Rhine Electronics Co 7225T Transmitter User Manual

Rhine Electronics Co Ltd Transmitter Users Manual

User manual

INSTRUCTIONS FOR OPERATION
SETING THE OPERATING CONTROLS
1. This unit operates on a 1.5 volts battery *2 (not included).
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2. Store the controller away from excess heat or humidity .
3. This remote control unit is required with 26bit code combinations. To prevent
possible interference from or to other remote units such as garage door
openers, car alarm or security system .
4. Operation buttons on the panel of transmitter .
button - FAN ON/OFF
button – increases the fan speed
button – decreases fan speed
button – Start up/shut down natural wind mode
button – Start up/shut timer
button – Fan reverse Warm weather
button – Fan reverse Cool weather
button - Light ON/OFF
button - Decrease the desired light level
button - Increase desired light level
910805
1
CONTROL SWITCH – For light brightness and ON/OFF control .
5. Start the fan or Turn off the fan
Press the FAN ON/OFF button .
6. Fan speed control :
Press the , button to run the fan at the desired.
7. Light control :
Turn the light on or off : Press the LIGHT ON/OFF button .
Dimmer : press the Decrease the desired light level button , or
press the Increase desired light level button.
GENERAL INFORMATION :
This REMOTE controller is designed to separately control your
ceiling fan speed and light brightness . The Light
ON/OFF button will control the light brightness ON/OFF .
The LED indicator on the transmitter will light when the Function button is pressed .
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN
SPEED CONTROLLER
1. Setting the code on your new transmitter .
Within 60 seconds of turning the AC power on, press and hole the FAN ON/OFF
button for 5 seconds. The receiver will then lock in the chosen frequency.
If your fan has a light it it will blink twice, for fans without lights check operation using the
transmitter
NOTICE :
The changes or modifications not expressly approved by the
party responsible for compliance could void user’s authority
to operate the equipment .
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may cause
910805
2

Navigation menu