Radwin RW3XMOD 3.6GHz Radio Module for Base and Fixed User Manual Manual

Radwin Ltd. 3.6GHz Radio Module for Base and Fixed Manual

Manual

           AP0136450     RF Module Operating in the 3.4-3.7 GHz bands    REFERENCE GUIDE
Regulatory Compliance    FCC/IC - Compliance  This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules and IC RSS standards. These limits are designed to provide reasonable protection against harmful interference in a  residential installation. This equipment generates  uses  and  can  radiate  radio  frequency  energy  and,  if  not  installed  and  used  in accordance  with  the  instructions,  may  cause  harmful  interference  to  radio  communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment  does  cause  harmful  interference  to  radio  or  television  reception,  which  can  be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:  • Reorient or relocate the receiving antenna.   • Increase the separation between the equipment and receiver.   • Connect the equipment into  an outlet on  a  circuit different from that to which the receiver is connected.  • Consult the dealer or an experienced radio/TV technician for help.  RADWIN  Ltd.  is  not  responsible  for  any  radio  or  communication  interference  caused  by using other than specified or recommended cables and battery or by unauthorized changes or modifications to this equipment. Changes or modifications or modifications not expressly approved by the manufacturer could void the user's authority to operate the equipment.   It is the responsibility of the installer to ensure that when using the outdoor antenna kits, only those antennas certified with the product are used. The use of  any  antenna  other than  those  certified  with  the  product  is  expressly forbidden by FCC rules 47 CFR part 15.204 and IC RSS standards.   Il  est  de  la  responsabilité  de  l'installateur  de  s'assurer  que  lorsque  vous utilisez  les  kits  d'antennes  extérieures,  seules  les  antennes  certifiés  avec  le produit sont utilisés. L'utilisation d'une antenne autre que ceux qui sont  certifiés avec le produit est expressément interdite par la réglementation FCC partie 47 CFR 15.204 et IC normes RSS.      Outdoor  units  and  antennas  should  be  installed  ONLY  by  experienced installation professionals who are familiar with local building and safety codes and,  wherever  applicable,  are  licensed  by  the  appropriate  government regulatory  authorities.  Failure  to  do  so  may  void  the  product  warranty  and may expose the end user or the service provider to legal and financial Caution liabilities.  Resellers  or  distributors of  this  equipment are  not  liable  for  injury, damage or violation of regulations associated with the installation of outdoor units  or  antennas.  The  installer  should  configure  the  output  power  level  of antennas according to country regulations and antenna type.         AP0136450 Reference Guide  i Warning      Avertissement
   Les  unités  extérieures  et  les  antennes  doivent  être  installés  que  par  des professionnels  expérimentés  d'installation  qui  sont  familiers  avec  les  normes locales et les codes de sécurité et, si applicable, sont agréées par les autorités gouvernementales de réglementation compétents. Ne pas le faire peut annuler    la garantie du produit et peuvent exposer l'utilisateur final ou le fournisseur de services  d'obligations  juridiques  et  financiers. Revendeurs ou distributeurs de ces équipements ne sont pas responsables des blessures, des dommages ou  violation des  règlements liés  à  l'installation  des unités extérieures ou des antennes. L'installateur doit configurer le niveau de puissance  de  sortie  des  antennes  conformément  aux  réglementations nationales et le type d'antenne.     This equipment should be installed and operated with a minimum distance of 57cm between the radiator and your body when operating in the 3.65-3.7 GHz band and 110cm when operating in the 3.45-3.65 GHz band.  Warning           Cet équipement doit  être installé  et utilisé  à  une  distance minimale de 57cm entre le radiateur et votre corps lors d'opérations dans la bande de 3.65 à 3.7 GHz et 110cm quand fonctionnant dans la bande de 3,45 à 3,65 GHz       The  module  is  granted  to  operate  under  FCC/IC  certification  in  the  3.65-3.70 GHz band and under IC certification in the 3.45-.365 GHz band only.   