Ruby Tech Es 2310C Users Manual L2 Managed Switch Solutions ¦±

ES-2310C to the manual c01aa1fa-855e-4310-9949-ed656e294d88

: Ruby-Tech Ruby-Tech-Es-2310C-Users-Manual-525586 ruby-tech-es-2310c-users-manual-525586 ruby-tech pdf

Open the PDF directly: View PDF .
Page Count: 3

ES-2310C:

8-Port L2 Managed Fast Ethernet Switch with 2 SFP Gigabit Dual Media

Key FeaturesKey Features

Standard compliance

---IEEE 802.3 10Base-T

---IEEE 802.3u 100Base-TX

---IEEE 802.3ab 1000Base-TX

---IEEE 802.3z 1000Base-X Ethernet

---IEEE 802.3x flow control capability

---ANSI/IEEE 802.3 auto-negotiation

---IEEE 802.1q VLAN

RoHS Compliance

Subscriber Interface

---8 are 10/100Mbps and 2 Gigabit

Ethernet ports.

---Port 9,10 are Gigabit TP/SFP Fiber

auto sense

---Auto-Negotiation and Auto-MDIX

---Back pressure flow control for half

duplex.

---IEEE 802.3x compliant for full duplex

---Connector: 8 RJ-45 and 2 dual media,

RJ-45/SFP

Performance

Switching capacity:

---Non-blocking switch fabric supports up

to 8 FE+2GbE ports

---8 K MAC addresses

---256K packet buffer and 128K control

memory

VSM(Virtual Stacking Management)

---Supports 16 devices stacking

---Multiple switches can be managed via

one IP address, just like software

stacking

---Low cost and easily to establish

network environment, not extra

hardware require

---Not center on the physical location of

wiring closets

VLAN

---Supports SVL/IVL configuration to

meet your VLAN requirement

---Port-base VLAN

---IEEE802.1q tag-base VLAN, 4094

max, up to 256 active VLANs including

static plus dynamic entry

---IEEE802.1q tag-base VLAN

ES-2310C

BenefitsBenefits

QoS with four priority queues

The QoS(Quality Of Service) feature provides four internal queues to support

four different classifications of traffic. High priority packet streams experience

less delay inside the switch, which supports lower latency for certain delay-

sensitive traffic. The ES-2310C can classify the packet as one of the four

priorities according to vip port, 802.1p priority tag, DiffServ and/or IP TOS.

The QoS operate at full wire speed. The actual scheduling at each egress

port can be based upon a strict priority, weighted round robin or a mix of both.

Port Mirroring

This mechanism helps track network errors or abnormal packet transmission

without interrupting the flow of data. Allow ingress traffic to be monitored by a

single port that is defined as mirror capture port. The mirror capture port can

be any 10/100 port, 10/100/1000 port. Mirroring multiple ports is possible but

can create congestion at the mirror capture port.

Q-in-Q VLAN for performance & security

The VLAN feature in the switch offers the benefits of both security and

performance. VLAN is used to isolate traffic between different users and thus

provides better security. Limiting the broadcast traffic to within the same VLAN

broadcast domain also enhances performance. Q-in-Q, the use of double

VLAN tags is an efficient method for enabling Subscriber Aggregation. This is

very useful in the MAN.

Isolated Group, provides protection for certain ports

The isolated group feature allows certain ports to be designated as protected.

All other ports are non-isolated. Traffic between isolated group members is

blocked. Traffic can only be sent from isolated group to non-isolated group.

Mac-based 802.ad LACP with automatic link fail-over

Dynamic fail-over means packets will not get assigned to any trunk member

port that has failed. If one of the ports were to fail, traffic will automatically get

distributed to the remaining active ports.

802.1x Access Control improves network security

802.1x features enable user authentication for each network access attempt.

Port security features allow you to limit the number of MAC addresses per

port in order to control the number of stations for each port. Static MAC

addresses can be defined for each port to ensure only registered machines

are allowed to access. By enabling both of these features, you can establish

an access mechanism based on user and machine identities, as well as

control the number of access stations.

802.1d Compatible & 802.1w Rapid Spanning Tree

For mission critical environments with multiple switches supporting STP, you

can configure the switches with a redundant backup bridge path, so

transmission and reception of packets can be guaranteed in event of any

fail-over switch on the network.

