RF Technology M7 Bluetooth wireless earphones User Manual 1
Shenzhen RF Technology Co., Ltd Bluetooth wireless earphones 1
User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 3302276 |
| Application ID | 1e6uQ3IbQsb8UKnD2spUyQ== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 139.1kB (1738809 bits) |
| Date Submitted | 2017-03-02 00:00:00 |
| Date Available | 2017-03-04 00:00:00 |
| Creation Date | 2017-02-23 15:18:25 |
| Producing Software | Corel PDF Engine Version 17.1.0.572 |
| Document Lastmod | 2017-02-27 11:30:39 |
| Document Title | 未命å -1 |
| Document Creator | CorelDRAW X7 |
| Document Author: | Administrator |
防水运动蓝牙耳机 使用说明书 操作提示: 拒接来电 开机 长按多功能键2秒至蓝色指示灯闪2次 语音提示:“开机" 短按多功能键两下 注: 第一次配对的手机定为电话1，耳机需关机后 再开机才能自动回连电话2， 电话1需手机连接。 重拨电话 耳机充电： 短按多功能键两下 语音提示:“重拨" 请使用5V,2.1A以下的充电器给耳机充电 充电，红灯长亮； 充满电，蓝灯长亮； 低电，闪红灯，语音提示：“电量低”。 关机 长按多功能键2秒至灯色指示灯闪1次 语音提示:“关机" 音量"+" 短按音量"+"键 语音提示: 最大音量时提示”嘀嘀”长音 音量"-" 短按音量"-"键 语音提示: 最大音量时提示”嘀嘀”长音 1 多功能键 2 音量+/上一曲 4 MIC 5 右耳 3 音量-/下一曲 6 左耳 上一曲 长按音量"+"键2秒 下一曲 长按音量"-"键2秒 接听电话 短按多功能键一下 挂断电话 左边耳挂(大中小) 短按多功能键一下 右边耳挂(大中小) 语音控制 长按音量“+”或者“－”键3秒进入提示控制, 再长按3秒结束语音控制 此功能需手机支持语音控制才能使用 播放/暂停音乐 短按多功能键一下"播放/暂停"音乐 配对 长按多功能键3秒直到蓝牙指示灯红蓝交替闪烁 打开手机/平板电脑的蓝牙开关, 并确定它处于可 搜索状态 手机上选择耳机型号"M7" 语音提示:“进入配对", "配对成功,已连接" 如未配对成功, 请重复以上步骤 如需输入密码, 请输"0000" 配对第二台手机(一拖二) 如需配对第2台手机, 关闭第一台手机的蓝牙, 按 照以上步骤操作 充电时长：1.5－2小时 耳机提示音选择 开机状态下,同时长按音量"+"和"多功能"键约5秒 至红蓝灯同时亮，可切换"中文/英文"提示音 耳机音效选择 本耳机支持高、中、低三种音效模式，播放音乐 时同时按音量“+”和“－”键至 红蓝灯同时亮 可循环切换 恢复出厂设置 温馨提示： 1、 请使用标准的5V直流充电器或直流供电源给 蓝牙耳机充电； 2、 三个月未使用请及时给蓝牙耳机充满电，以 延长电池使用寿命； 3、 首次使用蓝牙耳机请把电池电量用完再充满 电，这样可以延长电池的使用寿命； 4、 充电时请勿将蓝牙耳机放在易燃、易爆物品 旁边； 5、将蓝牙耳机放进口袋前请先关闭蓝牙耳机， 以免误碰到多功能键，造成手机意外拨号； 6、请将蓝牙耳机远离水源和火源，并避免长时 间曝露在阳光下以及温度过高的地方； 7、长时间不使用耳机，充电时红色充电指示灯 有可能延迟数秒再亮起，这不影响正常使用； 8、耳机无任何设备连接情况下，10分钟将会自 动关机，进入节能状态； 9、新使用M7耳机建议将音量调到80%左右连续 播放3个小时，这样反复2～3次后喇叭音质效果 更佳。 开机状态下,同时长按音量"－"和"多功能"键约5秒 至红蓝灯同时亮，然后重新开关机，即可恢复出 厂设置，清空所有配对过的蓝牙设备。 PARI NG 1 POWER 2 Vol+ 4 MIC 5 Right 3 Vol - 6 Left 保修期: 本产品自购买日期起保质12个月. 以下情况不在保修范围: 1. 无保修卡或产品维修标签被破坏 2.消 费者自行拆卸造成损坏. 3. 因人为跌落而造成的故障及人为机 械损坏 且位伴匶 产品型号 产品颜色 购买日期 维修日期 客户名称 联系地址 联系电话 Bluetooth wireless earphones 保修卡 1. Press and hol d the “POWER” k ey for 3 sec ond s to put the earphones in to pari ng mode. You will hea r the voice prompt “PARING” and the LED light will flash in red and blue. 2. Enable your bluet ooth devices such as mobile p hones, tablets or oth er bluet ooth media and make sure it is in searching mode. 3.Select “M7” in th e lis t shown on the Bluetoot h device. 4. Once selected , you wil l hear a voice promp t “ParingSuc cess”Con nected“”. The earphone could c onne ct to mult iple Blueto oth devices at the sam e time. 5. In put “0000 ” if any pin cod e need ed IMP ORTANT: When you need to conn ect your earphone with another Bluet ooth enable d audi o device, turn off the bluetoo thin the 1st mobil e device, hol d the pairing butt on unti l the Bluet ooth LED indic ator flashes in red and blue quickl y. This will put the headphone into pairing mode. Charging Earbuds Left (S.M.L) Earbuds Right (S.M.L) Before using your ear phones, ple ase charge it usin g the micro USB charging ca ble included in the pac kage . Note: Most USB chargers are compatible with M7. For optimal AC charging, please use a 1.0A USB charger. 1. Charging: LED in red 2. Charging finished: LED in blue 3. Low Battery: LED flashes in red POWER ON Press “POWER” KEY for 3 seconds, LED flashes in blue slowly. Voice prompt: “Power on” POWER OFF Press the “POWER” KEY for 3 seconds. LED will turn off. Voice prompt: “Power OFF” VOLUME UP Short press “+” for volume up. Voice prompt: “Maximum Volume” VOLUME DOWN Short press “-“ for volume down. Voice Prompt: “ MINIMUM VOLUME” next track. Answer Call Press the ”POWER” KEY once while a call is incoming. End Call Press the “POWER” KEY once to end call. Reject Call Double press “POWER” KEY for 2 seconds to reject a call Redial Double press 'POWER' KEY