Rhine Electronics Co RH787T Transmitter of Remote Control User Manual

Rhine Electronics Co Ltd Transmitter of Remote Control Users Manual

User manual

910805 1 INSTRUCTIONS FOR OPERATION SETING THE OPERATING CONTROLS 1.This unit operates on a 12 volts battery (not included). To prevent possible damage if the battery should leak , be sure to remove the battery when the unit is not use . 2. Store the controller away from excess heat or humidity . 3. This remote control unit is required with 16 code combinations. To prevent possible interference from or to other remote units such as garage door openers, car alarm or security system . If you find that your fan and light kit go on and off without using your control , simply change the combination code in your transmitter and receiver . 4.Operation buttons on the panel of transmitter . VI key – For fan Maximum speed . V key – For fan high speed . IV key – For fan Medium speed . III key – For fan Low speed . II key – For fan Lower speed . I key – For fan Minimum speed . OFF key – For fan speed off . REV key – For fan speed Reverse . CONTROL key – For light brightness and ON/OFF control . SET key – For learn 5.Start the fan : Press the selected speed button to run the fan at the desired . 6.Turn off the fan : Press the OFF button . 7.Light control : Turn the light on or off by only touching the LIGHT CONTROL button . Keep pressing the button in excess of 0.7 second it becomes a dimmer , the light varies cyclically in 0.8 second . One of the important feature of this control is AUTO-RESUME . After power on , it allows the light return to where it was off .
910805 2 GENERAL INFORMATION : This REMOTE controller is designed to separately control your ceiling fan speed and light brightness . The Light ON/OFF button will control the light brightness ON/OFF . The red indicator on the transmitter will light when the button is pressed . INSTRUCTIONS FOR INSTALLATION AND OPERATION OF FAN SPEED CONTROLLER A. Setting the code on your new transmitter . 1. Remove battery cover . Press firmly below arrow and slide battery cover off . 2. Slide code switches to your choice of UP and DOWN position . Factory setting is all UP . Do not use this setting . Use ball point pen or small screwdriver . Slide firmly up or down . B. Setting the code on your new Receiver unit . 1. Slide code switches to the same positions as set on your transmitter . They must be set to same positions to work . 2. Replace battery cover on transmitter . 3. Make sure the code switches are on the left positions . NOTICE : The changes or modifications not expressly approved by the party responsible for compliance could void user’s authority to operate the equipment . This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference
910805 3received, including interference that may cause

Navigation menu