Rhine Electronics Co 7225T Transmitter User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2396517
Application ID	Swy0UwzAfNWT6694I4WgHQ==
Document Description	User manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	6.15kB (76921 bits)
Date Submitted	2014-09-21 00:00:00
Date Available	2014-09-21 00:00:00
Creation Date	2014-08-15 09:00:42
Producing Software	OpenOffice.org 3.3
Document Lastmod	0000-00-00 00:00:00
Document Title	Users Manual
Document Creator	Writer
Document Author:	ETC

INSTRUCTIONS FOR OPERATION
SETING THE OPERATING CONTROLS
1.
This unit operates on a 1.5 volts battery *2 (not included).
To prevent possible damage if the battery should leak , be sure to remove
the battery when the unit is not use .
2.
Store the controller away from excess heat or humidity .
3.
This remote control unit is required with 26bit code combinations. To prevent
possible interference from or to other remote units such as garage door
openers, car alarm or security system .
4.
Operation buttons on the panel of transmitter .
button - FAN ON/OFF
button – increases the fan speed
button – decreases fan speed
button – Start up/shut down natural wind mode
button – Start up/shut timer
button – Fan reverse Warm weather
button – Fan reverse Cool weather
button - Light ON/OFF
button - Decrease the desired light level
button - Increase desired light level
910805
CONTROL SWITCH – For light brightness and ON/OFF control .
5.
Start the fan or Turn off the fan
Press the FAN ON/OFF button
6.
Fan speed control :
Press the ＋ , － button to run the fan at the desired.
7.
Light control :
Turn the light on or off : Press the LIGHT ON/OFF button .
Dimmer : press the Decrease the desired light level button , or
press the Increase desired light level button.
GENERAL INFORMATION :
This REMOTE controller is designed to separately control your
ceiling fan speed and light brightness . The Light
ON/OFF button will control the light brightness ON/OFF .
The LED indicator on the transmitter will light when the Function button is pressed .
INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN
SPEED CONTROLLER
1. Setting the code on your new transmitter .
Within 60 seconds of turning the AC power on, press and hole the FAN ON/OFF
button for 5 seconds. The receiver will then lock in the chosen frequency.
If your fan has a light it it will blink twice, for fans without lights check operation using the
transmitter
NOTICE :
The changes or modifications not expressly approved by the
party responsible for compliance could void user’s authority
to operate the equipment .
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference
received, including interference that may cause
910805

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.4
Linearized                      : No
Page Count                      : 2
Language                        : zh-TW
Title                           : 貼於產品本體之FCC標籤圖解範例
Author                          : ETC
Creator                         : Writer
Producer                        : OpenOffice.org 3.3
Create Date                     : 2014:08:15 09:00:42+08:00

EXIF Metadata provided by EXIF.tools