Installation Directions

: Pdf 610872-Installationsheet 610872-InstallationSheet 078477 Batch5 unilog

Open the PDF directly: View PDF .
Page Count: 2

LEVITON

In From Demarcation

www.leviton.com

CAT5E

JACK 1

PRELIMINARY

Installation Instructions

59-25 Little Neck Parkway.

Little Neck, N.Y. 11362-2591, USA

Tech Support: 800-824-3005

www.leviton.com

SMC

Mounting

Bracket

(sold separately)

Push-Lock

Pin

White / Green

Green

White / Orange

Orange

Blue

White / Blue

White / Brown

Brown

1

1x4 Combo Phone

and Data Module

DI-220-47609-00A-X0

1x4 Combo Phone and Data

Module

DESCRIPTION

The 1x4 Combo Phone and Data Module features

5 sets of 110 IDC punchdowns. Any set can be

used as the “input” set, bridging up to four lines of

telephone service to the other four sets. UTP cable

can be punched down on each of the four “output”

sets to distribute service to remote locations

throughout the house.

INSTALLATION

To install, simply snap the 1x4 Combo Phone and

Data Module into the mounting bracket

(Cat. No.

47612-SBK - sold separately)

and align the Push-

Lock Pins with the grid holes of the SMC. Module

may be mounted horizontally or vertically. With the

Push-Lock Pins in the “out” position, press the unit

into the grid in the desired location and secure by

pushing the Push-Lock Pins “in” (refer to Figure 1).

110 IDC Wiring Termination:

Using an industry standard puchdown tool, wire

the 110 IDC connectors per the T568A wiring

configuration as shown below. The wall jack should

also comply with this configuration for both phone

and data wallplates.

NOTE:

Blue = Line 1

Orange = Line 2

Green = Line 3

Brown = Line 4

47609-4DP

Phone/

Data

Module

Route and terminate up to four Category 5 or

Category 5e cables from the wall jacks to the 4-Pair

110 IDC connectors liming the sides of the board

using an industry standard punchdown tool. Each

cable should be fully terminated (all four pairs) on

one of the 110 IDC connectors.

APPLICATION:

For data:

Identify the cable you wish to activate

and connect one end of a Category 5 or 5e patch

cord into the corresponding module port and the

other end into an installed data switch or router.

PRELIMINARY

IMPORTANT INSTRUCTIONS

1. Read and understand all instructions. Follow all warnings and instructions marked on the product.

2. Do not use this product near water—e.g., near a tub, wash basin, kitchen sink or laundry tub, in a wet

basement, or near a swimming pool.

3. Never push objects of any kind into this product through openings, as they may touch dangerous voltages.

4. SAVE THESE INSTRUCTIONS.

SAFETY INFORMATION

1. Never install communications wiring or components during a lightning storm.

2. Never install communications components in wet locations unless the components are designed specifically

for use in wet locations.

3. Never touch uninsulated wires or terminals unless the wiring has been disconnected at the network

interface.

4. Use caution when installing or modifying communications wiring or components.

5. To prevent electrical shock, each opening must be filled with a module.

59-25 Little Neck Parkway.

Little Neck, N.Y. 11362-2591, USA

Tech Support: 800-824-3005

www.leviton.com DI-220-47609-00A-X0

LIMITED 2 YEAR WARRANTY AND EXCLUSIONS

Leviton warrants to the original consumer purchaser and not for the benefit of anyone else that this

product at the time of its sale by Leviton is free of defects in materials and workmanship under normal

and proper use for two years from the purchase date. Leviton’s only obligation is to correct such defects

by repair or replacement, at its option, if within such two year period the product is returned prepaid,

with proof of purchase date, and a description of the problem to Leviton Manufacturing Co., Inc., Att:

Quality Assurance Department, 59-25 Little Neck Parkway, Little Neck, New York 11362-2591. This

warranty excludes and there is disclaimed liability for labor for removal of this product or reinstallation.

This warranty is void if this product is installed improperly or in an improper environment, overloaded,

misused, opened, abused, or altered in any manner, or is not used under normal operating conditions or

not in accordance with any labels or instructions. There are no other or implied warranties of any kind,

including merchantability and fitness for a particular purpose, but if any implied warranty is required by

the applicable jurisdiction, the duration of any such implied warranty, including merchantability and fitness

for a particular purpose, is limited to two years. Leviton is not liable for incidental, indirect, special, or

consequential damages, including without limitation, damage to, or loss of use of, any equipment,

lost sales or profits or delay or failure to perform this warranty obligation. The remedies provided

herein are the exclusive remedies under this warranty, whether based on contract, tort or otherwise.

For Technical Assistance Call:

1-800-824-3005 (U.S.A. Only)

www.leviton.com

EXAMPLE: You have a computer and a printer in your home office, and want to access the printer from

computers in two bedrooms.

• Route cables to the two office jacks (for the office computer and printer) to corresponding 110 IDC connectors

for Ports 1 & 2.

• Route cables to the bedroom jacks (for the two bedroom computers) to corresponding 110 IDC connectors for

Ports 3 & 4.

• Install Category 5 or 5e patech cords from ports 1, 2, 3 and 4 on the module to ports on a data switc or router

(follow manufacturer’s instructions). The 3 computers and the printer will now be networked (a print server

may be required).