Resolution RE202 Security Transmitter, 345MHz User Manual RE202 Honeywell Compat Pencil DWS Instructions

Resolution Products, Inc. Security Transmitter, 345MHz RE202 Honeywell Compat Pencil DWS Instructions

User Manual

RE202_Honeywell-Compat_Pencil_DWS_Instructions.doc Page 1 of 3 28-Jul-11 www.ResolutionProducts.com Wireless Security Solutions RE202 Honeywell-Compatible Pencil Door / Window Features • Senses opening or separation. Narrow mounting locations. • ½ width of competitive products. Great for casements! • Magnet and Internal reed switch operation. • Magnet can mount beside or over sensor housing. • Strong, reliable RF signal. • 8-10 year battery life on 2-AAA batteries. Key Instructions • Battery “+” faces towards white “+” on circuit board. • Install batteries: rear batt – tail in first, front battery – nose in first. • Board goes in and out of housing without batteries (not with). • Reed switch is at the top of the housing, near the push button hole. • Reed switch = Loop 2 • (Inserting battery will send a Loop 4 Tamper, but Sensor does not actually have a tamper) • Enrolling:  Place Panel in RF Learning mode.  Input Type = RF  Lynx *56 “E I” mode: To enroll any particular loop: cause the loop to fault… restore… (panel should beep to indicate ID capture)… fault… restore… [panel will confirm enrollment].  Vista *56 “10 INPUT S/N: L” mode: Transmit two open/close sequences (using magnet). Press * (to check for duplicate serial/loop number). Press * (to continue to confirmation screen). Press * if you wish to skip confirmation; or “Yes” and activate the loop to confirm. RE202_Honeywell-Compat_Pencil_DWS_Instructions.doc Page 2 of 3 28-Jul-11 www.ResolutionProducts.com Operation • Magnetic reed switch: Alarm, when… … magnet is pulled away from reed switch. • Supervisories, every hour. Specifications Magnet trip distance: 0.75 inch nominal Mounting hardware: # 4 or #6 screws Replacement Battery: 2 AAA Alkaline Temperature Range: 0F to 120F Housing dimensions: 4 x 0.6 x 0.9 inches. Specifications subject to change without notice. Internal Picture ID Barcode Wall mount plate Battery Positive Magnet position Reed Switch
RE202_Honeywell-Compat_Pencil_DWS_Instructions.doc Page 3 of 3 28-Jul-11 www.ResolutionProducts.com Notices “GE”, “Honeywell”, and “DSC” are trademarks owned by General Electric Company, Honeywell International Inc., and Tyco Safety Products Canada LTD, respectively. Resolution Products, Inc. products will function with one of either GE, DSC or Honeywell systems. However, no Resolution product is produced by, endorsed by, nor is officially associated with GE, Honeywell or DSC. Resolution recommends verifying proper enrollment and operation, per control panel installation instructions, at installation. Warranty Resolution Products, Inc. will replace products that are defective in their first year. FCC Notice This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: This device may not cause harmful interference. This device must accept any interference that may be received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the Resolution Products, Inc. could void the user's authority to operate this equipment. FCC ID: U5X-RE202 IC Notice This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: 1. This device may not cause interference, and 2. This device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme avec d’Industrie Canada RSS standard exempts de licence. Son fonctionnement est soumis aux deux conditions suivantes: 1. Ce dispositif ne peut causer des interférences, et 2. Ce dispositif doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais fonctionnement du dispositif. IC: 8310A-RE202

Navigation menu