BAR LIGHTS ( BA2 AND BA3) Installation Directions
2014-09-27
: Pdf 109744-Installationsheet 109744-InstallationSheet 790576 Batch8 unilog
Open the PDF directly: View PDF .
Page Count: 1

Overview:
QMP Canopies are designed to fit all WAC quick connect
fixtures and pendants (50 watts max). They may also be used
on other manufacturers brand of quick connect (consult factory
for compatibility). This canopy mounts to a standard 4”
junction box, or directly to a surface (use conduit & junction
box where required by code). Power is supplied by a remote
12 or 24-volt transformer (sold separately).
Installation:
1. Cut out:4 1/8”
2. Consult voltage drop guidelines below to determine
distance and wire gauge sizes.
3. Remove the metal ring and separate the canopy from
Base plate.
4. Guide the secondary wires from the transformer through
the knock out in the junction box.
5. Connect fixture wires to transformer secondary wires,
with wire nuts (supplied).
Note: Do not connect to 120 volt building wires. Wires in
the junction box are fed from a remote transformer.
6. Attach the base plate to the junction box using two
screws (supplied).
7. If attaching to a flat surface, drill a 1 ¼” center hole to
allow clearance for wire assembly. Hold base plate
against the surface and mark positions of the canopy
screws, drill 3/16” holes. Use wood or other suitable
screws to affix base plate to surface through other
available holes or slots.
8. Mount the canopy to the surface, and tighten the metal
ring to the quick connect fitting.
9. Install Quick Connect fixture or pendant by inserting
quick connect post into fitting and threading clockwise
until snug.
Instructions: Quick Connect Canopies
Models : QMP-1RN-TR & QMP-1SQ-TR
CAUTION:
Always turn off power at fuse box prior to installation to prevent electrical shock.
For installation by a qualified electrician.
Retain instructions for future reference.
VOLTAGE DROP GUIDELINE/ Transformer to canopy distance
WIRE SIZE
35 W
50 W
18 GAUGE
8 FT
8 FT
16 GAUGE 12 FT 12 FT
14 GAUGE
16 FT
16 FT
12 GAUGE
20 FT
20 FT
Data based on 5% voltage drop
Junction box
Screw
Base plate
Quick connect fitting
Canopy
Metal ring
Quick connect post
Shown with the
QF-194 fixture
(Not included)
Retain these instructions for future service and adjustments
615 South Street, Garden City, NY 11530
Tel: (516) 515-5000 Fax (516) 515-5050
www.waclighting.com