SK Telesys SWT225 WiMAX CPE with 802.11b/g/n User Manual
SK Telesys Co.,Ltd. WiMAX CPE with 802.11b/g/n Users Manual
Users Manual
CPE (SWT225) User Manual June, 2011 THIS DOCUMENT CONTAINS INFORMATION CONFIDENTIAL AND PROPRIETARY TO SK TELESYS CO., LTD. THE INFORMATION MAY NOT BE USED, DISCLOSED OR REPRODUCED WITHOUT THE PRIOR WRITTEN AUTHORIZATION OF SK TELESYS AND THOSE SO AUTHORIZED MAY ONLY USE THE INFORMATION FOR THE PURPOSE OF EVALUATION CONSISTENT WITH AUTHORIZATION. REPRODUCTION OF ANY SECTION OF THIS DOCUMENT MUST INCLUDE THIS LEGENT. CPE (SWT225) Patent‐pending technologies to improve data performance [ Table of Contents ] SECTION 1. SWT225 COMPONENTS ...............................................................4 1.1 Components..................................................................................................................... 4 1.2 Front View....................................................................................................................... 5 1.3 Rear View ........................................................................................................................ 6 SECTION 2. INSTALLATION ........................................................................... 7 2.1 Antenna connection ........................................................................................................ 7 2.2 Adapter connection ......................................................................................................... 7 2.3 Station connection ..........................................................................................................8 SECTION 3. INTERNET ACCESS ................................................................... 10 3.1 Access via WiFi (wireless) ............................................................................................. 10 3.1.1 Detection of wireless network and access ........................................................................................... 10 3.1.2 View access to wireless network ..........................................................................................................11 3.2 Access via LAN (wired) .................................................................................................. 13 3.2.1 Connection between SWT225 and PC ................................................................................................. 13 3.2.2 View access to wired network .............................................................................................................. 14 SECTION 4. TROUBLE SHOOTING ............................................................... 15 4.1 Checking via LEDs ......................................................................................................... 15 4.2 Checking through WEB CM ........................................................................................... 16 Confidential & Proprietary SK Telesys Co., Ltd. | 2 CPE (SWT225) Patent‐pending technologies to improve data performance [ List of Figures ] FIGURE 1. COMPONENTS OF SWT225.................................................................................... 4 FIGURE 2. FRONT LEDS ......................................................................................................... 5 FIGURE 3. REAR PORTS ......................................................................................................... 6 FIGURE 4. ANTENNA CONNECTION ...................................................................................... 7 FIGURE 5. ADAPTER CONNECTION .......................................................................................8 FIGURE 6. FASTENING OF SCREWS ......................................................................................8 FIGURE 7. A VIEW OF THE BOTTOM AFTER THE SCREWS ARE FASTENED ......................... 9 FIGURE 8. MOUNTING OF THE STAND ................................................................................. 9 FIGURE 9. WIRELESS NETWORK DETECTION.................................................................... 10 FIGURE 10. VIEW ACCESS TO WIRELESS NETWORK .......................................................... 11 FIGURE 11. VIEW ACCESS TO WIRELESS NETWORK (IP ADDRESS) .................................. 12 FIGURE 12. CONNECTION TO THE LAN PORT ..................................................................... 13 FIGURE 13. VIEW ACCESS TO WIRED NETWORK ............................................................... 14 FIGURE 14. VIEW ACCESS TO WIRED NETWORK (IP ADDRESS) ........................................ 14 FIGURE 15. CHECKING OF WIMAX CONNECTION AT WEB CM ........................................... 17 Confidential & Proprietary SK Telesys Co., Ltd. | 3 CPE (SWT225) Patent‐pending technologies to improve data performance Section 1. SWT225 Components SWT225 CPE provides the WiFi service to users using the WiMAX service in the region where the WiMAX service is available. In this manual, [terminal] stands for all devices which can use wireless LAN (WiFi), such as laptops, smart phones, and other devices. 