Rhine Electronics Co GTX740 Transmitter of Remote Control User Manual
Rhine Electronics Co Ltd Transmitter of Remote Control Users Manual
Users Manual
INSTRUCTIONS FOR OPERATION
SETING THE OPERATING CONTROLS
MODEL:GTX740
Wireless Keyless Entry System (Optional Accessory)
Wireless Keypad Installation
1. Slide off both keypad and battery covers to fasten with 2 pan head screws.
2. Slide keypad cover onto Keypad.
3. Install a 9 volt battery and slide battery cover onto Keypad.
NOTE ：Mount Keypad out of child’s reach (at least 5 feet above floor).
Programming Wireless Keypad
1. Press and hold the “learn“ button (on the right side of the panel ) until
the green indicator light flashes (about 5 seconds )to erase old code.
2. Press and release the “learn” button (on the right side of the panel ).
3. When the green indicator light is illuminated, press 4 desirde
digits and ENTER to code Keypad.
NOTE ：When programming wireless keypad, the distance shall be at least 24
inches from the antenna of opener.
4. Enter the code to signal the system to open, close, stop or move the door
In the opposite direction.
You may set up this feature as follows:
1. Press and release the "learn" button (on the right side of
the panel).
2. When the green indicator light is illuminated, press and
hold the selected remote control push button.
3. After the green indicator light flashed three times,
release
the button.
4.This stores open/stop/close function for the selected
button for the first opener in memory.
5.Repeat the same steps above on the second and third
openers.
page: 1/2
Erase All Remote Control Codes
1. Press and hold the "learn" button (on the right side of the panel)
until the green indicator light flashes (about 5 seconds).
2. All transmitter codes are now erased.
Then follow the steps above to re-program each remote control.
Notice:The changes or modifications not expressly approved by the party responsible
For compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC rules .Operation is subject to the following two
conditions .
(1) This device may not cause harmful interference and
(2) This device must accept any interference received , Including interference that may
cause undesired operation .
The term “IC:” before the radio certification number only signifies that Industry
Canada Technical specifications were met.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
page: 2/2