1011020G.TB Wiring Instr.pmd 550334 4 SJE Rhombus Tank Alert XT Terminal Block Instructions

: Pump 550334 4 Sje Rhombus Tank Alert Xt Terminal Block Wiring Instructions 550334_4_SJE Rhombus Tank Alert XT Terminal Block Wiring Instructions pdf

Open the PDF directly: View PDF .
Page Count: 2

FIGURE C

Tank Alert® XT Indoor/Outdoor Alarm

Terminal Block Option Wiring Instructions

INSTALL THE FLOAT SWITCH AND ALARM

Follow Tank Alert® XT Indoor/Outdoor Alarm Installa-

tion Instructions included.

INSTALL THE PUMP SWITCH

NOTE: Electrical rating of pump must not exceed 20

amps at 120 VAC or 20 amps at 230 VAC.

1. Follow mounting instructions included with pump

switch.

2. Determine the type of pump switch to be installed.

Select the installation diagram from Figure A that

corresponds to the type of pump switch being

installed. Run wires from pump switch through

conduit as shown in Figure A:

Two-Wire Pump Switch Wiring: Using positions on

the right side of the terminal block, connect the black

wire to position 6, the white wire to position 7 as

shown in Figure A (left diagram).

Double Float® Wiring: Using positions on the right

side of the terminal block, connect the black wire to

position 6, the white wire to position 5, the red wire to

position 7 as shown in Figure A (right diagram).

INSTALL THE PUMP

1. Run wires from pump through the same conduit as

the pump switch wiring as shown in Figure B.

2. On the left side of the terminal block, connect the

black wire to position 7, and on the right side of the

terminal, connect the white wire to position 5, and

the green wire to position 8 as shown in Figure B.

3. Run wires from pump power source through

conduit as shown in Figure C. This source should be

on a separate circuit from alarm power.

4. Using positions on the left side of the terminal

block, connect the white wire to terminal position 5,

the black wire to terminal position 6, and the green

wire to terminal position 8 as shown in Figure C.

5. Turn power on and tip pump switch to check

installation. Turn power off.

6. Finish installing alarm panel according to Tank

Alert® XT Installation Instructions.

NOTE: Route pump power and alarm power cords

through conduit on left. Route control switch, pump

switch, and pump cords through conduit on right.

ELECTRICAL SHOCK HAZARD

Disconnect power before installing or servicing

this product. A qualified service person must

install and service this product according to

national and local electrial codes. Do not

install in hazardous locations as defined by

the National Electrical Code, ANSI/NFPA 70.

2-WIRE

PUMP SWITCH

FIGURE A

DOUBLE FLOAT®

PUMP SWITCH

FIGURE B

WIRE SIZE 12-24 AWG WIRE SIZE 12-24 AWG

WIRE SIZE 12-24 AWG

Inst. Instr. PN1011020G

NOTES: _______________________________________________________________________________________________

_______________________________________________________________________________________________________

22650 County Highway 6



P.O. Box 1708



Detroit Lakes, Minnesota 56502 USA

1-888-DIAL-SJE (1-888-342-5753)



Phone: 218-847-1317



Fax: 218-847-4617



E-mail: sje@sjerhombus.com

1011020G.TB Wiring Instr.pmd 550334 4 SJE Rhombus Tank Alert XT Terminal Block Instructions

Navigation menu

Versions of this User Manual:

Views

Navigation