RC LEADING TOYS FACTORY CR101 Card reader User Manual
RC LEADING TOYS FACTORY Card reader
User Manual
Instruction sheet of TF card reader
This product is used for micro SD card read and write data, products adopt
single chip technology, and support the USB2.0 interface, reading and writing
data with quick speed, stable, safety and reliable, which can be widely used in
various non life safety industries
The products produced under the environmental in strict accordance with
protection process production, confirm to EU environmental protection and
the FCC safety requirements.
Specification:
①size:47*19.3*9.5mm
②Voltage: 5V ±0.5 V
③Working Current: ≤70mA
④Working temperature: -10~+70℃
⑤The interface type: USB2.0 without driving(it can be work when plug it)
⑥Support system:Windows,Linux。
FCC Statement:
FCC ID:2AGR2-CR101
This equipment has been tested and found to comply with the limits for Part 15
of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to
radio
communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.