RSI VIDEOTECHNOLOGIES OS00 Outdoor Siren User Manual
RSI VIDEOTECHNOLOGIES Outdoor Siren
User Manual
Doc. - Ref. 216-OSX
Version : March 2014
The OSX Outdoor Siren is designed for use with a
Videofied™ wireless alarm system.
Its main features are :
• Completely wireless and powered with
alcaline batteries : 4 years battery life.
• Dual tamper function provides detection for
both wall and cover tamper.
• Transmits check-in/status signals every 8
minutes
• Flash LED light
• 100 dBA output level at 1 m
• 3 to 15 minutes output and flashlights
duration (according to local legislation).
Product Presentation
Installation guidelines
For easier installation, programming and RF testing should
be done to check for good communication between the
control panel and all system devices before mounting system
devices. Install the siren and other system devices in the order
of the following steps :
> Mounting - mount siren at the tested location.
> Programming/RF Testing - program the siren and all other
devices into the control panel and test RF communication
from each intended device location to the control panel.
Mounting
> Use proper tools and hardware for mounting the unit.
> Mount outdoors under eves to help prevent direct
contact from elements.
> Mount on front of structure where strobe light is clearly
visible to responding authorities.
1 Press both side buttons together to open the siren box.
2 Hold up the siren base against the mounting surface and
mark the four mounting holes.
3 Drill pilot holes and install anchors where needed.
4 Place unit on mouning surface so mounting holes line up
with pilot holes/anchors and secure unit with appropriate
screws.
5 Install 3 LR 1.5V batteries, observing correct polarity.
6 Attach front cover and lock with the screws.
Mounting holes
PRODUCT INSTALL SHEET
OSX Outdoor Siren
www.videofied.com
Programming/RF Testing
The following provides summarized steps for device
programming and testing. For complete details, refer to the
control panel installation manual.
1 With the programming keypad, browse to the ADD A NEW
DEVICE menu (Level 4).
2 Press OK/YES. The keypad displays PRESS PROGRAM
BUTTON OF DEVICE.
3 Press and release program button on siren using a paper
clip end.
The siren LED flashes.Wait for keypad display to show SIREN
(1 - 25) RECORDED.
4 Press OK/YES. The display shows RADIO RANGE TEST?
Press OK/YES again to run the test. The keypad display shows
TEST IN PROGRESS.
5 Make sure the siren is flashing indicating good
communication with the control panel. The test result must
stabilize at 8/9 minimum.
6 Press OK/YES to end the radio range test then ESC NO.
7 When finished, exit from configuration mode by a long
press on ESC NO.
INIT
Button
Opening
Button
Locking
Screw
www.videofied.com
PRODUCT INSTALL SHEET
2
OSX Outdoor Siren
Use only the flashlights or only the output
CONFIGURATION
DEVICES
AREAS AND DEVICES
OK or YES
OK or YES
OK or YES
Lvl. 4
Device list
To select the siren
ADD A DEVICE
DEVICE
CONFIGURATION
OK or YES
OK or YES
ALARM
FLASH + SIREN
Press
OK or YES
and use the arrows to
select FLASH + SIREN, FLASH or SIREN
Those functions are only available for panel
firmware versions 04.03.XX.XXX and later
In order to check the firmware version, enter
the following code in the standby menu when
the panel is DISARMED : 000000+YES
Enable delay beeps
CONFIGURATION
DEVICES
AREAS AND DEVICES
OK or YES
OK or YES
Lvl. 4
OUT SIREN DELAY
DISABLED/ENABLED
By default, the output and the flashlights are enabled
when the OSX is active. You can enable one or the other.
By default, delay beeps are disabled on the OSX outdoor
siren. You can enable those delay beeps.
www.videofied.com
PRODUCT INSTALL SHEET
3
OSX Outdoor Siren
www.videofied.com
PRODUCT INSTALL SHEET
4
OSX Outdoor Siren
Security notes / (FR) Notes de sécurité / (DE) Hinweise zur Sicherheit
Français
• Retirez les piles avant toute opération de
maintenance !
• Attention ! Il y a un risque d'explosion si
l'une des piles utilisées est remplacée par
une pile de type incorrect !
• Respectez la polarité lors de la mise en
place des piles !
• Ne jetez pas les piles usagées !
