Ring BHAMS001 Motion Sensor User Manual Ring Video Doorbell Setup and Installation Guide

Ring LLC Motion Sensor Ring Video Doorbell Setup and Installation Guide

User manual

Beams
Motion Sensor
55mm
92mm
1. Connect your
Motion Sensor.
Download the Ring app.
The app walks you
through setting up and
managing your Spotlight.
Search for “Ring” in one of
these app stores, or visit:
ring.com/app
Set up your
Ring Beams Bridge.
The Bridge connects your
Ring Beams lights to the
rest of your Ring system.
Your Bridge must be
up and running before
you set up your Motion
Sensor.
To set up your
Bridge, follow
the instructions
in the Ring app
or user manual.
Download from
Windows Store
3
2
Pull the tabs
on the back
outward
until you can
remove the
front of your
Motion Sensor.
Insert three
AAA batteries.
Beams
Alarm
Doorbells
Security Cams
Chimes
Set up your Motion
Sensor in the Ring app.
In the app, tap
Set Up a Device.
When prompted, select
Beams and follow the in-
app instructions.
Once setup
is complete,
you can
reattach
the front of
your Motion
Sensor.
Insert the batteries.
5
4
Slide the base
down and remove
it from your
Motion Sensor.
Use the base as
a template to
mark the screw
locations.
Hold the base
against the
surface and
drive the two
mounting
screws.
Slide your
Motion Sensor
back onto its
base.
1. Install your
Motion Sensor.
Your Motion Sensor detects motion
best when mounted 4-6 feet above
the ground.
7
6
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any inte rference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interferenceto radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
ISED Statement
English: This device complies with Industry Canada licenseexempt RSS standard(s).
Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This d
evice must accept any interference, including interference that may cause undesired operation of the device.
The digital apparatus complies with Canadian CAN ICES3 (B)/NMB3(B).
French: Le présentappareilestconforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitationestautorisée aux deux conditions suivantes: (1) l'appareil ne doit pas p
roduire de brouillage, et (2) l'utilisateur de l'appareildoit accepter tout brouillageradioélectriquesubi, mesi
le brouillageest susceptible d'encompromettre le fonctionnement.
Radiation Exposure Statement
This equipment complies with Canada radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with minimum distance 20cm between the radiator & your
body.
Déclaration d'exposition aux radiations
Cet équipement est conforme Canada limites d'exposition aux radiations dans un environnement non
contrôlé. Cet équipement doit être installé et utilisé à distance minimum de 20cm entre le radiateur et votre
corps.
For additional help, visit:
ring.com/help
Or give us a call…
US 1 800 656 1918
Canada 1 855 300 7289
Worldwide +1 310 929 7085
For a list of all our customer
support numbers, visit:
ring.com/callus
To review your warranty coverage, please visit www.ring.com/
warranty.
Patents: www.ring.com/patents
© 2018 Ring LLC or its affiliates.
RING, ALWAYS HOME, and all related logos are trademarks of Ring
LLC or its affiliates.
Last updated: 09/19/18

Navigation menu