D Settlement User Manual DSettlement
User Manual: Pdf DSettlement-Manual
Open the PDF directly: View PDF
Page Count: 312 [warning: Documents this large are best viewed by clicking the View PDF Link!]
- 1 General Information
- 2 Getting Started
- 3 General
- 4 Input
- 5 Calculations
- 6 View Results
- 6.1 Report Selection
- 6.2 Report
- 6.3 Stresses in Geometry
- 6.4 Dissipations
- 6.5 Time-History
- 6.6 Depth-History
- 6.7 Residual Settlement
- 6.8 Settled Geometry
- 6.9 Write Settled Geometry
- 6.10 Write D-Geo Stability Input
- 6.11 Time-History (Reliability)
- 6.12 Influencing Factors (Reliability)
- 6.13 Residual Settlements (Reliability)
- 7 Graphical Geometry Input
- 8 Tutorial 1: Building site preparation
- 8.1 Introduction
- 8.2 Project
- 8.3 Geometry
- 8.4 Soil types and properties
- 8.5 Layers
- 8.6 Loads
- 8.7 Verticals
- 8.8 Calculation
- 8.9 Results basic analysis (Tutorial-1a)
- 8.10 Influence of submerging (Tutorial-1b)
- 8.11 Comparison of consolidation models (Tutorial-1c and 1d)
- 8.12 Influence of initial overconsolidation
- 9 Tutorial 2: Embankment design with vertical drains
- 9.1 Introduction
- 9.2 Project
- 9.3 Initial embankment design (Tutorial-2a)
- 9.4 Acceleration of the consolidation process by means of vertical drains (Tutorial-2b)
- 9.5 Staged loading (Tutorial-2c)
- 9.6 Temporary pre-loading by soil raise (Tutorial-2d)
- 9.7 Additional enforced dewatering (Tutorial-2e)
- 9.8 Horizontal Displacements (Tutorial-2f)
- 9.9 Bandwidth Determination (Tutorial-2g)
- 9.10 Conclusion
- 10 Tutorial 3: Settlement plate fit
- 11 Tutorial 4: Ground improvement
- 12 Tutorial 5: Enforced dewatering by sand screens (IFCO)
- 13 Loads
- 14 Distribution of stress by loading
- 15 Pore pressure
- 16 Soil and strain models
- 17 Determining soil parameters
- 18 Special Calculations
- 19 Benchmarks
- Bibliography