Ramenez-les à votre installateur ou à un
point de collecte spécialisé.
English
• Remove battery before any
maintenance !
• WARNING, there is a risk of explosion if a
battery is replaced by an incorrect type!
• Observe polarity when setting up the
batteries!
• Do not throw used batteries! Bring them
to your installer or a collection point.
Deutsch
• Batterien vor jeglichen Wartungsarbeiten
entfernen!
• Vorsicht, es besteht Explosionsgefahr,
wenn eine Batterie durch eine Batterie
falschen Typs ersetzt wird!
• Achten Sie beim Einsetzen der Batterien
auf die Polung!
• Entsorgen Sie Batterien nicht im
normalen Haushaltsmüll! Bringen Sie
Ihre verbrauchten Batterien zu den
öffentlichen Sammelstellen.
FCC Regulatory Information for USA and CANADA
FCC Part 15.21 Changes or modifications made to this equipment not expressly approved by RSI Video Technologies may void the FCC
authorization to operate this equipment.
FCC Part 15.105 Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
> Reorient or relocate the receiving antenna.
> Increase the separation between the equipment and receiver.
> Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
> Consult the dealer or an experienced radio/TV technician for help.
Radio frequency radiation exposure information according 2.1091 / 2.1093 / OET bulletin 65
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed
and operated with minimum distance of 20 cm between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.
Operation is subject to the following two conditions:
1 This device may not cause harmful interference, and
2 This device must accept any interference received, including interference that may cause undesired operation.
Cet appareil est conforme à la Partie 15 des règlementations de la FCC et avec la norme RSS-210 de l’Industrie Canadienne.
Son fonctionnement est soumis aux deux conditions suivantes :
1 Cet appareil ne doit pas causer d’interférences nuisibles et
2 Cet appareil doit accepter toute interférence reçue, y compris les interférences pouvant entraîner un fonctionnement indésirable.
www.videofied.com
North American Headquarters
1375 Willow Lake Blvd, Suite 103
Vadnais Heights, MN 55110
USA
E-Mail : usasales@rsivideotech.com
EMEA SALES
23, avenue du Général Leclerc
92340 BOURG-LA-REINE
FRANCE
E-Mail : emeasales@rsivideotech.com
5
PRODUCT INSTALL SHEET
OSX Outdoor Siren
© 2013 RSI Video Technologies Videofied® and MotionViewer® are Registered Trademark of RSI Video Technologies.
Specifications subject to change without notice.
Electrical Data
Panel Compatibility XL, XLL XT, XV, VISIO
Power requirements 4.5V DC
with 3 LR20, 1.5V, D size Alkaline batteries
Battery life 4 years
Current consumption
Standby 141uA (OSX200 & OSX210)
200uA (OSX601 & OSX712)
Alarm 2A
RF Technology S2View®
Radio type Spread spectrum bidirectionnal
Operating frequency
868MHz - OSX200 & OSX210 (Europe, South Africa, Asia)
915MHz - FHSS - OSX601 (USA, Canada, South America)
920MHz - FHSS - OSX712 (Australia, South America)
Transmission security AES encryption algorithm
Supervision Polled signal every 8 minutes
Antenna Integrated
Tamper detection Wall and cover tampered
Output level 100 dBA at 1m
Output and flashlights duration
3 min by default (15 min max according to local legislation)
Flashlight type LED
Flashlight color Orange - OSX200 & OSX601
Blue - OSX210 & OSX712
Flashlight frequency 1 flash per second
Operating temperature -25°/+70°C (-13°/158°F)
Maximum relative humidity 75%, non-condensing
Installation/Mounting
Cover Two side scews for cover locking
Siren/Wall Four screws secure siren base to mounting surface
Physical Data
Material ABS - ULV0
Dimensions 349 mm x 232 mm x 54mm
Weight 1200g (without batteries)
1400g (with batteries)
Protection Marking IP44/IK08
Standards & Certifications
868MHz (OSX200 & OSX210)
Standards :
NF EN50131-4 : 2009 Grade 2 - Type W
NF EN50130-4 : 2011
NF EN50130-5 : 2011 Class IV
915MHz (OSX601)
USA FCC Part 15C (FCC47 CFR part15)
Canada IC (RSS-210 Issue 8)
920MHz (OSX712)
Australie C-Tick (AS-NZS4268)