Unified MAPEI MSDS 556101

2015-10-30

: Pdf 556101 556101 Forms

Open the PDF directly: View PDF .
Page Count: 2

Calculated VOC (See below.) 0 g/L

II - PHYSICAL CHARACTERISTICS

Boiling Point >212°F (>100°C)

Vapor Pressure (mmHg) 1,0

Vapor Density (AIR=1) 1,10 - 1,20

Specific Gravity (H20=1) 1,00 - 1,30

Melting/Freezing Point (F) N/E

Evaporation Rate (Butyl Acetate=1) Same as water.

Solubility in water Soluble

Appearance and Odor Beige paste. Slight odor of latex.

(VOC per CA South Coast Air Quality Management District, Rule 1168)

pH (paste/liquid) 8,0 - 10,0

MANUFACTURER:

MAPEI CORPORATION

1144 East Newport Center Drive

MSDS PREPARED BY:

Regulatory Affairs Department - MAPEI North America

I - GENERAL INFORMATION

Deerfield Beach, FL 33442

USA and Puerto Rico

MAPEI INC.

2900 Francis-Hughes Avenue

Laval, QC H7L 3J5

Canada

Ph: (954) 246-8888 Ph: (450) 662-1212

Not Regulated

IV - TRANSPORTATION

By GROUND - USA and Puerto Rico (DOT):

By AIR (IATA):

Not Regulated

By SEA (IMDG):

Not Regulated

By GROUND - Canada (TDG):

Hazardous Components

(specific chemical identity; common names): OSHA (PEL) ACGIH (TLV-

TWA) Other Limits Recommended % Percent

(Optional)

THIS PRODUCT CONTAINS NO HAZARDOUS INGREDIENTS AS DEFINED BY US OSHA HAZARD COMMUNICATION STANDARD - 29 CFR

1910.1200 OR SECTION 13 OF THE CANADIAN HAZARDOUS PRODUCTS ACT.

For California (Proposition 65): This product contains no chemicals reportable under Proposition 65.

(USA) - HMIS (Hazardous Materials Identification System) Rating: Health - 1 Fire - 0 Reactivity - 0 Protection - B

(Canada) - WHMIS (Workplace Hazardous Materials Information System) Classifications:

All ingredients are listed within or exempted from US TSCA and Canadian DSL.

Not regulated under WHMIS.

III - HAZARD ASSESSMENT

V - FIRE AND EXPLOSION HAZARD DATA

Flash Point: >212°F (>100°C) Lower Explosive Limit (%) - N/E Upper Explosive Limit (%) - N/E

Extinguishing Media:

Will not burn except under extreme temperatures. Water spray, carbon dioxide, dry chemical or foam.

Special Fire Fighting Procedures:

Wear standard fire fighting gear with self-contained breathing apparatus.

Unusual Fire and Explosion Hazards - Some decomposition products may be harmful.

IN THE EVENT OF A CHEMICAL EMERGENCY INVOLVING A SPILL, LEAK, FIRE, EXPLOSION, EXPOSURE OR ACCIDENT CONTACT THE

FOLLOWING NUMBERS:

EMERGENCY 24 HOUR NUMBER (USA) CHEMTREC 1-800-424-9300 (Canada) CANUTEC 1-613-996-6666

CONSUMER STATEMENT:

CAUTION EYE IRRITANT. NON-TOXIC.-

Stability: Stable Conditions to Avoid: None known.

VI - REACTIVITY DATA

WORK AND HYGIENE PRACTICE:

Remove contaminated clothing immediately. Wash hands, after each use and before eating, drinking, or using toiletries. Minimize contact of product

on skins.

"*" = chronic effect

________________________________________________________________________________________________________________________

REVISION DATE (YYYY/MM/DD): 2005/07/15

For most current MSDS, download document from: www.mapei.com

MAPEI® Material Safety Data Sheet (MSDS) - North America

Ultrabond ECO™ 575

Premium Cove Base Adhesive

Product Name:

Product Description:

Read complete MSDS prior to using product.

-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Page 2 of 7

Ultrabond ECO™ 575 Page 2 de 7

Páginas 2 de 7

English Version on pages 2 and 3.

Version Française à la pages 4 et 5.

La versión en Español en las páginas 6 y 7. MSDS

Incompatibility (Materials to Avoid): Strong oxidizing agents, strong acids, and strong bases.

Hazard Decomposition of By-products: Carbon monoxide, carbon dioxide, oxides of nitrogen, and other unidentified organic compounds.

Polymerization: Will Not Occur Conditions to Avoid: None known.

Inhalation? YES Skin? YES Ingestion? NO

Acute: No effects are suspected under normal professional use.

Chronic: None known.

NTP -NO IARC - NO OSHA - NO

VII - HEALTH HAZARD DATA

Routes of entry during normal usage:

Health Hazards:

Carcinogenicity:

Signs and Symptoms of Overexposure:

No effects are suspected under normal professional use.

Medical Conditions That Can Be Aggravated by Exposure:

Allergies, skin and respiratory disorders. Product sensitivity.

Eyes: Flush with cool water for 15 minutes while holding eyelid open. If irritation persists, seek medical attention immediately.

Skin: Avoid contact with skin. Remove contaminated clothing. Wash affected area thoroughly with soap and water. If irritation persists, seek

immediate medical attention.

Inhalation: Remove to fresh air if allowable concentrations of any of the hazardous ingredients are exceeded. If not breathing, trained personnel

should initiate artificial respirations and immediate medical attention should be obtained.

Ingestion: Do not induce vomiting. Do not give anything by mouth to an unconscious person. Seek medical attention immediately.

VIII - EMERGENCY AND FIRST AID PROCEDURE

Steps to be taken if Material is Leaked or Spilled:

Wear protective equipment. Contain by diking with inert absorbent materials and put into an approved waste container.

Waste Disposal Method: Dispose in accordance to local environmental regulation.

Precautions to be taken during Handling and Storage:

Keep container closed when not in use. Store at 60-95°F (15-35°C) and out of the sun. Use adequate ventilation to avoid breathing vapors when cover

is removed.

Other Precautions: Avoid prolonged skins contact.

IX - PRECAUTIONS FOR SAFE HANDLING AND USE

X - CONTROL MEASURES

Respiratory Protection:

If workplace exposure limit of product is exceeded, a NIOSH/MSHA approved air supplied respirator is required in absence of proper environmental

control. Engineering or administrative controls should be implemented to reduce exposure.

Local Exhaust - Use in WELL VENTILATED areas only. Mechanical - Use only intrinsically safe devices.

Special - N/A Other - N/A

Ventilation:

Protective Gloves: Impervious. (Nitrile, rubber, or better)

Eye Protection: Safety glasses or goggles as necessary to prevent eye contact.

Other Protective Equipment: As needed to minimize contact with skin.

________________________________________________________________________________________________________________________

_______________________________________________________________________________________________________________________

________________________________________________________________________________________________________________________

The information contained herein is based on data considered accurate. However, no warranty is expressed or implied regarding the accuracy of these

data or the results to be obtained from the use thereof. MAPEI assumes no responsibility for personal injury or property damage to vendees, users, or

third parties caused by the material. Such vendees or users assume all risks associated with the use of the material.

_______________________________________________________________________________________________________________________

N/A="Not Applicable" N/E="Not Established"

Page 3 of 7

Ultrabond ECO™ 575 Page 3 de 7

Páginas 3 de 7

English Version on pages 2 and 3.

Version Française à la pages 4 et 5.

La versión en Español en las páginas 6 y 7. MSDS

Unified MAPEI MSDS 556101

Navigation menu

Versions of this User Manual:

Views

Navigation