RCA WHP150 User Manual To The 4985ad82 0086 4b30 978f 70da27be204c
User Manual: RCA WHP150 to the manual
Open the PDF directly: View PDF 
.
Page Count: 12
| Download | |
| Open PDF In Browser | View PDF |
ROil
Wireless
He a d p h 0 n e s
with 900 MHz Transmitter
\
\
Freedom From Wires
listen
anY"f'here in
WHP150
your
1:-°""8
INTRODUCTION
The 900 MHz stereo wireless headphone system uses latest
wireless technology that enables you to enjoy music and TV
sound anywhere inside or outside your home. You can simply
connect the system to any sound source such as CD, TV, VCR,
Hi-Fi and radio. It is also perfect for usage in class rooms,
hospitals, meetings, churches, as a hearing aid, and for the
purpose of language translation.
FEATURES
•
•
•
•
•
•
•
.
900 MHz Radio Frequency (RF) technology
RF technology lets you roam freely throughout your home
Operating distance up to 125 ft.
No line-of-sight limitations
Built-in charger in the transmitter
Virtually interference free stereo quality
Automatic Level Control and auto ON/OFF control.
HEADSET SAFETY
• Do not play your headset at a high volume.
Hearing experts advise against continuous
extended play.
• . If you experience a ringing in your ears,
reduce the volume or discontinue use.
• Make sure the volume level of the headphone
is set at a comfortable listening level hefore
placing it in position over your ears.
2
SYSTEM COMPONENTS
RADIO TRANSMITIER
Auto Power
ON/Signal
Strength
Indicator (Green)
Charge Indica tor
(Red)
-tI---
Frequency
Adjustment
Charge Output
Plug (connects
H+--to headphones
for charging)
- - Audio Cord
HEADPHONE RECEIVER
/---Power Indicator
I---On/Off Switch
/ /----Charge Input
Stereo Indicator --~::::::::§~ ~'----Volume Control
Tune
3
INSTALLATION OF TRANSMlnER
1) Connect the supplied AC power adapter to an electrical
wall outlet.
2) Plug the AC power Adapter into the DC jack located on the
rear of the transmitter.
ChargeOutput
Jack
AC/DC
Adapter
Green
LED
Audio
Cord
3) Locate the audio cord connected at the back of the transmitter. The 3.5 mm plug provided can be used to connect the
transmitter to the headphone jack of any audio source.
If your equipment has a 1/4" size jack, use the adapter plug
included with the headphone.
For connection to RCA type radio jacks located on the back of
a TV, VCR or A/V receiver, use the "Y" adapter that is
included. Just insert the mini plug on the audio cord into the
jack on the adapter to convert the connector for this application. Then insert the red and white RCA plug ends into the
equipment jacks marked "Audio Out" to make the audio
source connection (see diagram).
4
~~~
Audio
Cord
'-r:o-(~~k ~
I
I
"Y" kdapter
1/4" adapter
INSTALLATION OF BATTERIES
1) Open the battery compartment cover on the right side of the
headphone.
2) Insert two AA size Ni-Cd rechargeable batteries with the
correct polarity.
3) Replace the cover and you are ready to charge the batteries.
Battery
Door
5
I
CHARGING THE BAnERIES
1) Switch the ON /OFF switch on the headphone receiver to OFF.
2) Plug the charge output plug, located on the back of the
transmitter, into the charge input jack of the headphone
receiver to charge the batteries.
3) The charging process starts automatically and the RED LED
lights up indicating the unit is charging.
4) After the quick charge is completed, the quick charge indicator
will be OFF; however, the trickle charge will continue.
Caution: Do not use other kinds of batteries to replace the Ni-Cd quick
charge (AA) battery. When you are not using the headphone, please switch it off as the batteries can be damaged.
Headphone
a
Base
Red LED
The Ni-Cd (nickel cadmium) batteries must be fully charged prior
to operation. An initial charge of 24 hours is required to ensure
the extended life of the Ni-Cd batteries. Be sure the headset is in
the OFF position during charging status.
6
OPERATION
1) Turn on the audio source (TV or audio component) to which
the transmitter is connected.·
2) Switch the ON /OFF switch on the headphone to ON.
3) Place the headphones on your head and adjust the volume
control to the desired listening level. The adjustable headband lets you adjust the length of the headphones for a
comfortable fit.
4) Tune the frequency adjustment control, located on the back of
the transmitter, to a mid-level setting. Just rotate the thumbwheel knob up or down and leave it set approximately in the
middle of the range.
5) Adjust the tuning dial of the headphone to the frequency of
the transmitter for best reception.
NOTE
You should now be able to walk freely from room to room without disruption. If
disruption should occur (signal breaks up), adjust the headphones tuning control
to maximize stereo reception.
If you hear interference from other components, re-adjust the twung control.
Move the control on the transn1itter to a different setting, then adjust the control
on the headphones to matdl the new setting. You may have to try a few locations to find one with no interference.
When transn1itting/receiving over long distances, the signal from the system will
become weaker and the stereo indicator light will go dinl.
For protection of the transnutter and to save power, the transnutter will cut off
automatically in about one minute when the input signal from the audio source
is too weak for operation. If the signal is restored, the transnutter will work
again autoinatically.
7
TROUBLE SHOOTING,
No Sound
Ensure the AC adapter is fully inserted into the
AC outlet and into the power connection input on
the transmitter.
Ensure the headphones ON /OFF switch is in
the ON position.
Headphone batteries may be too low. Charge batteries.
