Ricoh WLRWL542 Option for Radiocommunications User Manual 2

Ricoh Company Ltd Option(s) for Radiocommunications 2

User Manual 2

• Use a screwdriver to tighten the knob-screws. Do not tighten manually, because this candisconnect the board.4. Reattach the application cover ( x1).• If the 500-Sheet Finisher is installed, remove it before you attach the parallel cable. Install thefinisher again after you connect the parallel cable.IEEE 802.11a/g (D377)AccessoriesCheck the accessories and their quantities against the following list:No Description Quantity1 IEEE 802.11a/g Interface Board 12 Antenna Cables 23 Antenna Clamps 8Installation• Turn off the main power switch and disconnect the power supply cord.2. Installation1102R-WL54M1N/ R-WL54M1GNSetting Manual for end product
1. Remove the plastic application cover ( x1).2. Remove the cover [A] of the board slot ( x1).3. Insert the interface card [B] as shown above.• Use a screwdriver to tighten the knob-screws. Do not tighten manually, because this candisconnect the board.4. Look at the markings on the antenna bracket.•ANT1. Antenna 1 transmits and receives. It must be installed on the front left corner of the mainmachine. (The core on the Antenna 1 cable is black.)•ANT2. Antenna 2 only receives. It is installed on the rear right corner of the machine.Controller Options1112
• To assure reliable data sending and receiving, Antenna 1 must be installed on the front left cornerof the machine.5. Remove the seals from of the cable clamps and attach them to the left side of the machine as shownabove.6. Attach Antenna 1 [A] to the left front corner of the machine. (The core on the Antenna 1 cable is black.)7. Set the cable of Antenna 1 in the clamps and close them.8. Remove the seals from the cable clamps and attach them to the rear of the machine as shown above.9. Attach Antenna 2 [B] to the right rear corner of the machine.10. Set the cable of Antenna 2 in the clamps and close them.User Tool Settings for IEEE 802.11a/gGo into the User Tools mode and do the procedure below. These settings take effect every time the machineis powered on.• You cannot use IEEE 802.11a/g if you use Ethernet.1. Press the "User Tools" key.2. On the touch panel, touch "System Settings".• The Network I/F (default: Ethernet) must be set for either Ethernet or wireless LAN.3. Select "Interface Settings"> "Network"> "Network I/F Setting"4. Press "IEEE 802.11". Only the wireless LAN options show.2. Installation1122

Navigation menu