Philips Installation Guide Ced230 55 Qsg Eng
Guía de configuración rápida ced230_55_qsg_eng ¿Que tipo de tarjetas SD soporta mi sistema Philips? | Philips
Guía de configuración rápida ced230_55_qsg_aen ¿Que tipo de tarjetas SD soporta mi sistema Philips? | Philips
User Manual: Philips Installation Guide
Open the PDF directly: View PDF 
.
Page Count: 2
| Download | |
| Open PDF In Browser | View PDF |
Installation Guide CED230/55 m Installation guide 2 RR FR 1 3 10 9 5 RL FL + - 11 2 7 1 3 Register your product 4 + - 12 8 6 n 4 5 + - - + and get support at www.philips.com/welcome CED229 EN User manual 1 Connect These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer. a㻌㻌Illumination switch b To the +12V car battery which is energized at all time c Motor/electric antenna relay control lead. Amplifier relay control lead d Ground e Ignition key +12V DC when ON/ACC f Antenna 2 g h i j k l m n o Subwoofer Out Aux-In Parking switch cable Reverse driving cable Video-In Camera-In Video-out 1 and 2 Rear line-out Front line-out Mount Caution 183mm • This unit is designed for negative ground (earth) 12 V DC operation only. • Always install this unit in the car dashboard. Other locations can be dangerous as the rear of the unit heats up during use. • To avoid short-circuit: before you connect, ensure that the ignition is off. • Ensure that you connect the yellow and red power supply leads after all other leads are connected. • Ensure that all loose leads are insulated with electrical tape. • Ensure that the leads do not get caught under screws orin parts that will move (e.g. seat rail). • Ensure that all ground (earth) leads are run to a common ground (earth) point. • Use only the supplied mounting hardware for a safe and secure installation. • Improper fuses can cause damage or fire. When you need to change the fuse, consult a professional. 53.5mm Note on the power supply lead (yellow) • When you connect other devices to this apparatus, ensure that the rating of the car circuit is higher than the total fuse value of all the connected devices. Notes on speaker connection • Never connect speaker wires to the metal body or chassis of the car. • Never connect speaker wires with stripes to one another. Caution • Make sure that all bare wires are insulated with electrical tape. Note Note • For proper operation of the DVD player, the chassis must be mounted within 20 degree horizontal. Ensure that the unit is mounted within this limitation. • As different cars have different requirements, you might need to connect CED229 differently from the user manual’s instructions. In that case, consult a professional mechanic to connect. Caution Connect parking brake cable and reverse driving cable to a rear view backup camera • Keep the connection of the car battery if there is an on-board drive or navigation computer. Otherwise, the computer may lost its memory. • To avoid short circuit, ensure the bare wires do not touch each other and disconnect the negative terminal of the car battery. Note • Check your local driving regulations on whether it is legally required to install the rear view backup camera. These connections require a professional mechanic to install. This car audio video system allows you to connect to the rear view backup camera. You can view the things that happens behind your car in the display, especially you are driving a big vehicle. This helps protecting your bumper and anything it might contact. Installation Guide_BR-PT and AR-ES_110919.indd 1 CED230_55_QSG_EN.indd 1 9/19/2011 4:43:59 PM 6/14/2012 10:48:49 AM Quick start guide CED230/55 3 Quick start guide Register your product and get support at www.philips.com/welcome CED229 EN User manual Mute volume: Press OK/MUTE on the unit or of the remote control to mute the sound. 4 Caution • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteriesin fire. • Risk of decreased battery life! Never mix different brands or types of batteries. • Risk of product damage! When the remote control is not used for long periods, remove the batteries. • Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/percholorate. Insert USB device: 1. Slide down the USB socket cover. 2. Then, insert the USB device into the USB socket. CR2025 3V CR20 25 3V CR2025 1 5 Insert SD/SDHC card or CD: 1. Press to open the front panel. 2. Insert the SD/SDHC card into the card slot, or CD into the disc slot. 3. Flip and close the front panel. Turn on: Press OK/MUTE to turn on. Turn off: Press and hold the same button for 3 seconds to turn off. 2 All rights reserved. www.philips.com Specification are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners. © 2012 Koniniklijke Philips Electronics N.V. Adjust volume: Turn the control knob of the unit or press + or - of the remote control. QSG_BR-PT and AR-ES_110919.indd 1 CED230_55_QSG_EN.indd 2 9/19/2011 4:49:47 PM 6/14/2012 10:48:51 AM
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Create Date : 2012:06:14 10:48:47+08:00 Creator : Adobe InDesign CS5.5 (7.5) Modify Date : 2012:06:14 10:49:18+08:00 Tagged PDF : Yes XMP Toolkit : Adobe XMP Core 5.2-c001 63.139439, 2010/09/27-13:37:26 Metadata Date : 2012:06:14 10:49:18+08:00 Creator Tool : Adobe InDesign CS5.5 (7.5) Page Image Page Number : 1, 2 Page Image Format : JPEG, JPEG Page Image Width : 256, 256 Page Image Height : 256, 256 Page Image : (Binary data 8878 bytes, use -b option to extract), (Binary data 9260 bytes, use -b option to extract) Instance ID : uuid:17ff72c5-ebbd-4b12-94f1-f13e13338559 Document ID : xmp.did:68C0B26EC5B5E111B9F499482AAE5039 Original Document ID : xmp.did:74469C04479BE111A56DB2A9FE791F35 Rendition Class : proof:pdf History Action : created, saved, saved, saved, saved, saved, saved History Instance ID : xmp.iid:74469C04479BE111A56DB2A9FE791F35, xmp.iid:68EB2AAB489BE111A56DB2A9FE791F35, xmp.iid:69EB2AAB489BE111A56DB2A9FE791F35, xmp.iid:6CEB2AAB489BE111A56DB2A9FE791F35, xmp.iid:286D6DE7C2B5E111B9F499482AAE5039, xmp.iid:68C0B26EC5B5E111B9F499482AAE5039, xmp.iid:6BC0B26EC5B5E111B9F499482AAE5039 History When : 2012:05:11 17:05:37+08:00, 2012:05:11 17:07+08:00, 2012:05:11 17:07+08:00, 2012:05:11 17:08:50+08:00, 2012:06:14 10:05:36+08:00, 2012:06:14 10:05:36+08:00, 2012:06:14 10:30:28+08:00 History Software Agent : Adobe InDesign 7.5, Adobe InDesign 7.5, Adobe InDesign 7.5, Adobe InDesign 7.5, Adobe InDesign 7.5, Adobe InDesign 7.5, Adobe InDesign 7.5 History Changed : /;/metadata, /metadata, /;/metadata, /metadata, /;/metadata, /;/metadata Derived From Instance ID : xmp.iid:286D6DE7C2B5E111B9F499482AAE5039 Derived From Document ID : xmp.did:74469C04479BE111A56DB2A9FE791F35 Derived From Original Document ID: xmp.did:74469C04479BE111A56DB2A9FE791F35 Derived From Rendition Class : default Doc Change Count : 1 Format : application/pdf Producer : Adobe PDF Library 9.9 Trapped : False Page Count : 2EXIF Metadata provided by EXIF.tools