President Electronics USA UT412 AM 4W, Mobile CB Station Transceiver User Manual Addendum Johnson II USA 12 24 V v1 03 indd
President Electronics USA AM 4W, Mobile CB Station Transceiver Addendum Johnson II USA 12 24 V v1 03 indd
Contents
- 1. User Manual Addendum
- 2. User Manual
User Manual Addendum
IC RSS-GEN, Sec 7.1.2 Warning Statement - (Required for Transmitters)
ENGLISH:
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To
reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for
successful communication.
FRANÇAIS :
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) ap-
prouvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type
d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication
satisfaisante.
IC RSS-GEN, Sec 7.1.2 Warning Statement - (Required for Transmitters w/ detachable antennas)
ENGLISH:
This radio transmitter has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required
antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are
strictly prohibited for use with this device.
FRANÇAIS :
Le présent émetteur radio a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maxi-
mal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont
strictement interdits pour l'exploitation de l'émetteur.
IC RSS-102, Sec 2.6 Warning Statements
ENGLISH:
The antenna used for this radio must be properly installed and maintained and must provide a separation distance of at least 44 cm (17.5 Inches) from all persons
and must not be collocated or operated in conjunction with any other antenna or transmitter. Never transmit if any person is closer than the specied distance to the
antenna.
Note that PRESIDENT does not specify or supply any antenna with this transceiver. While a 0 dBi gain antenna is normal for a typical installation, the above limit
applies to any antenna with up to 3 dBi gain.
FRANÇAIS :
L’antenne utilisée pour cette radio doit être correctement installée et entretenue. Elle doit respecter une distance minimum de 44 cm (17,5 pouces) de l’utilisateur et
ne doit pas être installée à proximité ou utilisée conjointement avec tout autre antenne ou émetteur. N’utilisez pas votre radio si vous ne respectez pas la distance
spéciée.
Note: PRESIDENT ne recommande ni ne fournit aucune antenne avec cet émetteur-récepteur. Alors qu’un gain d’antenne de 0 dBi est normal pour une installation
traditionnelle, la limite mentionnée ci-dessus s’applique à n’importe quelle antenne avec un gain maximal de 3 dBi.
IC RSS-GEN, Sec 8.4 / RSP-100, Sec 8.4
ENGLISH:
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference;
and (2) This device must accept any interference, including interference that may cause undesired operation of the device.
FRANÇAIS :
Le présent appareil est conforme aux normes CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux
conditions suivantes : (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.