Qolsys QS-IQMICRO Wireless door/window Sensor used in Qolsys IQ home security system User Manual IQ Micro S Line Quick Guide

Qolsys, Inc. Wireless door/window Sensor used in Qolsys IQ home security system IQ Micro S Line Quick Guide

User manual

STEP 1IQ MICRO DW S-LINE QUICK INSTALL GUIDE✓Exterior Doors✓Sliding glass doorsWindows✓CHOOSE INSTALLATION LOCATIONAlso great for: Medicine cabinets Gun safes Garage doors Interior doorsSPECIFICATIONSSEE REVERSE FOR REMAINING STEPSSensor: 1.83”H x .87”W x .4”D Wireless signal range: 600ft (200M), open air. Code outputs: tamper, tamper restore, alarm, alarm restore, low battery. Transmitter frequency: SECURE 319.5 MHz (S-Line) Unique code ID Supervisory keep-alive interval: 70 minutes. RF Peak Strength: 69.32 dBμV/m at 3m Operating Temperature: -10C~50C Relative Humidity: 5-95% Non-Condensing Storage Temperature: -40-80C Replace battery with 3V Lithium (x1). (1) -Panasonic CR1632 -Energizer CR1632 -Duracell DL1632This is a quick guide for experienced installers only. Refer to http://dealers.qolsys.com (login required)
STEP 2STEP 4STEP 5SECURE SENSOR & MAGNETSTEP 6Document#: IQ-MICRO-SQG-12-18 Revision#: 1/9/19 Issue Date: JAN 2019 Qolsys Product #: QS1132-840/QS1130-840 APPLY ADHESIVEREMOVE BATTERY TABS1”Apply provided adhesive strips to the back of sensor and magnet. Magnet gap should not exceed 1”STEP 3LEARN INTO PANELCustomize name and settings as desired and and touch “ADD” ADDPlace your panel in “autolearn" modeOpen and close the case to “tamper” the deviceMagnet locator markMagnetSensorLINE UP SENSOR & MAGNETTechSupport@Qolsys.comCONTACT TECH SUPPORTGOT QUESTIONS?Qolsys Inc. proprietary. Reproduction without permission is not permitted.FCC ID: 2AAJXQS-IQMICROIC: 11205A-QSIQMICROThis device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.

Navigation menu