TM8260 Installation And Programming Guide TM8000/TM8260/MMA 00041 02 MMA

• Contents
• Preface
  • Scope of Manual
  • Associated Documentation
  • Document Conventions
• Safety Warnings
  • RF Exposure Hazard
  • Safe Radio Mounting
  • Interference with Vehicular Electronics
  • Preparation when Drilling Holes
  • Vehicles Powered by Liquefied Petroleum Gas
  • Radio Installation in Gas or Fuel tankers
  • Nonstandard Radio Installations
  • Negative Earth Supply
• 1 Preparing the Installation
  • 1.1 Regulations
  • 1.2 Installation Tools
  • 1.3 Unpacking and Checking the Equipment for Completeness
  • 1.4 Installation Considerations
  • 1.5 Installation Overview
• 2 Installing a Dual-Radio System
  • 2.1 Installing a Basic Dual-Radio System
    • 2.1.1 Downloading MAC Addresses
    • 2.1.2 Removing Link J4
    • 2.1.3 Assembling the Body Interfaces
    • 2.1.4 Assembling the Control Head Interface
    • 2.1.5 Mounting the Control Head and Radio Bodies
    • 2.1.6 Installing the Antennas
    • 2.1.7 Installing the Control Head Remote and Radio Connecting Cables
    • 2.1.8 Connecting the Power Cables to a Power Source
  • 2.2 Advanced Dual-Radio Installation
    • 2.2.1 Connecting Remote Speakers
    • 2.2.2 Connecting the Cross-band Linking, GPS, and External Interface Cable
  • 2.3 Checking the Installation
• 3 Programming the Radio System
  • 3.1 Programming a Dual-Radio System
  • 3.2 Recommended Dual-Radio Settings
  • 3.3 Upgrading Radio Firmware
  • 3.4 Calibrating the Radio System
  • 3.5 Troubleshooting
• 4 Quick reference
• Appendix A Cross-band Linking, GPS and External Interface Cable
  • A.1 Introduction
  • A.2 Cross-band Repeater Operation
    • A.2.1 Installation
    • A.2.2 Radio Programming
    • A.2.3 Operational Testing
  • A.3 Connecting to a GPS Device
    • A.3.1 Installation
    • A.3.2 Radio Programming
  • A.4 Connecting to the Ignition Signal
    • A.4.1 Installation
    • A.4.2 Radio Programming
  • A.5 Connecting to an External Alert Device
    • A.5.1 Installation
    • A.5.2 Radio Programming
  • A.6 Connecting to other External Devices or Signals
  • A.7 Interface Specification
• Glossary
• Tait General Software Licence Agreement