Installation Directions

2014-07-04

: Pdf 610872-Installationsheet 610872-InstallationSheet 078477 Batch5 unilog

Open the PDF directly: View PDF PDF.
Page Count: 2

DownloadInstallation Directions
Open PDF In BrowserView PDF
Y
R
A
IN

	

DI-220-47609-00A-X0

M
I
L
1x4 Combo Phone
E
and Data Module
PR

47609-4DP

Installation Instructions

Push-Lock
Pin

www.lev

iton.com

DESCRIPTION
The 1x4 Combo Phone and Data Module features
5 sets of 110 IDC punchdowns. Any set can be
used as the “input” set, bridging up to four lines of
telephone service to the other four sets. UTP cable
can be punched down on each of the four “output”
sets to distribute service to remote locations
throughout the house.

INSTALLATION

LEVITON
In From Demarcation

CAT5E
JACK 1

1x4 Combo Phone and Data
Module

To install, simply snap the 1x4 Combo Phone and
Data Module into the mounting bracket (Cat. No.
47612-SBK - sold separately) and align the PushLock Pins with the grid holes of the SMC. Module
may be mounted horizontally or vertically. With the
Push-Lock Pins in the “out” position, press the unit
into the grid in the desired location and secure by
pushing the Push-Lock Pins “in” (refer to Figure 1).

Phone/
Data
Module

110 IDC Wiring Termination:
Using an industry standard puchdown tool, wire
the 110 IDC connectors per the T568A wiring
configuration as shown below. The wall jack should
also comply with this configuration for both phone
and data wallplates.

SMC
Mounting
Bracket

NOTE: 	Blue = Line 1

(sold separately)

1

	
	
	

Orange = Line 2
Green = Line 3
Brown = Line 4

White / Blue
Blue
White / Orange
Orange
White / Green
Green
White / Brown
Brown
Route and terminate up to four Category 5 or
Category 5e cables from the wall jacks to the 4-Pair
110 IDC connectors liming the sides of the board
using an industry standard punchdown tool. Each
cable should be fully terminated (all four pairs) on
one of the 110 IDC connectors.

59-25 Little Neck Parkway.
Little Neck, N.Y. 11362-2591, USA
Tech Support: 800-824-3005
www.leviton.com

APPLICATION:
For data: Identify the cable you wish to activate
and connect one end of a Category 5 or 5e patch
cord into the corresponding module port and the
other end into an installed data switch or router.

Example: You have a computer and a printer in your home office, and want to access the printer from
computers in two bedrooms.
•	 Route cables to the two office jacks (for the office computer and printer) to corresponding 110 IDC connectors
for Ports 1 & 2.
•	 Route cables to the bedroom jacks (for the two bedroom computers) to corresponding 110 IDC connectors for
Ports 3 & 4.
•	 Install Category 5 or 5e patech cords from ports 1, 2, 3 and 4 on the module to ports on a data switc or router
(follow manufacturer’s instructions). The 3 computers and the printer will now be networked (a print server
may be required).

IMPORTANT INSTRUCTIONS

1.	Read and understand all instructions. Follow all warnings and instructions marked on the product.
2.	Do not use this product near water—e.g., near a tub, wash basin, kitchen sink or laundry tub, in a wet
basement, or near a swimming pool.
3.	Never push objects of any kind into this product through openings, as they may touch dangerous voltages.
4.	 SAVE THESE INSTRUCTIONS.

