Pelican Accessories SW-2 Game Console Transceiver for Wireless Controller User Manual

Pelican Accessories Game Console Transceiver for Wireless Controller Users Manual

Users Manual

PRODUCT OVERVIEW:ShockWave Wireless Controller uses advance technology which gives you the ability to playwithout the limitations of a typical corded controller, hence there are a few switches and LED(lights) not found on your basic PlayStation® 2 Controller.Channel SwitchThis switch selects the broadcast channel of the radio frequency. There are four positions;1,2,3 and 4. There is a corresponding Channel Switch on the receiver.Rumble ON/OFF Button:The rumble feature automatically turns on when the ShockWave is powered On. To turn Offthe Rumble feature, press the Rumble button. Press the button again to turn the feature back On. The motors will rumble to signify when the Rumble featured has been turned On.Power ButtonThis button turns your ShockWave wireless controller on. Press button to turn on.Signal LED (Green, Receiver and Controller):When on or flickering data is being transmitted between Controller and Receiver.Mode LED (Red, Controller)The Mode LED is Off for Digital Mode, On for Analog Mode, if the LED flashes, press the analog button again to enter a mode.Analog ButtonPress the analog button to cycle through modes. To turn off the controller press and hold the analog button until the two LEDs flicker together then release and the controller will poweroff.INSTRUCTIONS:1. Insert Batteries:Remove the battery lid and place the four AAA batteries (included) into the ShockWave Wireless Controller. Make sure they are inserted as shown in the battery compartment. Thebatteries included are not long life.2. Plug in the Receiver:With the PlayStation® 2 turned off, plug the receiver into controller port one (far left port).3. Select a Channel on the Controller:You may select any channel you desire 1,2,3, or 4.4. Select a Channel on the Receiver:This must match the channel selected on the Controller.Note:If using more than one controller you must use different channel settings, i.e., the firstcontroller and receiver are set to Channel 1, the second controller and receiver are set to channel 2. The channel position selected on the WaveStation controller and Receiver have no relation to the PlayStation® 2 controller ports.5. Turn on the Controller:Press the Power button to turn ShockWave On, the signal LED will light.Note:If you wish to extend battery life press the Rumble Off button. This will turn off the rumble effect in game play resulting in a doubling of your battery life. To turn the rumbleback on, press the rumble button again. The motor will vibrate indicating the rumble feature has been turned on.6. Turn off the controller:Press and hold the analog button until the two LEDs flicker together. Release the button and the controller will turn off.OTHER FEATURES:Multiple Players:You may play with up to four ShockWave Wireless controllers with the use of a MultiTap. Check to see that the channel switches are set as outlined above.Power Save Mode:When not in use the ShockWave controller automatically goes into a sleep mode to conservebatteries. A touch of any button puts the controller back into play mode.Note: Turn off the controller when not in use to extend your battery life.Instruction for Operation:LIMITED WARRANTYPelican Accessories warrants to the original consumer purchaser thatthe product will be free from defects in materials and / or workmanshipfor a period of 120 days from the date of purchase. If a defect coveredby this warranty occurs during this period, Pelican Accessories at itsoption will repair or replace, at no charge, any part that Pelican Accessoriesdetermines to be defective.To obtain warranty service during the warranty period, send the defectiveproduct postage pre-paid, with a money order for $4.00 to cover thereturn postage and handling, along with proof of purchase and the dateof purchase to:PELICAN ACCESSORIES1840 East 27th StreetVernon, CA 90058This warranty shall not apply if the product has been damaged by abuse,misuses, negligence, accident, modification, tampering or by any othercauses unrelated to defective materials and / or workmanship.Repair or replacement as provided under this warranty is PelicanAccessories' exclusive prerogative. ANY APPLICABLE IMPLIEDWARRANTIES, INCLUDING WARRANTIES OR MERCHANTABILITYAND FITNESS FOR A PARTICULAR PURPOSE ARE HERBY LIMITEDTO 120 DAYS FROM THE DATE OF PURCHASE AN ARE SUBJECTTO THE CONDITIONS SET FORTH IN THIS LIMITED WARRANTY. INNO EVENT SHALL PELICAN ACCESSORIES OR INCIDENTALDAMAGES RESULT FROM THE BREACH OF ANY EXPRESS ORIMPLIED WARRANTIES. This warranty gives you specific legal rights,and you may also have other legal rights,Which vary from state to state.Instruction for Operation:PL-651Our products are developed, tested, and approved by gamers forgamers. Pelican’s Gamer’s Guarantee states: If you are not 100%satisfied with your new ShockWave Wireless Controller we willreplace it or replace it with an equal valued item.For technical questions please visithttp://www.pelicanacc.comor call us directly at 1-800-331-3844Gamer’s GuaranteePelican and its logo are registered trademarks.Sony is a registered trademark of Sony Corp.PlayStation® 2 is registered trademarks ofSony Computer Entertainment Inc.This product is not designed, manufactured, sponsoredor endorsed by Sony Computer Entertainment Inc.ANALOGSELECT STARTPOWERRUMBLE1 2 3 4CHANNELCHANNEL1 2 3 4Changes or modifications not expressly approved by the manufacture could void theuser's authority to operate the equipment. This device complies with Part 15 of theFCC Rules. Operation is subject to the following two conditions; (1) this device maynot cause harmful interference, and (2) this device must accept any interferencereceived, including interference that may cause undesired operation.ShockWave ControllerShockWave ReceiverPower ButtonL1 / L2Rumble ButtonDirection ButtonsSelect ButtonsAnalog StickChannelR1 / R2Analog ButtonStart ButtonFunctionButtonsChannelSignal LEDSignal LEDMode LED*WARNING*Please verify that all the bateries are inserted correctly. If they are put in wrong, it maycause personal injury as well as damage to your ShockWave Wireless Controller.

Navigation menu