2 dual media ports for flexible fiber connection

Port 9, 10 dual media ports are provided for flexible fiber connection. You can

select to install optional transceiver modules in these slots for short, medium

L2 Managed Switch

Fast Ethernet Switch

Fast EthernetSwitch

RUB

TECHTECH

Networking & Communications

R

or long distance fiber backbone attachment. Use of the SFP/GBIC will disable

their corresponding built-in 10/100/1000Base-T connections.

Broadcast/Multicast/unknown-unicast Storm Control

To limit too many broadcast/multicast/unknown-unicast flooding in the

network, broadcast/multicast storm control is used to restrict excess traffic.

Threshold values are available to control the rate limit for each port. Packets

are discarded if the count exceeds the configured upper threshold.

Technical SpecificationsTechnical Specifications

LED Description

Network Interface

Full Forwarding Packet Rate: PPS (64 Bytes packets per second)

Cable and Maximum Length

Hardware Spec

---Flooding unknown VLAN frame setting,

can flood packet with some VLAN tag

associated to a invalid/inactive VLAN

---In tag-base VLAN, supports egress/

ingress packet filter

---Q-in-Q is an efficient method for

enabling Subscriber Aggregation

Qos

---Port Based (VIP Port), 802.1p , TOS

and Diffserv(IPv4/IPv6) based QoS

packet classification

---Supports four level priority queues to

prioritize in-bound and out-bound traffic

---Supports two scheduling, WRR and

Strict

---Supports priority in a Q-in-Q tag

Bandwidth Control

---Supports bandwidth rating per port

ingress and egress rate limit 1000Mbps

with 1Mbps increment

Broadcast Storm

---Multicast/Broadcast/Unknown-Unicast

Storm suppression.

Transmission Mode

---10/100Mbps support full or half duplex

1000Mbps support full duplex only

Transmission Speed

---10/100/1000Mbps for TP 1000Mbps

for Fiber

Port Mirroring

---Support 1: N RX port mirroring

---Supports port sniffer function with 3

modes:

(TX Monitor Mode, RX Monitor Mode

and TX-RX pair Monitor Mode)

