SS 2000 INSTALL Installation Directions

: Pdf 583235-Installationsheet 583235-InstallationSheet 009456 Batch5 unilog

Open the PDF directly: View PDF .
Page Count: 2

INSTALLATION OF SS-2000 SERIES STOPPER® STATION

All specifications and information shown were current as of publication, and are subject to change without notice. 1027IS MAY2011

Safety Technology International, Inc.

2306 Airport Road • Waterford, Michigan 48327-1209

Phone: 248-673-9898 • Fax: 248-673-1246

Toll Free: 800-888-4784 • E-mail: info@sti-usa.com

Web: www.sti-usa.com

Safety Technology International (Europe) Ltd.

Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch

Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999

Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only)

E-mail: info@sti-europe.com • Web: www.sti-europe.com

NOTE: TO PROVIDE ADEQUATE CLEARANCE FOR INSTALLATION,

MAY REQUIRE: SUB-102722 SPACER, OR RACO #660

W/1/2" K.O. AND RACO #653 EXTENSION RING.

ALSO RACO #696 MASONRY BOX.

P

3.25 in.

(82mm)

4.87 in.

(124mm)

1.62 in.

(41mm) 2.25 in.

(57mm)

*

#7 BUTT

PRODUCT DIMENSIONS

*SS-2**4 and LT1-UL NOTES: For access control installations, power for the LT-1UL Timer must be supplied by a power

source listed to UL294. When used for access control, this device shall be used as part of an access controlled egress door

system. It is up to the local AHJ to allow use of this device in place of an automatic sensor. For higher security installations,

lower time limits should be used. For SS-2**4 and LT1-UL the enclosed timer is to be used and installed per the enclosed

LT-1UL installation sheet. *SS-2**4 and LT1-UL maximum rating 30 VDC 3A.

REMARQUES POUR *SS-2**4 et LT1-UL: Pour les installations de contrôle d’accès, l’alimentation de la minuterie LT-1UL

doit être fournie par une source homologuée UL294. Lorsque cet appareil est utilisé aux fins de contrôle d’accès, il doit faire

partie d’un système de porte de sortie à accès contrôlé. Il incombe donc à l’AHJ local d’autoriser l’utilisation de cet appareil

au lieu d’un capteur automatique. Pour les installations de sécurité plus renforcée, des délais inférieurs doivent être utilisés.

Pour les modèles SS-2**4 et LT1-UL, la minuterie intégrée doit être installée et utilisée suivant la fiche d’installation LT-1UL

fournie. La cote maximale des modèles *SS-2** 4 et LT1-UL est de 30 VCC 3A. Electronic warranty form at www.sti-usa.com/wc14

NOTE:

#7 BUTTON TYPE

.

#9

#

#9

#

#7 BUTTON TYPE

.

#9

#

EXISTING STANDARD

SINGLE GANGBOX

HOUSING INDEXING SLOTS

BACKPLATE ASSEMBLY

(SEE REVERSE SIDE)

102722 SPACER RED, GREEN,

YELLOW, WHITE AND BLUE.

STI RECOMMENDS THE USE OF THIS

SPACER FOR SWITCH CLEARANCE

ON STANDARD SINGLE GANG BOXES.

ASSIGNED A 5VA FLAMMABILITY RATING.

SEE NOTE IN PRODUCT DIMENSION VIEW.

10274 OCTAGON SHELL

RED, GREEN, YELLOW, WHITE AND BLUE

10105 MOMENTARY BUTTON (#4)*KEYS

(2) PROVIDED

10271 STATION HOUSING

RED, GREEN, YELLOW,

WHITE AND BLUE

10100 PUSH/TURN

RESET BUTTON (#1)

10104 KEY BUTTON (#3)

KEY REQUIRED TO ACTIVATE - IN

ACTIVATE MODE KEY CAN BE REMOVED

19001 SCREW

(1) PROVIDED

STATION LABEL

KEYS

(2) PROVIDED

10102 KEY RESET SWITCH

OCTAGON KEY RESET BUTTON (#0)

RED, GREEN, YELLOW, WHITE

AND BLUE

02050

T

PUSH

PUSH

HERE

#7 BUTT

#7 BUTT

#9

#

STRIP 1/4 in. OF WIRE INSULATION

INSERT IN TERMINAL (AS SHOWN) THEN

USING A PHILLIPS SCREWDRIVER TURN

CLOCKWISE UNTIL TIGHT.

INSTALLATION OF SS-2000 SERIES STOPPER® STATION

All specifications and information shown were current as of publication, and are subject to change without notice. 1027IS MAY2011

Safety Technology International, Inc.

2306 Airport Road • Waterford, Michigan 48327-1209

Phone: 248-673-9898 • Fax: 248-673-1246

Toll Free: 800-888-4784 • E-mail: info@sti-usa.com

Web: www.sti-usa.com

Safety Technology International (Europe) Ltd.

Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch

Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999

Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only)

E-mail: info@sti-europe.com • Web: www.sti-europe.com

VIEW IN DIRECTION OF ARROW A

INSTALLATION OF ELECTRICAL

WIRE INTO TERMINAL BLOCK

VIEW IN DIRECTION OF ARROW A

INSTALLATION AND REMOVAL OF TERMINAL BLOCKS AND

TERMINAL BLOCK ASSEMBLY FROM BUTTON ASSEMBLY

#7 BUTT

#9

#

#9

#

#7 BUTT

#9

#

TERMINAL BLOCK 10196 NO (1) PROVIDED

10198 NC (1) PROVIDED

SEE VIEW IN DIRECTION OF ARROW

FOR CONTACT INDENTIFIER LOCATIONS

UP TO (3) TERMINALS MAY BE USED FOR EACH

STATION ASSEMBLY.

OUTGOING

INCOMING

19010 SCREWS #6-32 x 1

OUTLET BOX (2) PROVIDED.

SCREWS #6-32 x 1.50 WHEN

USING 102722 SPACER

(SEE REVERS SIDE).

19021 GROUND LUG

(1) PROVIDED

BUTTON LOCK NUT

10272 BACKPLATE

GREEN, YELLOW, WHITE AND BLUE

A

#7 BUTT

#7 BUTT

#9

#

NC

NO1

2

3

4

SEPARATION OF TERMINAL ASSEMBLY.

FROM BUTTON ASSEMBLY IS AS FOLLOWS:

GRASP TERMINAL HOUSING AND USING THUMB

APPLY PRESSURE DOWNWARD, REMOVE TERMINAL.

REMOVAL OF TERMINAL BLOCK

FROM TERMINAL HOUSING: INSERT

SMALL SCREWDRIVER (AS SHOWN)

AND PRY UPWARD, REMOVE TERMINAL.

#7 BUTT

#7 BUTT

#9

#

TERMINAL BLOCK

RELEASE LEVER

MUST FACE UPWARD

AS SHOWN FOR SWITCH

TO FUNCTION CORRECTLY.

ELECTRICAL TERMINAL BLOCK

UP TO 3 TERMINALS MAY BE USED

INSERT NOTCH, AS SHOWN

THEN ROTATE UPWARD

VOLTAGE

250 VDC

600 VAC

RATED AVERAGE CURRENT

1 AMP

3 AMP

ALL TERMINALS ACCEPT TWO 12 TO 18 (AWG)

NO — NORMALLY OPEN

NC — NORMALLY CLOSED

C — COMMON

TERMINAL BLOCK LEGEND

NOTE: SS-2XX4/LT CONTACTS ON FORM C TIMER RATED: 120 VAC, 3A

28 VDC, 3A