SIGFOX SENSIT3 Sigfox demonstrator User Manual Sensit Legal Notice

SIGFOX SA Sigfox demonstrator Sensit Legal Notice

Contents

sensit-legal-notice

Legal notice
CONTENT OF THE PACKAGE
Your Sens’it package contains:
1 Sens’it 3
1 magnet
1 Micro-USB cable
1 Velcro strap
1 user manual
1 legal notice
SAFETY INSTRUCTIONS
Before any use please read the Sens’it manual carefully and
keep it for any later reference.
Defects caused by unauthorized modifications, improper
use, negligence, exposure to inclement weather conditions,
accident, or any use of this product that is not in
accordance with the provided instructions will result in the
exclusion of the warranty and of the manufacturer’s
liability.
Do not use the Sens’it with any part or component that is
not coming from Sigfox or the Sens’it package.
Place the Sens’it in a cool and dry area. For the withstood
temperature and humidity range, see the technical
specifications.
Do not leave any electronic equipment on top of the
Sens’it.
Do not submerge the Sens’it in liquids.
Do not place the Sens’it magnet close to electronic devices
such as PCs, hard drives, batteries, etc. Doing so could
damage them, or delete the information they contain.
Do not use the Sens’it while it is charging.
WARNING STATEMENT
United States
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
The radiated output power of the device is far below the
FCC radio frequency exposure limits. Nevertheless, the
device shall be used in such a manner that the potential for
human contact during normal operation is minimized.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a special
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected. Consult the
dealer or an experienced radio/TV technician for help.
Do not throw away Sens’it in the normal household trash; it
must be disposed properly in the same way as other electronic
equipment following official procedures.
FCC: 2ACK7SENSIT3
Europe
Canada
This device complies with Part 15 of the FCC Rules and with
Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et (2)
l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Radiofrequency radiation exposure Information: This
equipment complies with FCC and IC radiation exposure limits
set forth for an uncontrolled environment.
Cet équipement est conforme aux limites d’exposition aux
rayonnements IC établies pour un environnement non contrôlé.
IC
IC: 12204A-SENSIT3
Australia
Singapore
Japan
This device is granted pursuant to the Japanese Radio Law
(電波法). This device should not be modified (otherwise the
granted designation number will become invalid)
Technical Specifications
Designed in France
Assembled in China
Model 3.1 3.2 3.3 3.4
Radio Characteristics
TX Center Frequency
(MHz)
868.13 902.2 923.2 920.8
RX Center Frequency
(MHz)
869.525 905.2 922.2 922.3
TX Power
(dBm ERP)
14 22 10 22
Power Supply Characteristics
Battery type LiPo, 250 mAh, 3.7 V
WARNING: the battery cannot be changed
Recharge Micro-USB, 5 V
Environmental Characteristics
Operating
temperature (°C)
-10 °C to 50 °C
Charging
temperature (°C)
0 °C to 40 °C
Relative
humidity (%)
30% to 90%
Mechanical Characteristics
Dimensions
(W x H x D)
52 mm x 82 mm x 15 mm
Weight 50 g
Protection IP54
Certifications
Country approval Europe USA Japan Singapore
Australia

Navigation menu