Instructions

User Manual: Pdf

Open the PDF directly: View PDF PDF.
Page Count: 7

Scroll down to view the document on your mobile browser.
Mounting the Mk7/Leapfrog Creatr spring loaded idlerThis instruction shows you how to remove the existing extruder from your Leapfrog Creatr and replace it with the spring loaded design.Note that changing the design of the Creatr my void your warranty.No original parts are modified for this upgrade so you can always restore the Creatr to its original state when it needs to be shipped to Leapfrog for service.Tools needed•2.5mm Allen key•3mm Allen key•3 or 3.2 mm drill bit•4mm drill bit•M4 threading bit•pliers, small flat file, Xacto nice to your likingParts needed•Set 3D printed parts•approx. 12 3mm steel washers•2 3mm nylon washers•2 M3 x 25mm screws•1 M4 x 15mm screw•1 M4 nut (a thin nut, approx 2mm thick)•1 Spring (25mm OD 10mm, available from reprapworld.com)Note that the M4 nut needs to be a thin nut of max. 2mm. These are not widely available, you can also take a standard nut and file it down to the needed size.Preparing the printed partsMake sure surfaces are smooth, drill all holes up to 3 or 3.2mm.

Navigation menu