RSI VIDEOTECHNOLOGIES KF00 Keyfob User Manual Manual kf641

RSI VIDEOTECHNOLOGIES Keyfob Manual kf641

Contents

Manual_kf641

KF 240/641/742 4-BUTTONS REMOTE KEYFOBINSTALLATION SHEETDOC. - REF. 217-KFEDITION DATE : FEBRUARY 20161Operation Press briefly and release the corresponding button to arm (full arming or partial arming) or disarm. The first beep confirms the button has been pressed. Two beeps confirm that the panel has received the command. If the panel has not received the command, only one beep is emitted by the keyfob.A red double flash confirm the system full or partial arming. A green double flash confirms disarming.To trigger an alert, press and hold one of the partial arming keys for 2 seconds. > Note : This keyfob is powered by a CR3032 lithium battery with a 5-year battery life.CommandsFull ArmingPartial arming 1Siren alert after holding for 2 secondsDisarmingPartial arming 2Silent alert after holding for 2 secondsVisual arming status after holding for 2 secondsPress and hold ___ & __ simultaneously for 5 secondsThe keyfob emits delay beeps when the system is armed. You can determine if a door contact is still open.If a device is detecting while the panel is arming, the keyfob emits a 4-second long beep.You do not need to wait for the beeps to stop to leave the premises. The beeps will automatically stop after the configured exit delay.Visual arming statusSystem disarmedSystem armedProgrammingEnable the device recording mode on the panel, the keypad will display “PRESS PROGRAM BUTTON OF DEVICE”.Press and hold the keyfob & keys simultaneously. When releasing, the keyfob emits a beep and a flash every second then the keyfob is recorded by the panel.If the keyfob is not recorded, confirm that the keypad is displaying: then press and hold the keyfob & keys again (by strongly pressing the buttons). PRESS PROGRAM BUTTON OF DEVICE
2INSTALLATION SHEET KF 240/641/742 4-BUTTONS REMOTE KEYFOBSecurity notes / (FR) Notes de sécurité / (DE) Hinweise zur SicherheitFrançais• Retirez la batterie avant toute opérationde maintenance !• Attention ! Il y a un risque d'explosion sila batterie utilisée est remplacée par unmauvais modèle !• Respectez la polarité lors de la mise enplace de la batterie !• Ne jetez pas la batterie usagée !Ramenez-la à votre installateur ou à unpoint de collecte spécialisé.Deutsch• Batterien vor jeglichen Wartungsarbeitenentfernen!• Vorsicht, es besteht Explosionsgefahr,wenn eine Batterie durch eine Batteriefalschen Models ersetzt wird!• Achten Sie beim Einsetzen der Batterie aufdie Polung! • Entsorgen Sie Batterie nicht im normalenHaushaltsmüll! Bringen Sie Ihreverbrauchten Batterie zu den öffentlichenSammelstellen.English• Remove the battery before any maintenance !• WARNING, there is a risk of explosion if abattery is replaced by an improper model !• Observe polarity when setting up thebattery!• Do not throw the battery when it is used!Dispose of it properly according to LithiumMetal requirementsFCC Regulatory Information for USA and CANADAFCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI Video Technologies may void the FCC authorization to operate this equipment.FCC Part 15.105 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:> Reorient or relocate the receiving antenna.> Increase the separation between the equipment and receiver.> Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.> Consult the dealer or an experienced radio/TV technician for help.Radio frequency radiation exposure information according 2.1091 / 2.1093 / OET bulletin 65This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.Cet équipement est conforme aux limites d’exposition aux rayonnements IC établies pour un environnement non contrôlé.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s)Operation is subject to the following two conditions:1 This device may not cause harmful interference, and 2 This device must accept any interference received, including interference that may cause undesired operation.Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence.L’exploitation est autorisée aux deux conditions suivantes :1 L’appareil ne doit pas produire de brouillage, et 2 L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement..
INSTALLATION SHEET3www.videofied.comKF 240/641/742 4-BUTTONS REMOTE KEYFOBCertifications868MHz (KF 240)In accordance with Annex IV of the R&TTE Directive 1999/5/ECNF EN50131-3 2009 Grade 2 - Type BNF EN50130-4 2011NF EN50130-5 2011 Class IIThis symbol on the product or on its packaging indicates that this product should not be treated as household waste. It must be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health. The recycling of materials will help to conserve natural resources. For more information about recycling of this product, please contact your local municipality, your waste disposal service or the company that installed the product.915MHz (KF 641) USA FCC (Part 15C) Canada IC (RSS-210 Issue 8) 920MHz (KF 742)Australia C-Tick(AS/NZS4268, AS/NZS 60950)ELECTRICAL PROPERTIESPanel compatibility All panelsPower requirements Type CBattery type 1x Lithium, CR3032Nominal Voltage 3 VBattery life 5 yearsRF technology S2View®Radio Type Spread Spectrum BidirectionalOperating frequency868MHz - KF240 (Europe, Africa, Asia)915MHz - FHSS - KF641 (USA, Canada, South Amercia)920MHz - FHSS - KF742 (Australia, South America)Transmission security AES encryption algorithmAntenna IntegratedMaximum keyfobs registered 22PHYSICAL PROPERTIESMaterial Plastic : ABSDimensions 70 mm x 40 mm x 10 mmWeight 40 gOperating temperature 0°/+40°C (32°/104°F)Max relative humidity 70%, without condensingThe EC declaration of conformity of this product is available by flashing this QR code.

Navigation menu