QUEST USA BABHP Build A Bear Plush Headphones User Manual bab plush headphones 11 24

QUEST USA CORP Build A Bear Plush Headphones bab plush headphones 11 24

Contents

User Manual

Power ON / OFF:
Power on: Push and hold the “●” button to turn on the headphone.
The player will enter into Bluetooth mode automatically while
you turn on.
Power off: Push and hold the “●” button to turn off the headphone.
Bluetooth function
● Bluetooth pairing: turn on the headphone and enter Bluetooth mode
(the indicator will be red and flash), then use your mobile or other
electronic equipment which have Bluetooth function to search the headphone,
its pairing name is “QA100”.
● Bluetooth re-pairing: any electronic equipment which you have paired the
Bluetooth with this headphone will connect the headphone automatically as
soon as they are in the same place and keep within 10m in the range, and
only the two with Bluetooth are under turn on status.
● Listen music: under Bluetooth mode, you just play the music on mobile or
any other equipment paired, and then you can enjoy the music by the
headphone.
60 mm
80 mm
Pause/Play music: Simply press the pause/ play “●” button located on
headphone
Volume up: press and hold the “ + ” button
Volume Down: press and hold the “ - ” button
Next song: press once the “ + ” button
Previous song: press once the “ - ” button
● Incoming call: During incoming calls the headphone will acknowledge there
is an incoming call. If music is playing , it will mute the music and announce
the phone number calling you .To accept the call, press the phone/pause/pay
“●” button.
● End call: Press the phone/pause/pay “●” button.
Charge it
Power Source: Built-in rechargeable battery.
Recharging: Plug the micro USB cable into the micro USB port on the side
of the headset, & connect the other end of the cable with any
compatible charger or wall outlet.
When charging, the LED indicator will glow red.
When full charged, the LED indicator will turn off.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Warning
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
SPECIFICATIONS:
Version: BT V4.0
Battery: 3.7V 300mAh
Play time: About 3h
Charging time: About 2h
Frequency Response: 20-20KHz
Speaker sensitivity: 103dB±3dB
Bluetooth distance: About 10m

Navigation menu