Radio Shack 15 1186 Users Manual

15-1186 to the manual 3f7c9fda-331c-4d4c-8001-0bfb8420eb95

2015-01-21

: Radio-Shack Radio-Shack-15-1186-Users-Manual-352754 radio-shack-15-1186-users-manual-352754 radio-shack pdf

Open the PDF directly: View PDF PDF.
Page Count: 2

Cat. No. 15-1186
To mount the TV FM Flush Mount Wall Plate:
1. If there is no wall box, cut a 13/4 ¥ 4 inch hole in the
wall at the desired location.
2. Across the top of the hole, position a flat bracket
piece a
g
ainst the inner wall surface and an an
g
led
bracket piece a
g
ainst the outer wall surface (with the
recessed part inside the hole).
3. Thread two of the supplied lon
g
bolts throu
g
h the
two outer holes on the bracket pieces.
4. Repeat Steps 2 and 3 across the bottom of the hole
so the center hole in the bottom bracket is 31/4
inches below the center hole in the top bracket (to
match the distance between the mountin
g
holes on
the wall plate).
(L) illus of hole on wall w
/
dimension lines
size to fit text margins
(R) illus of wall cross-sec
t
w/brackets and screws;
Custom Manufactured in Taiwan for RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
15-1186.fm Page 1 Thursday, July 15, 1999 1:47 PM
12A98 Printed in Taiwan
5. Use a Phillips screwdriver to loosen the two screws
on the back of the wall plate. Connect the antenna
cable/wires from inside the wall to the rear connec-
tors on the plate, then reti
g
hten the screws.
Warning: Be sure the exposed portions of the
cables/wires do not touch each other.
6. Use the two supplied short screws to secure the
plate to the center holes of the brackets.
7. Use a flat-bladed screwdriver to loosen the screws
at the back of the supplied three-pron
g
cable plu
g
.
Connect the 300-ohm antenna wire from the audio
and video outputs of the TV
(
or the left and ri
g
ht
channels of the FM radio
)
to the plu
g
, then reti
g
hten
the screws.
8. Insert the plu
g
into the wall plate’s
j
ack.
size to fit text
margins
illus of hole on wall
w
brackets in place
15-1186.fm Page 2 Thursday, July 15, 1999 1:47 PM

Navigation menu