Warning         This device complies with Part 15 of the FCC rules and with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:  (1) This device may not cause harmful interference.   (2) This device must accept any interference received,  including interference that  may cause undesired operation.    Cet appareil est conforme  la  norme d'Industrie Canada  exempts  de  licence  RSS  (s).  Son fonctionnement est soumis aux deux conditions suivantes:  1. Cet appareil ne peut pas causer d'interférences, et  2.  Cet  appareil  doit  accepter  toute  interférence,  y  compris  les  interférences  qui  peuvent causer un mauvais fonctionnement de l'appareil.   This Class B digital apparatus complies with Canadian ICES-003.  Cet appareil numrique de la classe B est conforme  la norme NMB-003 du Canada    AP0136450 Reference Guide iiPrudence Avertissement
           Overview  The AP0136450 is an RF module operating in the 3.4 – 3.7 GHz frequency bands. It is a TDD OFDM radio supporting 5 MHz, 10 MHz, 20 MHz and 40 MHz channel bandwidths. The RF module cannot work as a stand-alone device. It can operate and be controlled only when attached to a digital main board and altogether assembled in an enclosure suitable for outdoor use. The assembly of the RF module attached to the digital main board is hereafter referred  to  as  ‘ODU’.  The  ODU  in  its  various  outdoor  enclosures  is  manufactured  by RADWIN. The  RF  module  is  certified  as  a  limited  modular  approval  type  with  the  FCC  ID: Q3KRW3XMOD and IC: 5100A-RW3XMOD.    Condition of Use  The  AP0136450  RF  module  is  a  proprietary  radio  interface  and  can  only  be  connected  to digital  boards  manufactured  by  RADWIN.  The  ODU  resides  in  an  outdoor  enclosure  also manufactured and assembled  by RADWIN or  its  subcontractors. The  RF module is  not for sale to the general public.  FCC rules and IC Regulation Restrictions  The ODU firmware is factory programmed to operate under the FCC rules and Industry Canada regulation restrictions. The firmware is locked and inaccessible by any third party. As a result of the above the user interface allows both the installer and the user to control the ODU only within the boundaries of the regional restrictions.    Antennas  The AP0136450 RF module  is  certified  with  various antenna  types  covering both Point-to-Point and Point-to-Multipoint systems. They are all dual pole cross polarized antennas and they are the only ones to be used with the RF module.        AP0136450 Reference Guide 1
Certified Antennas Following is the list of antennas certified for use with the AP0136450 RF module:  Antenna Type Manufacturer Model Number Antenna Max Gain (dBi) Dual Pole Dish RADWIN Ltd. RW-9722-3338 26 External Flat Panel Dual Pole RADWIN Ltd. RW-9612-3338 22 Integrated Flat Panel Dual Pole RADWIN Ltd. MT0099910 22 Integrated Flat Panel Dual Pole RADWIN Ltd. MT0140780 17 Integrated Flat Panel Dual Pole RADWIN Ltd. AM0140450 14 Sector Dual Pole 120 Deg RADWIN Ltd. RW-9061-3003 15 Sector Dual Pole 90 Deg RADWIN Ltd. RW-9061-3001 14   Maximum Output Power    3650 – 3700 MHz band - FCC/IC The  maximum  output  power  can  be  set as follows,  when  operating  in  the  3.7  GHz  band, under FCC and IC regulations.   Antenna gain (dBi) CBW (MHz) Max output power (dBm) EIRP limit (dBm) 14 5 23 37 10/20/40 25 39 15 5 22 37 10/20/40 25 40 17 5 20 37 10 23 40 20/40 25 42 22 5 15 37 10 18 40 20 21 43 40 24 46 24 5 13 37 10 16 40 20 19 43 40 22 46 26 5 11 37 10 14 40 20 17 43 40 20 46       AP0136450 Reference Guide 2
Declared channel bandwidths and frequency ranges        3450 – 3650 MHz band - IC The maximum output power can be set as follows, when operating in the 3.5 GHz band, under IC regulation.  The antenna giving the highest EIRP value is a Dual Pole 26 dBi Dish. The declared maximum output power is 25 ± 2 dBm.                                      AP0136450 Reference Guide 3 Channel BW [MHz] Center Freq. Range [MHz] 5 3652.5 – 3697.5 10 3655 – 3695 20 3660 – 3690 40 3670 - 3680 Channel BW [MHz] Center Freq. Range [MHz] 5 3452.5 – 3697.5 10 3655 - 3695 20 3660 - 3690 40 3670 - 3680

Navigation menu