Philips Lighting North America LCN7330P Starsense SC Controller User Manual 2 of 2
Philips Lighting North America Corporation Starsense SC Controller 2 of 2
Contents
- 1. User manual 1 of 2
- 2. User manual 2 of 2
User manual 2 of 2
Date: December 23,2014
UL LLC.
333 Pfingsten Road
Northbrook, IL 60062
PHILIPS
Philips Lighting Electronics N.A.
10275 West Higgins Road
Rosemont, lL 60018
To whom it may concern:
In regard to our StarSense LCN7330P (FCC ID: VBO-LCN7330P and IC ID: I35Y-LCN7330P) Segment Control
node, this component is not offered for sale by itself, but only as part of the LFC73l0 Segment Controller cabinet.
As such, there is no user/installation manual for this individual component; it is only included and described as a
part of the larger assembly. The documents provided are the only documents that describe this product.
The statements below will be added to the revision of the manual. These statements will be in English language in
the EN manual and French in the FR manual:
In regard to the wording for the 20 cm separation requirement, the following statement will be added:
To comply with FCC/IC kF exposure limits for general population / uncontrolled exposure, the antenna(s)
usedfor this transmitter must be installed to provide a separation distance ofat least 20 cmfrom all persons and
must not be co-located or operating in conjunctionwith any other antenna or transmitter.
In regard to the wording required by FCC part 15.105 for a class A device the following statement will be added:
This equipment has been tested andfound to comply with the limits for a Class A digital device, pursuant to part l5
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can rqdiate radio
frequency energ/ and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residentiql area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
In regard to RSS-Gen, Section 8.3 the following will be added to the user manual:
This radio transmitter, l3SY-LCN7330P, has been approved by Industry Cqnada to operatewith the antennq types
listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. The only
antenna approvedfor use with this device is the antenna shown in the antenna exhibit (SmartDisk Antenno 707|XX
with cable not exciding 0.5 m and mqximum gain of 3.lSdBi).
Yours Sincerely,
Sr. Test Development Test Engineer
Philips Lighting Electronics N.A.
Tel: 800.322.2086
Fax: 888.423.1882
www. phi lips.com/advance