Realtek Semiconductor RTU7305BG1-HMC UWB HMC User Manual rev
Realtek Semiconductor Corp. UWB HMC rev
User manual rev
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 928293 |
| Application ID | 1ttgEwa9CApXptjCow5dCg== |
| Document Description | User manual rev |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 16.37kB (204617 bits) |
| Date Submitted | 2008-04-15 00:00:00 |
| Date Available | 2008-06-23 00:00:00 |
| Creation Date | 2008-04-11 16:44:32 |
| Producing Software | Acrobat Distiller 7.0.5 (Windows) |
| Document Lastmod | 2008-04-14 17:28:30 |
| Document Title | Microsoft Word - Realtek UWB BG1 HMC User Guide_0411.doc |
| Document Creator | PScript5.dll Version 5.2 |
| Document Author: | marcochuang |
Realtek UWB BG1 HMC User Guide_0411.doc Realtek UWB BG1 HMC User Guide Revision B Author : Marco Chuang Date : 2008/04/11 All Rights Reserved by Realtek Corp. Realtek UWB BG1 HMC User Guide_0411.doc Table of Contents 1. 2. Introduction.................................................................................................................... 3 System Description ........................................................................................................ 4 2.1. UWB PHY ............................................................................................... 5 2.2. 2.3. 3. 4. 5. 6. 7. UWB MAC.............................................................................................. 5 SPI Flash ................................................................................................... 5 Hardware Interfaces ....................................................................................................... 6 3.1. PCIe half mini card Interface .............................................................................. 6 Document History.......................................................................................................... 7 Radiation Exposure Statement....................................................................................... 7 Interference Statement ................................................................................................... 7 Coordination Requirements ........................................................................................... 8 All Rights Reserved by Realtek Corp. Realtek UWB BG1 HMC User Guide_0411.doc 1. Introduction This document describes the system, operations, and interfaces of the UWB BG1 HMC (half mini card) module. Two main applications are supported by this module. One is wireless USB application and the other one is WiNet mode. For WUSB application, the HMC is used as the host controller, and connect to wired USB device with a wireless DWA hub. WiNet mode is an IP-based network communication, and link up the networks by UWB module. WUSB Application WiNet Application All Rights Reserved by Realtek Corp. Realtek UWB BG1 HMC User Guide_0411.doc 2. System Description The UWB BG1 HMC module supports the following functions: Certified WUSB mode WiNet mode Support 53.3M, 80M, 106.7M, 160M, 200M, 320M, 400M, 480Mbps. The module system mainly consists of two main chips – (i) UWB PHY(RTU7010), (ii) UWB MAC(RTU7305). A serial flash memory(8Mb) is required to store proper data/commands for the PHY chip and MAC chip. To make the system work properly, the Flash should be loaded with proper content by using the Flash utility provided by Realtek. The RF performance can also be tested using the test utility provided by RealTek. Two basic clock frequencies are used in the system – 12MHz for MAC and 66MHz for PHY. Some more details of the components are shown in the following sections. The system block diagram is shown below. Figure 1 System Block Diagram All Rights Reserved by Realtek Corp. Realtek UWB BG1 HMC User Guide_0411.doc Product Specification Frequency Band Network Standard Modulation Mode FEC Coding Support Data Rate Interface Support Applications 3168MHz ~ 4752MHz WiMedia PHY 1.1 & MAC 1.0 Multiband OFDM with QPSK, DCM Rate 1/3, 1/2, 5/8, 3/4 Convolutional Coding, Reed Solomon Coding 8 data rates from 53.3Mbps to 480 Mbps PCIe half mini card interface Certified WUSB, WiNet 2.1.UWB PHY This chip integrates the RF and baseband functions of a UWB PHY defined by the standard. This version of PHY chip is packaged in 48-pin QFN form factor. The analog/RF section requires 1.8V and 3.3V to operate. The digital core operates with 1.5V and the I/O voltage can support a range of 1.8V~3.3V. 2.2. UWB MAC This MAC chip is also from RealTek which has a standard MPI interface to communicate with a standard UWB PHY, as well as a high speed USB interface to connect directly to a PC. This chip requires voltages of 1.2V and 3.3V. 2.3. SPI Flash This chip is a serial flash memory from Macronix with a capacity of 8Mb. It is used by the MAC to store the initialization data and command sequence required by the MAC and PHY on start up. This chip requires 3.3V only. All Rights Reserved by Realtek Corp. Realtek UWB BG1 HMC User Guide_0411.doc 3. Hardware Interfaces 3.1. PCIe half mini card Interface Table 1 half mini card connector termination assignment All Rights Reserved by Realtek Corp. Realtek UWB BG1 HMC User Guide_0411.doc 4. Document History Date 2008/03/25 2008/04/11 Revision Description Initial Release Modify Chapter 5&7 Author Marco Chuang Marco Chuang 5. Radiation Exposure Statement This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must follow the specific operating instructions for satisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instruction as documented in this manual. 6. Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. All Rights Reserved by Realtek Corp. Realtek UWB BG1 HMC User Guide_0411.doc CAUTION: Any changes of modifications not expressly approved by the grantee of this device could void the user’s authority to operate the equipment. 7. Coordination Requirements For real application, the transmitter will only be active when communicating with the specific receiver through handshaking, acknowledgement and other mechanisms over the wireless channel. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. A UWB device operating under the provisions of this section shall transmit only when it is sending information to an associated receiver. The UWB intentional radiator shall cease transmission within 10 seconds unless it receives an acknowledgement from the associated receiver that its transmission is being received. An acknowledgement of reception must All Rights Reserved by Realtek Corp. Realtek UWB BG1 HMC User Guide_0411.doc continue to be received by the UWB intentional radiator at least every 10 seconds or the UWB device must cease transmitting. Per FCC regulations, an intentional radiator may only transmit when communicating with an associated receiver. In end-user applications, this is achieved through the handshaking, acknowledgements, negotiation of the communication channel, and other mechanisms those will ensure that the transmitter is activated only when communicating with a receiver. The continuous transmitting mode is for compliance and evaluation purpose only and is not available to the end user. All Rights Reserved by Realtek Corp.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Encryption : Standard V2.3 (128-bit) User Access : Print XMP Toolkit : 3.1-701 Producer : Acrobat Distiller 7.0.5 (Windows) Create Date : 2008:04:11 16:44:32+08:00 Creator Tool : PScript5.dll Version 5.2 Modify Date : 2008:04:14 17:28:30+08:00 Metadata Date : 2008:04:14 17:28:30+08:00 Format : application/pdf Creator : marcochuang Title : Microsoft Word - Realtek UWB BG1 HMC User Guide_0411.doc Document ID : uuid:9385439e-a286-4726-bf62-bbf9afd8be56 Instance ID : uuid:d3abae1e-408c-496a-91c4-0c0ca4fd9408 Page Count : 9 Author : marcochuangEXIF Metadata provided by EXIF.tools