Philips Lighting North America SSDB1S Wireless 902MHz-928MHz Module User Manual 443529060901 rev F

Philips Lighting North America Corporation Wireless 902MHz-928MHz Module 443529060901 rev F

User Manual

Starsense NEMA Dim Intellivolt OLC LLC7320Installation Instructions4435 290 60901 REV. FWiring/Installation DiagramAttach a copy of barcodeto luminaire interior5IP>=43LLC7320Output loadThe OLC shall be able to operate an electronic ballast loadwith 4A rating at 120VAC and 2.5A rating at 277VAC.43INTERNALBALLAST/DRIVERWITH DIMMINGCONTROLGRAYWHTBLACKHNPhotocontrol base **Photocontrol base is not supplied with StarsenseLight Sensor mustpoint NORTHVIOLETBLACKWHTREDVLTGRYWHTBLK2000981379400000981379400LLC7320 913701261202Starsense WirelessLine V:Line Freq:Temp Range:Tc:Pload:120-277V50-60Hz-30...+60°C65°C480VAMade in USA0682NLL2PFTYYWWD+D-1Do notremovebarcodefromStarsenseØ86.0129.1000981379400CAUTION: Radio Frequency Radiation ExposureThis equipment complies with FCC radiation exposure limits set forth for uncontrolled equipment and meets the FCC radio frequency (RF)Exposure Guidelines in Supplement C to OET65. This equipment has very low levels of RF energy that it deemed to comply without maximumpermissive exposure evaluation (MPE). But it is desirable that it should be installed and operated with at least 20cm and more between theradiator and person's body (excluding extremities: hands, wrists, feet and ankles). Co-location : This transmitter must not be co-located oroperated in conjunction with any other antenna or transmitter.
Philips Lighting Electronics N.A.10275 West Higgins RoadRosemont, IL 60018Tel: 1-800-322-2086 Fax: 888-423-1882Customer Support/Technical Service:800-372-3331www.philips.com/starsense-na©2014 Philips Lighting Electronics N.A.A Division of Philips Electronics North America Corporation.All rights reserved.Published and printed in USAForm No. PA-7540-A 5/14This device complies with part 15 of the FCC rules for the United States and Industry Canada (IC) license-exempt RSS standard(s).Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must acceptany interference received, including interference that may cause undesired operation. Any changes or modifications not expresslyapproved by Philips could void the user's authority to operate this equipment.This product is intended for commercial use only.

Navigation menu