1011020G.TB Wiring Instr.pmd 550334 4 SJE Rhombus Tank Alert XT Terminal Block Instructions

: Pump 550334 4 Sje Rhombus Tank Alert Xt Terminal Block Wiring Instructions 550334_4_SJE Rhombus Tank Alert XT Terminal Block Wiring Instructions pdf

Open the PDF directly: View PDF PDF.
Page Count: 2

Download1011020G.TB Wiring Instr.pmd  550334 4 SJE Rhombus Tank Alert XT Terminal Block Instructions
Open PDF In BrowserView PDF
Tank Alert® XT Indoor/Outdoor Alarm

Terminal Block Option Wiring Instructions
INSTALL THE FLOAT SWITCH AND ALARM

ELECTRICAL SHOCK HAZARD
Disconnect power before installing or servicing
this product. A qualified service person must
install and service this product according to
national and local electrial codes. Do not
install in hazardous locations as defined by
the National Electrical Code, ANSI/NFPA 70.

®

Follow Tank Alert XT Indoor/Outdoor Alarm Installation Instructions included.

INSTALL THE PUMP SWITCH
NOTE: Electrical rating of pump must not exceed 20
amps at 120 VAC or 20 amps at 230 VAC.
1. Follow mounting instructions included with pump
switch.
2. Determine the type of pump switch to be installed.
Select the installation diagram from Figure A that
corresponds to the type of pump switch being
installed. Run wires from pump switch through
conduit as shown in Figure A:
Two-Wire Pump Switch Wiring: Using positions on
the right side of the terminal block, connect the black
wire to position 6, the white wire to position 7 as
shown in Figure A (left diagram).
®

Double Float Wiring: Using positions on the right
side of the terminal block, connect the black wire to
position 6, the white wire to position 5, the red wire to
position 7 as shown in Figure A (right diagram).
NOTE: Route pump power and alarm power cords
through conduit on left. Route control switch, pump
switch, and pump cords through conduit on right.

FIGURE A
2-WIRE
PUMP SWITCH

OR

DOUBLE FLOAT®
PUMP SWITCH

WIRE SIZE 12-24 AWG

INSTALL THE PUMP
1. Run wires from pump through the same conduit as
the pump switch wiring as shown in Figure B.
2. On the left side of the terminal block, connect the
black wire to position 7, and on the right side of the
terminal, connect the white wire to position 5, and
the green wire to position 8 as shown in Figure B.
3. Run wires from pump power source through
conduit as shown in Figure C. This source should be
on a separate circuit from alarm power.
4. Using positions on the left side of the terminal
block, connect the white wire to terminal position 5,
the black wire to terminal position 6, and the green
wire to terminal position 8 as shown in Figure C.
5. Turn power on and tip pump switch to check
installation. Turn power off.
6. Finish installing alarm panel according to Tank
Alert® XT Installation Instructions.

FIGURE B

FIGURE C

WIRE SIZE 12-24 AWG

WIRE SIZE 12-24 AWG

NOTES: _______________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________
_______________________________________________________________________________________________________

22650 County Highway 6
P.O. Box 1708
1-888-DIAL-SJE (1-888-342-5753)
Phone: 218-847-1317

Detroit Lakes, Minnesota 56502 USA
Fax: 218-847-4617
E-mail: sje@sjerhombus.com
Inst. Instr. PN1011020G
© SJE-Rhombus Rev 04/08



Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.0-c316 44.253921, Sun Oct 01 2006 17:14:39
Creator Tool                    : PageMaker 7.0
Modify Date                     : 2008:06:25 11:30:32-05:00
Create Date                     : 2008:06:25 11:29:53-05:00
Metadata Date                   : 2008:06:25 11:30:32-05:00
Format                          : application/pdf
Title                           : 1011020G.TB wiring instr.pmd
Creator                         : Sharlene.Delaney
Producer                        : Acrobat Distiller 8.1.0 (Windows)
Document ID                     : uuid:90dcbdd3-45ba-45a1-9252-21b364299324
Instance ID                     : uuid:b1674bc1-d19f-4f62-8069-0dbd663fb170
Page Count                      : 2
Author                          : Sharlene.Delaney
EXIF Metadata provided by EXIF.tools

Navigation menu