Service Flash DW070.qxp Electrolux Dishwashers FDB1050 And FDB1250

: Pdf Electrolux Dishwashers Fdb1050 And Fdb1250 Electrolux_Dishwashers_FDB1050 and FDB1250 Electrolux

Open the PDF directly: View PDF .
Page Count: 1

Control board malfunction.

To determine if the control board is malfunctioning, complete the rotary switch test as follows:

1. Power Dishwasher OFF then back ON ( the Washing, Drying and Clean LEDs will flash

ON and OFF).

2. Press the Heat Dry, Delay Start and Start/Cancel keys at the same time until all 7 LEDs

are flashing ON and OFF.

3. Open the door and all 7 LEDs will stay ON, but will stop flashing.

4. Shut the door and all 7 LEDs will go out.

5. Press the Start/Cancel key ( depending on the position of the Rotary Switch, a specific LED

will come on.)

6. Rotary Switch position and corresponding LED indicators:

Normal Wash LED above the Heat Dry button

Pots and Pans LED under the 2

Light Wash LED under the 4

Upper Rack Washing LED

Rinse Only Clean LED

With each position of the Rotary Switch, push and pull the knob. If the led stays ON without

flashing, go to the next position. If pushing and pulling the knob causes an LED to go out,

replace the control.

FDB1050 and FDB1250

PROBLEM

SOLUTION

MODEL/SERIAL #

SERVICE FLASH

DW070

Diagnostics for Control Board

Electrolux Service Flash DW070 08.30.07