1.1 Components Figure 1. Components of SWT225 Component Quantity Main body 1EA Bracket (screws included) 1EA LAN cable 1EA Adapter 1EA Confidential & Proprietary SK Telesys Co., Ltd. | 4 CPE (SWT225) Patent‐pending technologies to improve data performance 1.2 Front View Figure 2. Front LEDs Items Power WiFi Descriptions Indicates power supply to the device. Flashes green when normal. Indicates the state of wireless LAN (WiFi). Flashes green when normal. Blinks while data is transferred. LAN1 Indicates the state of LAN Port 1. LAN2 Indicates the state of LAN Port 2. WiMAX1 Indicates the state of WiMAX Module 1. WiMAX2 Indicates the state of WiMAX Module 2. Confidential & Proprietary SK Telesys Co., Ltd. | 5 CPE (SWT225) Patent‐pending technologies to improve data performance 1.3 Rear View 1. LAN Port #1 2. LAN Port #2 3. Reset button 4. Power Port Figure 3. Rear Ports No. Items Descriptions Provides wired connection to a terminal. A terminal LAN1 connected into this port will be allocated an IP address automatically (via DHCP). Provides wired connection to a terminal. A terminal LAN2 connected into this port will be allocated an IP address automatically (via DHCP). Used to reset the device. Press and hold for less than 2 RST (Reset) seconds for rebooting and for 10 seconds or longer for factory initialization. PWR (power) The power adapter, one of the device components, is connected into this slot. Confidential & Proprietary SK Telesys Co., Ltd. | 6 CPE (SWT225) Patent‐pending technologies to improve data performance Section 2. Installation 2.1 Antenna connection Connect a pair of antennas to the main body respectively as shown in Figure 4. Figure 4. Antenna connection 2.2 Adapter connection Connect the adapter to the main body as show in Figure 5. SWT225 has no power switch. Therefore power is supplied to the device upon connection of the adapter. Confidential & Proprietary SK Telesys Co., Ltd. | 7 CPE (SWT225) Patent‐pending technologies to improve data performance Figure 5. Adapter connection 2.3 Station connection Fasten the two screws to the bottom of the main body of SWT225 as shown in Figure 6 to mount the stand. Figure 6. Fastening of screws Confidential & Proprietary SK Telesys Co., Ltd. | 8 CPE (SWT225) Patent‐pending technologies to improve data performance Figure 7. A view of the bottom after the screws are fastened Mount the stand onto the device using the screws as shown in Figure 8. Figure 8. Mounting of the stand Confidential & Proprietary SK Telesys Co., Ltd. | 9 CPE (SWT225) Patent‐pending technologies to improve data performance Section 3. Internet access You can access the Internet via either WiFi or LAN. 3.1 Access via WiFi (wireless) 3.1.1 Detection of wireless network and access Run wireless network detection on your computer and see what networks exist around it. If SWT225 is included in the list of networks, double click on the SSID to access WiFi. Figure 9. Wireless network detection Confidential & Proprietary SK Telesys Co., Ltd. | 10 CPE (SWT225) Patent‐pending technologies to improve data performance 3.1.2 View access to wireless network Once access via WiFi is made, information is displayed as shown in Figure 10. Figure 10. View access to wireless network Confidential & Proprietary SK Telesys Co., Ltd. | 11 CPE (SWT225) Patent‐pending technologies to improve data performance Figure 11. View access to wireless network (IP address) Confidential & Proprietary SK Telesys Co., Ltd. | 12 CPE (SWT225) Patent‐pending technologies to improve data performance 3.2 Access via LAN (wired) 3.2.1 Connection between SWT225 and PC Connect between the LAN port of SWT225 and the Ethernet port of your PC using the LAN cable provided with the device. Figure 12. Connection to the LAN port Confidential & Proprietary SK Telesys Co., Ltd. | 13 CPE (SWT225) Patent‐pending technologies to improve data performance 3.2.2 View access to wired network Figure 13. View access to wired network Figure 14. View access to wired network (IP address) Confidential & Proprietary SK Telesys Co., Ltd. | 14 CPE (SWT225) Patent‐pending technologies to improve data performance Section 4. Trouble Shooting For an uninterrupted Internet access, always make sure that the WiMAX modem is properly connected. No Internet access is available if the WiMAX modem is not connected to the base station. WEB CM access via WiFi or LAN, however, is available even when the WiMAX modem is not connected to the base station. 4.1 Checking via LEDs You can verify that you have an Internet access based on the indication of the LEDs on SWT225. LED Power Color(s) Function Flashes green When power is supplied Flashes green When WiFi AP is on Blinks green When data is transmitted via WiFi Flashes green When access is made via LAN Blinks green When data is transmitted via LAN Flashes green WiMAX strong electric field Flashes yellow WiMAX weak electric field WiFi LAN1/2 WiMAX Flashes red Out of zone Blinks yellow (every one min) Connecting Confidential & Proprietary SK Telesys Co., Ltd. | 15 CPE (SWT225) Patent‐pending technologies to improve data performance Blinks green and yellow Flashes blue 4.2 When WiMAX data is transmitted. Turned off when data is transmitted while on Idle Checking through WEB CM You can verify that you have an Internet access at the WEB CM of SWT225. Access via wireless network (WiFi): If your terminal is connected to SWT225 via wireless network (WiFi), bring up the web browser on the terminal and type http://192.168.2.1 to access the WEB CM of SWT225. Access via the LAN port: If your terminal is connected to SWT225 via the LAN port (wired), bring up the web browser on the terminal and type http://192.168.2.1 to access the WEB CM of SWT225. Login name and password for WEB CM access: Sktelesys and sktelesys In the WEB CM page, go to WiMAX and Status to view connection information. Confidential & Proprietary SK Telesys Co., Ltd. | 16 CPE (SWT225) Patent‐pending technologies to improve data performance Figure 15. Checking of WiMAX connection at WEB CM Confidential & Proprietary SK Telesys Co., Ltd. | 17 FCC RF Radiation Exposure Statement The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operation in conjunction with any other antenna or transmitter.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.6 Linearized : No Author : grace_loh Create Date : 2011:07:01 10:23:31+09:00 Modify Date : 2011:07:01 10:27:01+09:00 Has XFA : No XMP Toolkit : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00 Format : application/pdf Creator : grace_loh Title : Microsoft Word - FCC_Doc_001]SWT225_User Manual.doc Creator Tool : PScript5.dll Version 5.2.2 Metadata Date : 2011:07:01 10:27:01+09:00 Producer : Acrobat Distiller 9.0.0 (Windows) Document ID : uuid:cc90d8be-3510-45fc-ac79-7824cb4e2e90 Instance ID : uuid:55a8839d-0d72-4cd9-a4fe-e6a65191005a Page Count : 19EXIF Metadata provided by EXIF.tools