Ridgid Eb44241 Users Manual

EB44241 to the manual 5083e71e-f319-4557-b908-d5251985614d

2015-02-04

: Ridgid Ridgid-Eb44241-Users-Manual-387840 ridgid-eb44241-users-manual-387840 ridgid pdf

Open the PDF directly: View PDF PDF.
Page Count: 36

Scroll down to view the document on your mobile browser.
OSCILLATINGEDGE BELT/SPINDLESANDER
2Table of ContentsSection PageTable of Contents .................................2Safety Instructions For OscillatingEdge Belt/ Spindle Sander .................. 3Safety Signal Words ............................3Before Using The Sander ....................3When Installing Or Moving TheSander ...............................................4Before Each Use  .................................5Plan Ahead To Protect Your Eyes,Hands, Face and Ears .......................5When Sander is Running  ....................7Before Leaving The Sander  ................7Precautions To Take When Sanding Metals ...............................................7Precautions To Take When Sanding Paint ..................................................7Motor Specifications and ElectricalRequirements .................................. 8General Electrical Connections  ...........8Power Supply and Motor Specifications .................................... 8110-120 Volt, 60 Hz. Tool Information .9Motor Safety Protection .....................10Wire Sizes  .........................................10Unpacking and Checking Contents  . 11List of Loose Parts .............................11Loose Parts  .......................................11Assembly ............................................12Mounting Rubber Feet To Base  ........12Parts Storage  ....................................12Removing the Sanding Belt Assembly 13Installing the Sanding Belt Assembly  13Installing Sanding Sleeves Larger than 1/2" Diameter ...........................14Installing Sanding Sleeves for the 1/2" Diameter Sanding Drum ..................15Selection Of Spacer Ring Inserts And Upper Spindle Washers  ..................15Bolting Oscillating Edge Belt/Spindle Sander To Workbench  ....................16Section PageSupporting Oscillating Edge Belt/Spindle Sander to Sawhorses ......... 17Alignment ........................................... 17Squaring Front Table  ........................ 17Aligning Belt To Miter Gauge Slot  ..... 18Removing/Installing the Sanding Belt  19Tensioning and Tracking ................... 19Getting to Know Your Spindle Sander ............................................ 20On-Off Switch .................................... 21Safety Instructions for Oscillating Edge Belt/Spindle Sander  ...................... 22Before Using The Sander .................. 22When Installing Or Moving The Sander ............................................. 22Before Each Use ............................... 22Plan Ahead To Protect Your Eyes,Hands, Face and Ears  .................... 23When Sander is Running .................. 24Before Leaving The Sander .............. 25Precautions To Take When Sanding Metals ............................................. 25Precautions To Take When Sanding Paint ............................................... 25Basic Sanding Operation .................. 26Sandpaper Selection ......................... 26Surface Sanding on the Sanding Belt 27End Sanding on the Sanding Belt  ..... 27Sanding Curved Edges  ..................... 27Feed Direction ................................... 28Dust Collection Capability  ................. 28Transporting Sander  ......................... 28Maintenance ....................................... 29Lubrication ......................................... 29RIDGID Recommends the Following Accessories ................................... 29Wiring Diagram .................................. 29Troubleshooting ................................ 30Repair Parts  ....................................... 32Notes .................................................. 35

Navigation menu