to redial the last number . Voice Prompt: “ Redialing” Voice Command Press volume “-” or “+”KEY for 3 seconds to use the voice command. Note: Please ensure your mobile phone supports voice command function for this feature. FCC Statement No sound NOTES Do not expose the built-in battery to excessive heat, including direct sunlight and fire. This earphones is in compliance with the specified Bluetooth version. It does not guarantee compatibility of all functions on every Bluetooth enabled device. Please check with your mobile phone's user manual for compatibility and functionality. Play/Pause Music PREVIOUS TRACK Choose Voice Prompt Language Turn on earphones, press and hold the “POWER” and “+“ KEY for 5 seconds until the LED in blue and red at the same time to choose English or Chinese voice prompt. NEXT TRACK TROUBLE SHOOTING No power Ensure the earphone is charged and with enough power for operation. The earphones can't be used when it is in charging mode. Ensure the earphone is on. Ensure your Bluetooth device is on. If the volume of the earphones is too low, adjust the volume to an appropriate level. Unable to connect Turn off M7 and turn it back on. The Bluetooth earphones will go into pairing mode. Select M7 on your Bluetooth enabled device. Poor sound quality Ensure placing the earphones and Bluetooth device within 33ft. (10m) sensing distance and with no barriers. Press the “POWER” KEY once to play/pause music Press and hold “+” KEY for 2 second for previous track. Press and hold “-“ KEY for 2second for the Factory Reset Turn on earphones, press and hold the “POWER” and “-“ KEY for 5 seconds until the LED in blue and red at the same time, The paring information is empty, re-start the earphone then it will be in paring mode again.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.5 Linearized : No XMP Toolkit : Adobe XMP Core 5.4-c005 78.147326, 2012/08/23-13:03:03 Format : application/pdf Creator : Administrator Title : 未命名 -1 Create Date : 2017:02:23 15:18:25+08:00 Creator Tool : CorelDRAW X7 Modify Date : 2017:02:27 11:30:39+08:00 Metadata Date : 2017:02:27 11:30:39+08:00 Producer : Corel PDF Engine Version 17.1.0.572 Document ID : uuid:a2e43c4d-b0fc-4b18-81a3-080c53fe42fa Instance ID : uuid:6f11b9c3-d934-411c-a162-b46bc7bbac21 Profile CMM Type : Lino Profile Version : 2.1.0 Profile Class : Display Device Profile Color Space Data : RGB Profile Connection Space : XYZ Profile Date Time : 1998:02:09 06:49:00 Profile File Signature : acsp Primary Platform : Microsoft Corporation CMM Flags : Not Embedded, Independent Device Manufacturer : IEC Device Model : sRGB Device Attributes : Reflective, Glossy, Positive, Color Rendering Intent : Perceptual Connection Space Illuminant : 0.9642 1 0.82491 Profile Creator : HP Profile ID : 0 Profile Copyright : Copyright (c) 1998 Hewlett-Packard Company Profile Description : sRGB IEC61966-2.1 Media White Point : 0.95045 1 1.08905 Media Black Point : 0 0 0 Red Matrix Column : 0.43607 0.22249 0.01392 Green Matrix Column : 0.38515 0.71687 0.09708 Blue Matrix Column : 0.14307 0.06061 0.7141 Device Mfg Desc : IEC http://www.iec.ch Device Model Desc : IEC 61966-2.1 Default RGB colour space - sRGB Viewing Cond Desc : Reference Viewing Condition in IEC61966-2.1 Viewing Cond Illuminant : 19.6445 20.3718 16.8089 Viewing Cond Surround : 3.92889 4.07439 3.36179 Viewing Cond Illuminant Type : D50 Luminance : 76.03647 80 87.12462 Measurement Observer : CIE 1931 Measurement Backing : 0 0 0 Measurement Geometry : Unknown Measurement Flare : 0.999% Measurement Illuminant : D65 Technology : Cathode Ray Tube Display Red Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Green Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Blue Tone Reproduction Curve : (Binary data 2060 bytes, use -b option to extract) Page Count : 1 Author : AdministratorEXIF Metadata provided by EXIF.tools