Resolution RE101 Door/Window Transmitter User Manual Exhibit E

Resolution Products, Inc. Door/Window Transmitter Exhibit E

Exhibit E User Manual

Resolution
RE101 Wireless DWS Transmitter
User and Installation Instructions
Introduction
The RE101 Wireless DWS Transmitter is a wireless door/window sensor (DWS) for security system
applications. Typical use of this device is for protection of doors and windows against intrusion.
The transmitter is activated by one of four inputs:
Reed Switch (activated by companion magnet)
Built-in Tamper Switch
External 1
External 2
The RE101 uses a common lithium CR123 battery, designed to provide long battery life.
Transmitter Programming
Each RE101 Wireless DWS Transmitter is shipped with a unique serial number pre-programmed into
the transmitter. Upon installation, the RE101 must be programmed into the security control panel.
The control panel's documentation should be consulted for full instructions.
External Contacts
External contacts allow the connection of two normally-closed, unsupervised contacts to the outer
terminals of the terminal block. Common wire for both contacts is connected to the middle terminal.
Specifications
Dimensions: 1 x 1.25 x 3”
RF transmission frequency: 319.5MHz
Operating Temperature: 10º to 120ºF (-12º to 49ºC)
Battery Type: CR123 Lithium
FCC Notice
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference that may be received, including interference that may
cause undesired operation.
Changes or modifications not expressly approved by the Resolution Engineering, LLC could void the
user's authority to operate this equipment.
FCC ID: U5X-RE101

Navigation menu