Isolated Group

---Provide one group allows certain ports

to be designated as protected

Restricted Group

---Can decide the direction of transmitting

packets for the specific port

Protocol

LACP

---2 Fast Ethernet +1 Gigabit Ethernet

groups

---Per-group max 4 member

---Provides DA, SA and DA+SA Mac-

based trunking with automatic link

fail-over

GVRP/GARP

---1.802.1q with GVRP/ GARP

Multicasting

---Supports IGMP snooping including

active and passive mode

STP/RSTP

---802.1d/1w

Network Security

---802.1x access control

---Isolated group

---Restricted group

---Management Access Policy Control

L2 Managed Switch

Fast Ethernet Switch

Fast EthernetSwitch

LED Color Function

Global POWER Green -Lit when +5V power is coming up

Global CPU Green -Blinks when CPU is active

Port LINK/ACT Green -Lit when connection with remote device

1-8 is good

-Blinks when any traffic is present

Port 10/100/ Green -Lit Green when TP link on 1000Mbps

1-8 1000Mbps /Amber speed

-Lit Amber when TP link on 100Mbps

speed

-Off when 10Mbps or no link occurs

Port SFP Green - Lit when SFP/GBIC connection with

9,10 remote device is good

-Blinks when any traffic is present

Category Connector Transmission Max. Cable Wavelength

Length

10-T/ RJ-45 Full/Half Duplex 100M /

100-TX

1000-T RJ-45 Full Duplex 100M /

1000-SX LC Full Duplex 220M 850nm

(M-M) 50/125

1000-SX LC Full Duplex 10KM 1310nm

(S-M) 9/125

Forwarding Rate Speed

14,880PPS 10Mbps

148,800PPS 100Mbps

1,488,000PPS 1000Mbps

Feature Detailed Description

TP Cat. 5 UTP cable, up to 100m

1000Base-SX SC M-M Up to 220/275/500/550m,

which depends on Multi-Mode Fiber type

1000Base-LX SC S-M Single-Mode Fiber, up to10/30/50Km

1000Base-FX WDM SC S-M Single Fiber, BiDi 10Km

RUB

TECHTECH

Networking & Communications

R

Dimensions 44(H) x 220(W) x 130.5(D) mm

Feature Detailed Description

Voltage 100~240 VAC

Frequency 50~60 Hz

Consumption 11.6W

Ambient Temperature 0 to 40 C

Humidity 5% to 90%

Safety Comply with FCC Part 15 Class A & CE

Mark Approval

---Static mac, to limit which mac

addresses can pass through or not

---Mac addresses learning limit, to set up

the maximum amount of mac that

each port can learn

Snmpv1,v2c Network Management

RFC 1213 MIB (MIB-II)

Interface MIB

Address Translation MIB

IP MIB

ICMP MIB

TCP MIB

UDP MIB

SNMP MIB

RFC 1757 RMON MIB

Statistics Group 1

History Group 2

Alarm Group 3

Event Group 9

RFC 1493 Bridge MIB

RFC 1643 Ethernet MIB

Enterprise MIB

OverviewOverview

ES-2310C is a Managed Fast Ethernet

switch that supports SNMP, Web UI and

CLI management interface and with 8 10/

100Base-TX (RJ-45 connectors) and 2

Gigabit dual media (RJ-45/SFP or RJ-45/

GBIC) ports. It is a standard switch that

meets all IEEE 802.3/u/x/z Gigabit, Fast

Ethernet specifications. In addition, the

switch implements the QoS (Quality of

Service), VLAN, Mac Filtering Policy, Port

Mirror, VLAN and full L2 protocols. It has

a rich feature set suitable for streaming

VoIP, video, and data traffics for multimedia

applications.

In this switch, Port 9, 10 support two types

of media --- TP and SFP/GBIC Fiber (LC,

BiDi-SC....); both ports support 10/100/

1000Mbps TP or 1000Mbps SFP/GBIC

Fiber with auto-detected function.

1000Mbps SFP/GBIC Fiber transceiver

is used for high-speed connection

expansion.

Fast Ethernet Switch

Fast EthernetSwitch

L2 Managed Switch

Ordering InformationOrdering Information

ES-2310C:

8-Port L2 Managed Fast Ethernet Switch with 2 SFP Gigabit Dual Media

RUB

TECHTECH

Networking & Communications

R

Ruby Tech Corp.

3F, No.1, Lane 50, Nan Kang Road, Sec.3, Taipei, Taiwan http://www.rubytech.com.tw

TEL:886-2-2785-3961 FAX:886-2-2786-3012 E-mail rubytech@mail.rubytech.com.tw

2008-07.30 Version A

Technical information listed is subject to change without prior notice. All brand names and trademarks are property of their respective owners.

Copyright c 2008 Ruby Tech Corp. All rights reserved.

Optional SFP Fiber Module (See note below)

Note:

We recommend the SFP transceiver from the following vendors:

1. Ruby Tech Corporation

2. Agilient Technologies

3. AVAGO Technologies

4. Finisar Corporation

SFP.LC 1000Base-SX GE SFP Multi-Mode Fiber Module 850nm

SFP.LC.M2 1000Base-SX GE SFP Fiber Module, LC Multi-Mode

1310nm 2km

SFP.LC.S10 1000Base-LX GE SFP Single-Mode 10Km Fiber Module

1310nm

SFP.LC.S30 1000Base-LX GE SFP Single-Mode 30Km Fiber Module

1310nm

SFP.L5.S50 1000Base-LX GE SFP Single-Mode 50Km Fiber Module

1550nm

SFP.BL5.S10 1000Base-LX GE SFP BiDi_LC 10Km Module Single

Fiber 1550nm, Type 1

SFP.BL3.S10 1000Base-LX GE SFP BiDi_LC 10Km Module Single

Fiber 1310nm, Type 2

SFP.BL5.S20 1000Base-LX GE SFP BiDi_LC 20Km Module Single

Fiber 1550nm, Type 1

SFP.BL3.S20 1000Base-LX GE SFP BiDi_LC 20Km Module Single

Fiber 1310nm, Type 2