2 Wi-Fi
+Bluetooth® adapter.
Integration to the end product
1. Insert WL15A module into PCIe M.2 card connector.
2. Secure the end of product using the screw.
3. Insert Antenna unit into Antenna connectors of WL15A module.
Technical Specification
a) Dimensions (H x W x D): 22mm x 30mm x 2.5mm
b) Weight: 2.3g
c) IEEE WLAN Standard: IEEE802.11a/b/g/n/ac
d) Bluetooth: BDR, EDR, Low energy
e) Antenna Diversity: Supported
f) Operating Temperature: -10 to 50 degree Celsius
g) Humidity: 30 to 80 %RH
h) Connector interface: PCIe M.2
i) Host interface: USB2.0 and PCIe v2.1 Gen1
FCC ID: ACJ9TGWL15A / IC: 216H-CFWL15A
Regulatory Information
Canada-Industry Canada (IC)
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils
radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage;
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
This device (local network devices) for the band 5150-5250 MHz is only indoor usage to
reduce potential for harmful interference to co-channel Mobile Satellite systems. High
power radars are allocated as primary users (meaning they have priority) of 5250-5350
MHz and 5650-5850 MHz and these radars could cause interference and/or damage to
LELAN devices.
Cet appareil (pour réseaux locaux radioélectriques) dans les bandes de fréquences
5150-5250 MHz est réervéàune utilisation àl’intéieur afin de réuire le risque d’interféence
avec les systèmes satellites mobiles bicanaux. Les radars forte puissance sont désignés
comme étant les premiers utilisateurs (c’st-à-dire qu’ls ont la priorité) des bandes de
fréquences 5250-5350 MHz et 5650-5850 MHz. Ces stations radars peuvent provoquer
des interférences et/ou des dommages à ce périphérique.
To reduce potential radio interference to other users, the antenna type and its gain should
be so chosen that the equivalent isotopically radiated power (EIRP) is not more than that
required for successful communication.
Caution: Exposure to Radio Frequency Radiation.
To comply with IC RF exposure compliance requirements, a separation distance of at least
FCC ID: ACJ9TGWL15A / IC: 216H-CFWL15A
5mm must be maintained between the antenna of this device and all persons. This device
must not be co-located or operating in conjunction with any other antenna or transmitter.
Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour
un environnement non contrôlé et respecte les règles d’exposition aux fréquences
radioélectriques (RF) CNR-102 de l’IC. Cet équipement doit être installé et utilisé en
gardant une distance de 5 mm ou plus entre le radiateur et le corps humain.
Instructions to OEM Integrators
A User manual provided to the end user must indicate the operating requirements and
conditions that must be observed to ensure compliance with the above-mentioned IC RF
Exposure guideline.
If this module is intended for use in a portable device, integrators are responsible for
separate evaluation and/or approval to satisfy IC RF Exposure requirements.
If other radio devices are to be integrated with this module, an additional evaluation and IC
submission may be required. Integrators are responsible for such additional evaluation and
IC submission.

Navigation menu