556010
2016-12-28
: Pdf 556010 556010 msds
Open the PDF directly: View PDF 
.
Page Count: 4
Safety Data Sheet
29 CFR 1910.1200
Section 1: Company and Product Identification
Product Name:
Product Code:
Emergency Response:
Section 2: Hazards Identification GHS07 BLANK BLANK BLANK
Hazard Pictograms:
Signal Word: Warning
Hazard Category:
Hazard Statements:
Hazards not
otherwise classified:
Section 3: Composition / Information on Ingredients
CAS# Weight %
NA
Section 4: First Aid Measures
General Info:
Notable Exposure
symptoms:
If ingested:
This material under normal conditions of use is not expected to pose any physical hazards or health risks. The
component exposure limits and other information in this document are provided for circumstances such as over-
heating, burning, or exposure to heated materials.
Contains no ingredients considered hazardous as defined by the Occupational Healt & Safety Administration
(OSHA) in the hazzard communication standard (29 CFR 1910.1200). Contains a blend of trade secret resins and
modifying agents for which there are no OSHA or equivalent exposure standards.
P501: Dispose of contents/container in accordance with local/regional/national/international rules.
P202: Do not handle until all safety precautions have been read and understood
Product is supplied in the form of a solid paper tape coated with solid adhesive. Like any organic material it may release
toxic fumes and gasses, including carbon monoxide when burned or smoldered in air. Molten adhesive can adhere to skin
and may cause severe burns upon contact.
Halex Corporation
4200 E. Santa Ana Street
Ontario, CA 91761
PH: 313-555-9865
ORCON Hot Melt Seaming Tapes
Company:
K10, K-20, XK30, K40, XK50, XU90 SUPER3S, CT7DS, SUPER3DS
909-622-3537
None per OSHA Regulaitons: 29CFR1910.1200
None per SARA Tile III, Section 313 and TCA 40 CRF 372
Precautionary
Statements:
Hazardous substance (name)
None
Material is non toxic. Accidental ingestion of small pieces is not likely to cause harm, but larger pieces of materials may
pose a choking hazard to small children or pets.
P281: Use personal protective equipment as required
NA
Hazard Category
Product may give off vapors in appreciable quantities affecting the inhalation route. Ensure proper ventilation.
US-SDS 1 of 4 5/30/2015
556010
If inhaled:
Eye contact:
Skin contact:
Chronic Effects:
Section 5: Fire Fighting Measures
General Info:
Extinguishing
Method / Equipment:
Hazardous
Decomposition Info:
Section 6: Accidental Release Measures
Personal precautions,
protective equipment
and procedures:
Containment
Equipment and
Procedures:
Cleanup Procedures:
Section 7: Handling and Storage
Safe Handling
Precautions:
Recommendations for
Storage:
Incompatibilities:
Section 8: Exposure Control / Personal Protection
General /
Engineering
Controls:
Work Clothing:
Eye/face protection:
Skin Protection:
Respiratory
Protection:
Additional
Information:
Constituents associated with burning / combustion are to be considered toxic.
None Known
Keep a source of cool, clean water available at worksite for burn treatment.
When heated above its melting point such that smoke is generated, this product may release carbon monoxide.
No effects anticipated.
Can burn skin on contact with molten material.
No chronic effects known. Contains no ingredient listed as a carcinogen by IARC, NTP or OSHA.
Not Applicable
Not Applicable
Gather spilled materials and placed in a cotainer for disposal.
Use caution and industry recognized protective equipment/clothing when working with molten adhesive. Turn off heated
application tool when not in use.
Store in cool area in product container away from sources of ignition or flame.
Wear safety goggles or face shield.
General purpose cotton or leather gloves may be worn durring application to prevent burns.
Should not be required. Consult an industrial hygenist if user notice respiratory problems.
Local exhaust ventilation should be utilized to control vapors / substances below exposure limits.
Keep personnel removed from and upwind of fire. Wear full body protective clothing and MSHA/NIOSH approved self-
contained breathing apparatus. All components have a flash point greater than 200C.
Carbon dioxide (CO2), dry chemical, foam. Firefighters should wear self-contained breathing apparatus (SCBA) and full
protective equipment.
Protective work clothing which covers skin and prevents exposures.
US-SDS 2 of 4 5/30/2015
CAS#
ACGIH-TLV OSHA-PEL
NA
NA NA
Section 9: Physical and Chemical Properties
State: Solid Melting Point: 60-90C.
Freezing
Point:
Not avail
Color:
AMBER/
CLEAR
Boiling
Point/Range:
350-400F
(159-170C)
pH Not avail
Sp Grav: 0.9 Odor:
aromatic,
solvent
Water
Solubility:
Insoluble
Evaporation rate: Flash Point: >250C.
Part. Coeff (n-
octanol/water
Not avail
Upper Flam Limits: Not avail
Lower Flam
Limits:
Not avail
Vapor
Pressure:
-
VOC Content
(lbs/gal):
Viscosity:
Autoignition
Temp:
250 C
Section 10: Stability and Reactivity
General:
Incompatible
materials:
Decomposition
products:
Section 11: Toxicological Information
General Information:
Toxicological
Information
(product):
Likely Routes of
Exposure:
LD50 Oral LD50 Dermal LC50 Inh Irritancy:
NA NA NA NA
Carcinogenicity or
mutagenicity:
Sensitization:
No decomposition products known. Toxic substances may be released in the event of a fire.
This product s stable under nornmal conditions of temperature or pressure. Hazardous polymerization will not occur.
Incompatible with strong oxidizers. May produce hazardous quantities carbon monoxide and smoke when burned.
Strong oxidizing agents, strong acids.
None
Inhalation of vapors.
Toxicological Information (contained substances)
None
Hazardous substance (name)
Product is not expected to be a sensitizer.
No toxicological data is available for this product. Product components are non-toxic as defined by the Federal Hazardous
Substances Act, 16 CFR 1500.3.
Substances with Exposure Limits
None
May cause slight irritation to the respiratory system while inhaling the dust or smoke.
US-SDS 3 of 4 5/30/2015
Section 12: Ecological Information
General information:
Aquatic toxicity:
Degradation / Mobility info:
Bioaccumulative potential:
Section 13: Disposal Information
Product disposal:
Container disposal:
Other considerations:
Section 14: Transport Information
DOT:
IMO/IMDG:
IATA:
OTHER:
Comments:
Section 15: Regulatory Information
TSCA:
CERCLA RQ:
SARA 311/312:
SARA 313
California Prop 65
Substances:
Canadian DSL:
WHMIS:
Section 16: Other Information
SDS Author:
Version Date:
1/10/2015
Ethylene-Vinyl Acetate Copolymer (CAS#24937-78-8)
No specific data available.
No further information.
None
None
None
None
None
Not Regulated
Not Regulated
Not Regulated
None
No specific data available.
Dispose of product in accordance with local, regional, and national regulations. Consult with waste contractor.
Dispose of product in accordance with local, regional, and national regulations. Consult with waste contractor.
Not Regulated
Reasonable care has been taken in the preparation of this document and contained information, but the supplier gives no warranty or
merchantability of fitness for a particular purpose. Information in this form is furnished solely for the purpose of Local, Federal and State
compliance. Persons using this product shall make their own determination as to the applicability of the Hazard Communication Standard and any
other requirement to their us of this product. Halex Corporation believes that the statements, technical information and recommendations set forth
herein are reliable and accurate at the time of publication.
Tony A. Dominguez
None
Difficult to biodegrade. It can be recycled with appropriate technologies.
None
US-SDS 4 of 4 5/30/2015
