421010 MSDS

2015-05-14

: Pdf 421010 Msds 421010_MSDS 45264 s

Open the PDF directly: View PDF PDF.
Page Count: 4

Per: 91/155/EEC and ISO 11014-1
Date: October 31, 2007
Number: RJSSH071090MSDSEU
Product names (as used on labels and list): LCD Cleaning Kit #421027, Mini Cleaning Kit #421010
Product description: A cleaning solution for screens and audio/video/digital/computer
products and accessories (isopropyl alcohol free).
Manufacturer: IC Intracom Asia Co., Ltd. • Far Eastern Technology Center
7-F No. 125, Section 2 • Da Tong Road, Shijr
Taipei, Taiwan
Contact: Dave Sousa
+1-813-855-0550, ext. 230
dsousa@icintracom.com
Water CAS No. 7732-18-5
A mixture of C8-18 fatty alcohol ethoxylate, a CAS No. 68439-51-0
co-polymer of ethylene oxide and propylene oxide
A blend of 5-chloro-2-methyl-4-isothiazolin-3-one CAS No. 55965-84-9
and 2-methyl-2H-isothiazolin-3-one
Phosphate ester CAS No. 95913-20-5
NOTE: This product presents no reported health hazards during normal use; however, read this entire MSDS for
a thorough evaluation of any potential hazards.
Possible routes of entry: Inhalation: yes; Skin: yes; Ingestion: yes; Eyes: yes
Eye contact: Eye contact can cause irritation.
Skin contact: Prolonged or repeated skin contact can result in irritation, drying
and cracking of the skin.
Inhalation: Low concentrations can cause mild irritation of eyes, nose and
throat; high concentrations can result in headaches.
Ingestion: Ingestion of large quantities can cause drowsiness, nausea and
vomiting.
Material Safety Data Sheet
Section I: Chemical Product & Company Identication
Section II: Composition / Information on Ingredients
Section III: Hazards Identication
Rev1, 6/13
Eye contact: Rinse eyes with water for at least 15 minutes, lifting lids occasionally
to remove particles. Get medical attention.
Skin contact: Wash exposed areas with soap and water. Should irritation persist,
get medical attention. Remove contaminated clothing and shoes
and wash items before reuse.
Inhalation: Remove to fresh air. If not breathing, give articial respiration; if
breathing is difcult, give oxygen. Get medical attention.
Ingestion: Not a likely route of exposure, but induce vomiting if a large amount
is swallowed. Get medical attention.
NOTE: This product is non-ammable.
Extinguishing media: Dry chemical, carbon dioxide, alcohol foam, water fog.
Special reghting procedures: As in any re, reghters should wear a self-contained breathing
apparatus in full pressure-demand, MSHA/NIOSH-approved (or
equivalent) protective gear.
Unusual re and explosion hazards: Closed containers exposed to heat can rupture.
Personal precautions: Wear appropriate personal protective equipment as specied in
Section VIII of this MSDS.
Cleanup: Flush into a sewer, using plenty of water. Otherwise, absorb any
spills with vermiculite or another inert material, then place in a
container for chemical waste. Prevent spills from entering potable
water supplies or streams. Finish clean-up by spreading water on
the contaminated surface. Eliminate all ignition sources. Any
product recovery or disposal must comply with local, state, federal,
international or country-specic regulations.
NOTE: Keep this product out of reach of children and pets.
Personal precautions: Use only when power to equipment is off. Protective eyewear and
clothing are recommended as needed to prevent excessive contact.
Prevention of re and explosion: No special technical protective measures are required.
Storage: Store in a cool, well-ventilated area away from all sources of ignition
(sparks, ames, etc.) and out of direct sunlight. Minimize solid and
liquid products’ exposure to air. Keep containers tightly closed,
and pack lightly for transport to prevent damage.
Section IV: First Aid Measures
Page 2 of 4
Section V: Fireghting Measures
Section VI: Accidental Release Measures
Section VII: Handling & Storage
Occupational exposure controls: None established.
Medical conditions aggravated by exposure: None known.
Ventilation: Good general ventilation (typically 10 air changes per hour) should
be used. Ventilation rates should be matched to conditions.
Respiratory protection: None should be needed with normal use.
Eye protection: None should be needed with normal use.
Skin and body protection: None should be needed with normal use.
Recommended decontamination facilities: Safety shower, eye wash and washing facilities are recommended
as appropriate to conditions.
Workplace hygiene practices: Wash thoroughly after handling and before eating, drinking or smoking.
Engineering controls: None required with normal use.
Appearance and odor: Colorless limpid liquid; fragrant.
Solubility in water: Soluble.
Density: 0.9970g/ml
pH: 5.0
Viscidity: 10.9s VOC: 1.8mg/kg
Conductance: 0.7ms/cm
Stability: The product is considered stable under normal conditions.
Hazardous polymerization: May not occur.
Incompatibility (materials to avoid): Nitric acid, sulfuric acid and strong oxidizers. Avoid heat, sparks
and ames.
Conditions to avoid: Direct sunlight, excessive heat and physical damage.
Metal corrosion: None.
Carcinogenicity: IARC: not established.
National Toxicology Program: not established.
OSHA: not established.
Reproduction toxicity: Not available.
Teratogenicity: Not available.
Mutagenicity: Not available.
Synergistic products: Not available.
Effects of exposure: Inhalation: low hazard with recommended handling.
Eyes: no specic hazard known; may cause transient irritation.
Skin: low hazard with recommended handling.
Ingestion: expected to be a low hazard.
Page 3 of 4
Section VIII: Exposure Controls & Personal Protection
Section IX: Physical & Chemical Properties
Section X: Stability & Reactivity
Section XI: Toxicological Information
NOTE: On the basis of available information, this product is not expected to produce any signicant adverse
environmental effects when recommended usage instructions are followed.
Waste disposal method: Discharge, treatment or disposal is subject to national, state,
provincial or municipal laws. Consult state or local regulatory
authorities before ushing into sewer using a large amount of water.
Empty container warnings: Empty containers may contain product residue. Follow MSDS and
label warnings even after containers have been emptied.
NOTE: Regulations may change from time to time. Consult the most recent version of the relevant regulations.
DOT proper shipping name: Not regulated.
Packing group: III (minor danger).
TDG classication: Non-regulated material.
Hazard class: Not regulated.
Identication number: Not applicable.
IMO: Not regulated.
IATA/ICAO class: Not regulated.
UN hazard codes: Not regulated.
NOTE: For detailed regulations, contact the appropriate agency in your country.
Label notication: Keep out of reach of children and pets. Not to be ingested.
NFPA hazard code: Health hazard rating: 0.
Fire hazard: 0.
Reactivity rating: 0.
Special hazard: none.
This data is offered in good faith as typical values and not as a product specication. The information in this data
sheet was compiled from information supplied by the vendors of the components of this compound. No warranty,
either expressed or implied, is hereby made. The recommended industrial hygiene and safe handling procedures
are believed to be generally applicable. However, each user should review these recommendations in the specic
context of the intended use and determine whether they are appropriate.
This Material Safety Data Sheet (MSDS) is for guidance and is based upon information and tests believed to be
reliable. IC Intracom makes no guarantee of the accuracy or completeness of the data and shall not be liable for
any damages relating thereto. The data is offered solely for your consideration, investigation and verication. IC
Intracom assumes no legal responsibility for use or reliance upon this data.
Page 4 of 4
Section XIII: Disposal Considerations
Section XIV: Transport Information
Section XV: Regulatory Information
Section XVI: Other Information
Section XII: Ecological Information

Navigation menu