Ensure the TV or audio component is on and tuned to a
channel with audio.
Adjust the volume control on the headphone to
turn up the volume.
The connected audio/video equipment is not playing
(CD, Tape, etc. .. ). Check the audio source.
The volume of headphone is turned down, adjust the
volume to an appropriate level.
Distortion
Ensure the stereo indicator light is on. If not,
adjust the tuning control on the headphones
until the indicator light is on.
Change the position of the FREQ. ADJUST control
to change operating frequency. You must then
adjust the tuning control on the headphone until
the stereo indicator light is on.
Headphone batteries may be too low. Charge the batteries
or replace with new ones if they do not charge.
Ensure the level control wheel is adjusted properly.
The headphone is too far from transmitter,
move closer.
The input level of the audio Signal is too low. Turn
up the volume of the audio source equipment.
8
SPECIFICATIONS
Transmission Mode:
UHF Stereo
Carrier Frequency
911.5 - 913.5 MHz
Operating Voltage
Transmitter, 19V200mA
Receiver, 2.4V (2xAA Ni-Cd Quick Charge Battery)
Frequency Response
20Hz - 20 Khz
Signal Noise Ratio
55 dB
Distortion
1.5%
Separation
30dB
Operation Distance
50M
NOTE: Changes or modifications not expressly approved by the party
responsible for compliance to the FCC Rules could void the users authority to
operate this equipment
9
RCA ACCESSORIES
The following RCA accessories are available through your RCA dealer or:
ORDER BY PHONE:
Have your Visa, MasterCard or
Discover Card ready and call the
toll-free number listed bel II IY. This
number should only be used to
place orders.
1-800-338-0376
ORDER BY MAIL:
Complete order form on page
11 and mail to:
RCA Accessories
PO Box 8419
Ronks, PA 17573
ANT200 AMPLIFIED TV ANTENNA
To receive UHF or VHF stations or serve as a backup for cable outages, purchase
the RCA ANT200. Switching between your cable or satellite and your antenna is
made easy with an integrated AlB switch. Hooks up to any TV and includes all
necessary accessories.
Features include:
- Dipoles tilt and rotate for improved picture
- UHF Loop turn range of 345
- Gold plated connectors for improved
signal conductivity
Manual Gain Control to Boost Signal
- Measures 8Y, H. X 8)' W. X 4:,( D.
0
ANT200
t
$4995
D918 Surge Protector Plus
Power surges can enter and destroy your valuable equipment from many sources
- cable, phone lines, satellite dishes or electrical connections. Guard
your vulnerable home theatre equipment against potential damage
from power surges or other electrical disturbances.
Features include:
3-Way Surge Protection
8 Outlets plus Coaxial, Phone & AC Line
- $10,000 Equipment Guarantee
- Lifetime Warranty
10
0918
$4995
t
RCUSATl UNIVERSAL REMOTE
Universal Remote
Controls 4 Devices, TV, VCR, Satellite or
Cable Box, and Audio System
Features include:
- Universal DSS and D13S Compatibility
Menu and Guide Controls
- Picture-In-Picture Controls
Code Search For Easy Programming
RCUSATl t
$2995
Nnlllt'
Address
City
Sta/{'
Day Timt' Plume NIIIII/'cl'
o Money Order Enclosed
Credit Card: 0 Visa
0 Check Enclosed
0 MasterCard 0 Discover
Card Number
DDDD-DDDD-DDDD-DDDD
Expires: _ 1 _ 1 _
Siglllltlire
PRICE
ITEM
ANT200 Amplified TV Antenna
$49.95
D918 Surge Protector
$49.95
RCUSATl Universal Satellite Remote
$29.95
QTY
TOTAL
Add Applicable Sales Tax
Include Post & Handling
$5.00
Total Amount of Order
t Tax, Shipping & Handling, Charges Appty © 1997 Thomson Consumer Electronics, Inc.
Trademark(s) ® Registered Marca(s) Registrada(s)
11
ONE YEAR LIMITED WARRANTY
Thomson Consumer Electronics, Inc. warrants that for one year from the date of
purchase this product is free from defects in material and workmanship. If the
item is defective within that period, return it at your expense to the dealer from
whom it was purchased together with proof of purchase for replacement. The
exchange unit is under warranty for the remainder of the original product's
warranty period. This warranty excludes defects or damage due to misuse, abuse,
neglect or acts of God, including but not limited to lightning damage. The
foregoing represents Thomson's sole obligation under this warranty.
This warranty gives you specific legal rights, and you may have other rights which
vary from state to state. For purchases outside the United States, contact your
dealer for warranty information.
12
"Thomson Consumer Electronics, Inc.
Product Exchange Center
32B Spur Drive
EI Paso, Texas 79906
IJ1500
Trademark(s) ® Registered
Marca(s) Registrada(s)
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : Yes Create Date : 1999:03:19 16:44:29Z Creator : Acrobat 3.0 Capture Plug-in Modify Date : 2010:12:07 13:28:47-06:00 XMP Toolkit : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04 Creator Tool : Acrobat 3.0 Capture Plug-in Metadata Date : 2010:12:07 13:28:47-06:00 Producer : Adobe Acrobat 9.41 Paper Capture Plug-in Format : application/pdf Document ID : uuid:3e74c079-9c5f-4c81-842b-4635e2e4a472 Instance ID : uuid:f8c9f57f-0cec-428e-824a-bec946cd3749 Page Count : 12EXIF Metadata provided by EXIF.tools