SAFETY INFORMATION

1.	Never install communications wiring or components during a lightning storm.
2.	Never install communications components in wet locations unless the components are designed specifically
for use in wet locations.
3.	Never touch uninsulated wires or terminals unless the wiring has been disconnected at the network
interface.
4.	Use caution when installing or modifying communications wiring or components.
5.	To prevent electrical shock, each opening must be filled with a module.
LIMITED 2 YEAR WARRANTY AND EXCLUSIONS
Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this
product at the time of its sale by Leviton is free of defects in materials and workmanship under normal
and proper use for two years from the purchase date. Leviton’s only obligation is to correct such defects
by repair or replacement, at its option, if within such two year period the product is returned prepaid,
with proof of purchase date, and a description of the problem to Leviton Manufacturing Co., Inc., Att:
Quality Assurance Department, 59-25 Little Neck Parkway, Little Neck, New York 11362-2591. This
warranty excludes and there is disclaimed liability for labor for removal of this product or reinstallation.
This warranty is void if this product is installed improperly or in an improper environment, overloaded,
misused, opened, abused, or altered in any manner, or is not used under normal operating conditions or
not in accordance with any labels or instructions. There are no other or implied warranties of any kind,
including merchantability and fitness for a particular purpose, but if any implied warranty is required by
the applicable jurisdiction, the duration of any such implied warranty, including merchantability and fitness
for a particular purpose, is limited to two years. Leviton is not liable for incidental, indirect, special, or
consequential damages, including without limitation, damage to, or loss of use of, any equipment,
lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided
herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise.

Y
R
A
IN

M
I
L

For Technical Assistance Call:
1-800-824-3005 (U.S.A. Only)
www.leviton.com

E
R
P
59-25 Little Neck Parkway.
Little Neck, N.Y. 11362-2591, USA
Tech Support: 800-824-3005
www.leviton.com

DI-220-47609-00A-X0



Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Create Date                     : 2006:09:15 17:24:30-04:00
Creator                         : Adobe InDesign CS2 (4.0.2)
Modify Date                     : 2012:11:16 14:02:49-08:00
XMP Toolkit                     : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26
Instance ID                     : uuid:941c4266-4b39-4af4-ba6c-45e0f977f3b2
Document ID                     : adobe:docid:indd:259f0c55-466e-11db-9d11-818eff9ac917
Rendition Class                 : proof:pdf
Derived From Instance ID        : 259f0c54-466e-11db-9d11-818eff9ac917
Derived From Document ID        : adobe:docid:indd:259f0c52-466e-11db-9d11-818eff9ac917
Manifest Link Form              : ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream, ReferenceStream
Manifest Placed X Resolution    : 72.00, 72.00, 72.00, 72.00, 72.00, 72.00
Manifest Placed Y Resolution    : 72.00, 72.00, 72.00, 72.00, 72.00, 72.00
Manifest Placed Resolution Unit : Inches, Inches, Inches, Inches, Inches, Inches
Manifest Reference Instance ID  : uuid:F8C48AAC463611DB95DED83F9D6C1DFC, uuid:04731ec6-faea-11da-bf2c-003065c9a8dc, uuid:04731ec6-faea-11da-bf2c-003065c9a8dc, uuid:E509DF09458211DBBBDBC93493C0318F, uuid:04731ec6-faea-11da-bf2c-003065c9a8dc, uuid:3E582A0B466E11DB95DED83F9D6C1DFC
Manifest Reference Document ID  : uuid:3C04A5CE459911DBBBDBC93493C0318F, uuid:073A35CFFC5A11DA86DFFB761DBA4EAF, uuid:073A35CFFC5A11DA86DFFB761DBA4EAF, uuid:E509DF08458211DBBBDBC93493C0318F, uuid:073A35CFFC5A11DA86DFFB761DBA4EAF, uuid:3E582A0A466E11DB95DED83F9D6C1DFC
Metadata Date                   : 2012:11:16 14:02:49-08:00
Creator Tool                    : Adobe InDesign CS2 (4.0.2)
Thumbnail Format                : JPEG
Thumbnail Width                 : 256
Thumbnail Height                : 256
Thumbnail Image                 : (Binary data 9401 bytes, use -b option to extract)
Format                          : application/pdf
Producer                        : Adobe PDF Library 7.0
Trapped                         : False
Page Count                      : 2
EXIF Metadata provided by EXIF.tools

Navigation menu